Investigating the contribution of geometry on the failure of cellular core structures obtained by additive manufacturing

Abstract

The aim of this work is to evaluate the mechanical properties and failure analysis of cellular core structures with different geometries that were obtained by additive manufacturing. \nSandwich panels are widely used in the aerospace and automotive industry. In general, the core of the panels is made of a two dimensional cellular with a honeycomb geometry. With the development of additive manufacturing methods it is possible to produce samples with complex geometries which may compete with conventional designs. \nThus an investigation was conducted to evaluate the mechanical behavior of three core geometries, specifically, regular honeycombs, lotus and hexagonal honeycombs with Plateau borders. Samples were produced in PLA (polylactic acid) by fused deposition modelling (FDM). Experimental compressive loading in three different directions, and finite element simulations of the samples permit to evaluate their deformation and failure mechanisms. \nLoad direction angles were found to have a strong influence in the failure mode. \nAmong the three structures, and for the same relative density, the lotus geometry exhibited the highest stiffness and strength. However, the absorbed energy was found to be higher for honeycomb, at two loading directions. \nSome of the structures studied may be alternative to conventional designs pursuing the strategy of design with low weight and high stiffness.