Time averaged tomographic measurements before and after dryout in a simplified BWR subchannel geometry

Abstract

Abstract For the validation of advanced two-fluid CFD models at boiling water reactor (BWR) conditions, it is necessary to have good experimental data challenging for the code by reflecting relevant flow phenomena. The present experimental study aims to provide detailed film thickness distributions in a BWR-like subchannel geometry, including spacer grids and heat transfer. This is achieved using chloroform as a working fluid, indirectly heated by hot water channels simulating BWR fuel rods. X-ray equipment was used to produce tomographic 3D-data of time-averaged attenuation coefficients which essentially represent the liquid holdup. The conversion to film thickness was done by integrating the attenuation coefficient along lines perpendicular to the rod wall and using an effective chloroform attenuation coefficient determined by numerical simulation of the experimental setup, including X-ray sensor behavior. The simulation method was validated by using two different sensors types. Measurements were performed over the whole cross-section of the channel and an axial length of 11\xa0cm. The experiments cover a range of liquid flow rates in the pre- and post-dryout regime.