Synthesis of 1-azaspiro[4.4]nonan-1-oxyls via intramolecular 1,3-dipolar cycloaddition

Abstract

Sterically shielded nitroxides of the pyrrolidine series have shown the highest resistance to reduction. Here we report the synthesis of new pyrrolidine nitroxides from 5,5-dialkyl-1-pyrroline N-oxides via the introduction of a pent-4-enyl group to the nitrone carbon followed by an intramolecular 1,3-dipolar cycloaddition reaction and isoxazolidine ring opening. The kinetics of reduction of the new nitroxides with ascorbate were studied and compared to those of previously published (1S,2R,3′S,4′S,5′S,2′′R)-dispiro[(2hydroxymethyl)cyclopentan-1,2′-(3′,4′-di-tert-butoxy)pyrrolidine-5′,1′′-(2′′-hydroxymethyl)cyclopentane]-1′-oxyl (1). Introduction Sterically shielded nitroxides are currently attracting much attention due to their high resistance to bioreduction [1,2]. It has been demonstrated that 2,2,5,5-tetraethylpyrrolidine nitroxides have the highest stability, sometimes exceeding that of trityl radicals [1]. Introduction of spirocyclic moieties has a smaller effect on the reduction rates of nitroxides than the introduction of linear alkyl substituents does; however, spirocyclic nitroxides may have much longer spin relaxation times at 70–125 K [3] and even at room temperature [4]. The latter effect may be useful for structural studies by means of PELDOR or DQC [5]. We recently reported the synthesis of sterically shielded pyrrolidine nitroxide 1 via a stereospecific consecutive assembly of two spiro-(2-hydroxymethyl)cyclopentane moieties. These procedures included the addition of pent-4-enylmagnesium bromide to the corresponding nitrone, oxidation to alkenylnitrone, intramolecular 1,3-dipolar cycloaddition, and isoxazolidine ring opening. Nitroxide 1 showed both an unexpectedly low reduction rate [6] and long relaxation times t1 and tm at room temperature [4]. Unexpectedly high resistance of this nitroxide to chemical reduction results from the configuration of the Beilstein J. Org. Chem. 2019, 15, 2036–2042. 2037 Scheme 1: The synthesis of aldonitrones 5a–c. Scheme 2: The principal synthetic scheme for nitroxides 12a–c. hydroxymethyl groups, which are directed towards the nitroxide group, thereby making it more hindered. It is known that inductive effects of substituents can strongly affect the rate of nitroxide reduction [7,8]; therefore, one could expect that the removal of electron-withdrawing tert-butoxy groups at positions 3 and 4 of the pyrrolidine ring of 1 (Figure 1) should lead to a further decrease in the reduction rate of the nitroxide. Figure 1: Structure of nitroxide 1. Here we describe the synthesis of C1-symmetric racemic 3,4unsubstituted pyrrolidine nitroxides with only one spiro(2hydroxymethyl)cyclopentane moiety. The rates of reduction of the new nitroxides with ascorbate were measured. Results and Discussion Aldonitrones 5b,c were prepared similarly to the well-known synthesis of 5,5-dimethyl-1-pyrroline-1-oxide (DMPO, 5a) [9,10] from nitrocyclohexane and 3-nitropentane (Scheme 1). In brief, the reaction of nitrocyclohexane and acrolein in a CH3ONa/CH3OH solution afforded the corresponding nitroaldehyde 3b with a 70% yield. Of note, the Michael addition of 3-nitropentane to acrolein was accompanied by remarkable tarring and gave a much lower yield of nitroaldehyde 3c (25%). The reactive aldehyde groups were protected via 1,3dioxolane assembly, and the resulting compounds were treated with Zn dust and NH4Cl in a water–THF solution to reduce nitro groups. The resulting hydroxylamines were treated with hydrochloric acid to hydrolyse dioxolane moieties, and careful basification resulted in intramolecular cyclisation givnig 5b,c with a yield of 51% and 42%, respectively. Nitrones 5a–c readily react with 4-pentenylmagnesium bromide. Quenching of the reaction mixtures with water under aerobic conditions leads to partial oxidation of resultant N-hydroxypyrrolidines 6a–c to corresponding nitrones 7a–c. Therefore, this conversion was finalised via bubbling of air into the solution in the presence of Cu(NH3)4 (Scheme 2). Beilstein J. Org. Chem. 2019, 15, 2036–2042. 2038 Scheme 3: A possible pathway of ketonitrone 7c self-transformations. Scheme 4: Oxidation of aminoalcohol 9a. Samples of resulting 2-(pent-4-enyl)nitrones 7a–c remarkably deteriorate during storage under aerobic conditions with dark tar formation. A possible pathway of decay may include oxidation of the ene-hydroxylamine tautomeric form to vinylnitroxide; similar compounds are prone to various dimerisation reactions (Scheme 3) [11]. It is worth noting that in the mass spectrum of 7c, the [M − 1]+ ion was observed instead of the molecular ion. The easy loss of a hydrogen atom is consistent with the susceptibility of 7c to oxidative decay (Scheme 3). Intramolecular cycloaddition of similar nitrones is known to lead to hexahydro-1H-cyclopenta[c]isoxazoles [6,12]. Indeed, heating of 7а–с at 145 °C in toluene for 30–60 min in a microwave oven produced 8a–c (racemic mixtures; Scheme 2). The structure assignment was performed on the basis of 1H and 13C NMR spectra and 1H,1H and 13C,1H correlations (see Supporting Information File 1); the spectral data are in agreement with the literature on similar systems [6]. To decrease the tarring, the reaction was carried out in the presence of 2,2,6,6-tetramethylpiperidine-1-oxyl. It should be noted that heating of alkenyl nitrones 7a and 7b gives the corresponding cycloadducts with yields close to quantitative, whereas for nitrone 7c, the complete conversion could not be achieved either at 145 °C or at a higher temperature. According to the 1Н NMR spectra, the 8c/7c ratio never exceeded 3:1. Heating of a pure sample of 8c under similar conditions caused the emergence of signals at 5.70, 4.92, and 4.87 ppm in the 1H NMR spectra. These signals were attributed to the protons of the terminal vinyl group of 7c. 1,3-Dipolar cycloaddition of nitrones to alkenes is known to be reversible [13,14]. We recently reported a similar reversibility of the intramolecular cyclization of sterically hindered pent-4-enylnitrone of the 2H-imidazole series [15]. Treatment with Zn in an AcOH/EtOH/EDTA/Na2 mixture was performed for reductive isoxazolidine ring opening [15,16] producing aminoalcohols 9a–c in 85–95% yields (Scheme 2). We have previously reported that oxidation of secondary amines with a spiro(2-hydroxymethyl)cyclopentane moiety at the α-carbon with the H2O2/WO4 system is ineffective whereas conversion of these amines to the corresponding nitroxides can be easily performed using m-chloroperbenzoic acid (m-CPBA) [6,15]. Treatment of 9a with m-CPBA in dry chloroform at −10 °C afforded a nitroxide, which was isolated as orange oil with a yield of 73% (Scheme 4). An infrared spectrum of the isolated compound showed a strong absorption band at 1725 cm−1 typical for carbonyl compounds and no absorption in the region 3100–3500 cm−1, suggesting that the hydroxymethyl group was affected in the reaction. The mass spectrum featured the molecular ion [M+] = 196.1335 corresponding to the molecular formula C11H18NO2, which matches element analysis data. These results allowed us to assign the structure 15 to this nitroxide. Indeed, oxidation of amines with peracids is known to proceed via oxoammonium cation formation [17,18], and the latter can oxidize alcohols to carbonyl compounds [19]. The close proximity of the hydroxymethyl group to the oxoammonium one favours the reaction. Treatment of 15 with NaBH4 in EtOH caused quantitative reduction of the aldehyde group to the hydroxymethyl one, thus yielding 12a identical to that prepared by the alternative method (see below). Beilstein J. Org. Chem. 2019, 15, 2036–2042. 2039 Scheme 7: A possible mechanism of nitroxide 17 formation. To prevent oxidative reactions in the side chain, the hydroxymethyl group in 9a–c was protected via acylation. Heating of 9a–c with an excess of acetic anhydride in chloroform quantitatively afforded the corresponding esters 10a–c. The products of acylation of the sterically hindered amino group were not detected in the reaction mixture. Oxidation of 10а–c with m-CPBA yielded the desired nitroxides 11a–c as orange oils. IR spectra of the new nitroxides contained no absorption bands in the region of 3000–3600 cm−1 and did not have an intense band at 1740 cm−1 characteristic for the ester C=O group. To confirm the structure of the nitroxides, alkoxyamines 16a–c were prepared by Matyjaszhewski s method (Scheme 5) [20]. Scheme 5: The synthesis of alkoxyamines 16a–c. Oxidation of aminoacetate 10a along with the expected formation of nitroxyl radical 11a, gave another nitroxide, 17, in 22% yield. The IR spectra of 11a and 17 are very similar, showing the bands typical for ester group vibrations and no bands that could be attributed to the vibrations of OH or NH groups. Besides that in the spectrum of compound 17, there are absorption bands near 3054 and 1620 cm−1, which denote the presence of a double C=C bond. To elucidate the structure, nitroxyl radical 17 was converted into alkoxyamine 18 (Scheme 6) using the literature method by Schoening et al. [21], and 1H and 13C NMR spectra, as well as two-dimensional 1H,1H-COSY and 1H,13C-HSQC and HMBC spectra were recorded (see Supporting Information File 1). Signals at 4.14 and 4.45 ppm in the 1H NMR spectrum were assigned to the hydrogen atoms of the O–C(10)H2 group. Analysis of the 1H,1H-COSY and 1H,13CHSQC NMR spectra allowed us to unambiguously assign a signal at 2.26 ppm in the 1H NMR spectrum to the methine proton on the C(9) carbon atom (see Supporting Information File 1). This signal in the 1H,1H-COSY spectrum contains two cross-peaks with hydrogens of the O–C(10)H2 group and two additional cross-peaks with signals at 2.11 and 2.36 ppm, which were assigned to the C(8)H2 group. The chemical shifts and character of the splitting for this group of signals correspond to structural fragment O–C(10)H2–C(9)H–C(8)H2. The signals of the C(8)H2 group in the COSY spectrum contain only two additional cross-peaks with t