Effect of grain refining by cyclic extrusion compression (CEC) of Al-6061 and Al-6061/SiC on wear behavior

Abstract

Abstract Cyclic extrusion compression (CEC) is an effective fabrication process for producing fine, ultrafine grains with superior physical and mechanical properties. In the present work, CEC process was applied on Al alloy 6061 and its silicon carbide (SiCp) composite containing 5 and 10 wt. % SiCp. . The specimens were pressed at room temperature up to 6 cycles for Al alloy 6061, 5 cycles for Al 6061 5 wt. % and 4 cycles for Al 6061 10 wt. % SiC corresponding to plastic strains of 3.72, 3.1 and 2.48 respectively. The evolution of microstructure, hardness and dry sliding wear tests were conducted. The samples were investigated before and after the CEC process by optical microscope, and the worn surfaces were investigated by Scanning Electron Microscope (SEM) and (EDX) analysis. The CEC cycles reduced the grain size, porosity % and SiC particle size. These microstructural parameters were reflected on the increase in hardness and reduction in wear rate and a slight reduction in coefficient of friction. In general, this improvement in properties is associated with the following parameters; grain refining, reinforcement volume fraction, size and distribution of SiCp as well as the number of CEC cycles. Regarding the composite samples, a significant improvement in wear resistance was obtained and the Al 6061 10 wt. % SiC, showed the best performance. The wear mechanism was also affected by the CEC process.