An Analysis of the Femoral Drilling Angle to Avoid Tunnel Collision during Double-Bundle Anterior Cruciate Ligament and Anterolateral Ligament Reconstruction on the Knee.

Abstract

Concomitant anterior cruciate ligament (ACL) and anterolateral ligament (ALL) reconstruction has been reported as an effective technique for providing rotational control of the knee. However, the intraoperative risk of collision with an ACL tunnel during the drilling for the femoral ALL tunnel has been described. The purpose of this study was to investigate the various femoral drilling procedures to avoid tunnel collisions during combined double-bundle ACL and ALL reconstruction. Nine cadaveric knees were used in this study. ACL drilling was performed through the anteromedial portal to footprints of the posterolateral bundle at 120° (PL120) and 135° (PL135) knee flexion and the anteromedial bundle at 120° (AM120) and 135° (AM135) knee flexion. ALL drilling was performed at 0° (Cor0-ALL) and 30° (Cor30-ALL) coronal angles using a Kirschner wire (K-wire). The distance between the ALL footprint and ACL K-wire outlets, axial angles of ALL K-wires colliding with ACL K-wires, and distances from the ALL footprint to the collision point were measured. From these values, the safe zone, defined as the range of axial angles in which no collisions or penetrations occurred, was identified by simulation of tunnels utilized for reconstruction grafts in each drilling procedure. The point-to-point distance from the ALL footprint to the K-wire outlet was significantly greater in the AM120 than the AM135 (13.5\u2009±\u20093.1, 10.8\u2009±\u20093.2\u2009mm; p\u2009=\u20090.048) and in the PL135 than the PL120 (18.3\u2009±\u20095.5, 16.1\u2009±\u20096.5\u2009mm; p\u2009=\u20090.005) conditions, respectively. During an ACL drilling combination of PL135/AM120, a safe zone of\u2009>\u200945° in Cor30-ALL was identified. With a narrow safe zone during the PL135/AM120 combination only, the risk of femoral tunnel collisions in combined double-bundle ACL and ALL reconstruction is high. AM drilling at 120° and PL drilling at\u2009>\u2009135° knee flexion, combined with ALL drilling at 30° coronal angle and\u2009>\u200945° axial angle, may reduce this risk.