Optimum Parametric Identification of a Stand-Alone Photovoltaic System with Battery Storage and Optimization Controller Using Averaging Approach

Abstract

The dimensioning of photovoltaic systems is the major concern of researchers and power industry practitioners. This aims to improve energy efficiency and protect the conversion units by a consistent assessment of power conditioning circuits and interconnections for the PV application. In this context, this paper sets out to fulfill detailed modeling and control steps of a standalone photovoltaic (PV) power system with energy storage, according to practical specifications of the load, PV generation unit, and battery pack. The main goal is to estimate all unknown parameters, as the diode ideality factor and revers saturation current, the controller, and the PV link. The PV link interfacing the PV source circuit to the PV-side converter (PVSC) provides a filtering function to maintain a steady voltage at the link. The charge controller used in the PV-side converter is a DC/DC buck converter. It transfers the PV power to the battery and supplies the load. Using pulse- width modulation (PWM) technical, of which the switching duty cycle is the control-input variable; the PVSC power-conditioning circuit is permanently controlled by the maximum power point tracking (MPPT) algorithm to achieve the maximum energy. The battery pack voltage is properly maintained by the charge controller and specified to match the load voltage rating, to avoid a high ratio of voltage conversion. A method is proposed to integrate both the MPPT function and the battery cycle charge. The PV generator output and the power conditioning circuits, mainly constructed from switching- mode power converters, are nonlinear. An averaged model is then derived for dynamic analysis and controller synthesis, using the state-space averaging and linearization method. A PV array of nine PV modules configured into three strings is used in this application to demonstrate the effectiveness of modeling, design, control, and simulation. Simulation model for the controller and power interface is built and developed in short term, using the fundamental blocks of Matlab Simulink.