Investigation of an inverse thermal injection mould design methodology in dependence of the part geometry

Abstract

The production of injection moulded components with low shrinkage and warpage is a constant challenge for manufacturers. The thermal design of the injection mould plays an important role for the achievable quality, especially the placement of the cooling channels. This design is usually based on empirical knowledge of the mould designers. The construction is supported iteratively by injection moulding simulations. In the case of thick-walled plastic optics with big wall thickness jumps, the shrinkage is compensated by injection compression moulding. In this process, the thin-walled areas freeze earlier and the necessary compression pressure introduces stresses into these areas which reduces the optical performance. An adapted cooling channel design can reduce these problems. At the IKV, Institute for Plastics Processing in Industry and Crafts at the RWTH Aachen University, a methodology was developed which inversely calculates the cooling requirement of the moulded part A demand-oriented cooling channel system is derived based on the computed results. The aim of the research projects is to minimise displacement and internal stresses by temperature control of the moulded parts according to the demand. In this paper, the methodology is applied to three different geometries, representing three classical parts for the injection moulding process. Three different quality areas in the mould for the inverse optimisation are defined and investigated. For each geometry the cooling channel designs are then validated in injection moulding simulations based on the results from the thermal optimisation. It can be shown that for different component geometries and thicknesses, different quality areas are advantageous and decrease the maximum warpage of the parts. For thin-walled ribbed components, a 2D approach leads to a 15% smaller displacement, for components with wall thickness jumps, all investigated quality ranges show no differences in displacement, but a surface in the middle of the part is preferred due to a 3\xa0°C lower standard deviation of the temperature distribution.