Effect of processing conditions on (Ba1-xCax)(Ti0.9Sn0.1)O3 lead-free ceramics for the enhancement of structural, humidity sensing and dielectric properties

Abstract

The present study reports detailed guidelines for the preparation\xa0of high-quality perovskite (Ba1-xCax)(Ti0.9Sn0.1)O3 (BCTS) (x\u2009=\u20090.0–0.1) lead-free ceramics by solid state reaction. The compositions (x\u2009=\u20090.0–0.04) exhibit orthorhombic–tetragonal phase transition (TO-T), except x\u2009≥\u20090.06 that shows a pure tetragonal structure phase which conformed by X-ray diffraction (XRD). The microstructure and purity of the sintered ceramics were examined using scanning electron microscope equipped with an energy dispersive spectrometer (SEM-EDS). Some pores existing in the grain boundary were observed at high concentrations of Ca content. Field emission scanning electron microscope (FE-SEM) was used to examine the morphology of sensing film of the calcined powder and it was prepared as a humidity sensor using screen-printing technique. All the compositions exhibited poor sensitivity toward the humidity sensing in the range of 0–98% RH at room temperature. Hot-stage microscope (HSM) has been used to investigate the sintering curve of the pure calcined powder and it was found that the suitable sintering temperature for obtaining a fully dense microstructure is 1400\xa0°C. The highest values of permittivity (εr\u2009=\u200946,515, at 10\xa0kHz) and piezoelectric coefficient (d33\u2009=\u2009510\xa0pC/N) were achieved in the composition x\u2009=\u20090.02. The difference between alumina and platinum crucibles for the processing of the powders\xa0has been introduced, and by the aid of dispersive spectrometer analysis and it was indicated that use of alumina crucibles leads to the undesired presence of Al in the ceramics, which can be prevented by using a capped\xa0platinum crucibles.