Oxygen balance during laser powder bed fusion of Alloy 718

Abstract

Abstract The generation of spatters during laser powder bed fusion (L-PBF) of Alloy 718 is known to be detrimental for the re-use of the feedstock powder and the quality of the final product. In this study, dedicated powder sampling from different positions within the build chamber and powder bed was performed. The results clearly indicate the importance of the surface-to-volume ratio of the built components on powder degradation, as demonstrated by the analysis of the powder using capsules filled with dense lattice structures. Extensive formation of Al- and Cr-rich oxides on the entrained powder deposited on the gas inlet and outlet was detected. Significant oxygen pick-up by spatter particles compared to the virgin powder was measured (>300\xa0ppm O2); while the as-built material experienced a slight loss (~30\xa0ppm O2). The change in the microstructure of spatter particles in comparison to the virgin powder, namely the primary dendrite arm spacing, indicates significantly higher cooling rate during spatter solidification, estimated to be of about 108\xa0K/s, compared to around 106\xa0K/s for the virgin powder and 107\xa0K/s for the L-PBF component. These findings allows to evaluate the extent of powder degradation during L-PBF and establish the oxygen balance of the process.