Yu-Fong Huang

Total recovery of resources and energy from rice straw using microwave-induced pyrolysis

This article presents the application of microwave-induced pyrolysis to total recovery of resources and energy from rice straw. The microwave power and particle size of feedstock were both key parameters affecting the performance of microwave-induced pyrolysis. Under 400-500W microwave power, the reduction of fixed carbon in the biomass was significant. From the experimental results of specific surface area, zeta potential, and Cu2+ adsorption, the applications of solid residues in the water and wastewater treatment could be expected. The major compositions in gaseous product were H2, CO2, CO, CH4 of 55, 17, 13, 10vol.%, respectively. The high H2 content might imply that microwave-induced pyrolysis of biomass waste has the potential to produce the H2-rich fuel gas. Alkanes, polars, and low-ringed polycyclic aromatic hydrocarbons were three primary kinds of compounds in the liquid product.

Hydrogen-rich fuel gas from rice straw via microwave-induced pyrolysis

This study aimed to research the productivity of H(2)-rich fuel gas from rice straw using the microwave-induced pyrolysis. The formation constituents of gas product and the mechanism of its production were also discussed. The primary components of gas product were H(2), CO(2), CO, and CH(4), with average percentages of 50.67, 22.56, 16.09, and 7.42vol.%, respectively. According to the TA-MS analysis, it was suggested that focused heating by microwaves made the microwave-induced pyrolysis different from the traditional pyrolysis. A chemical equation could be nearly balanced to illustrate the gas composition generated from rice straw. From the viewpoint of energy consumption, close to 60% of the input energy could be derived and utilized as bioenergy.

Pyrolysis of biomass by thermal analysis-mass spectrometry (TA-MS).

The kinetic parameters such as pre-exponential factor and activation energy of hemicellulose, cellulose, and lignin were well determined by the linear regressions of selected, sufficient thermogravimetric data, and close to literature values. The pyrolysis of biomass can be divided into four stages. There was only drying in the zeroth stage (<150°C). In the first stage (150-250°C), some light hydrocarbons were produced with the early pyrolysis of biomass. The biomass was mainly pyrolyzed in the second stage (250-500°C) with higher reaction rates than those of other stages. The productions of H(2) and CO(2) in the third stage (>500°C) may be able to be the evidence of self-gasification of char existing at higher temperatures.

Catalytic and atmospheric effects on microwave pyrolysis of corn stover

Corn stover, which is one of the most abundant agricultural residues around the world, could be converted into valuable biofuels and bio based products by means of microwave pyrolysis. After the reaction at the microwave power level of 500W for the processing time of 30min, the reaction performance under N2 atmosphere was generally better than under CO2 atmosphere. This may be due to the better heat absorbability of CO2 molecules to reduce the heat for stover pyrolysis. Most of the metal-oxide catalysts effectively increased the maximum temperature and mass reduction ratio but lowered the calorific values of solid residues. The gas most produced was CO under N2 atmosphere but CO2 under CO2 atmosphere. Catalyst addition lowered the formation of PAHs and thus made liquid products less toxic. More liquid products and less gas products were generated when using the catalysts possibly due to the existence of the Fischer-Tropsch synthesis.

A sequential method to analyze the kinetics of biomass pyrolysis

The kinetics of biomass pyrolysis was studied via a sequential method including two stages. Stage one is to analyze the kinetics of biomass pyrolysis and starts with the determination of unreacted fraction of sample at the maximum reaction rate, (1-α)(m). Stage two provides a way to simulate the reaction rate profile and to verify the appropriateness of kinetic parameters calculated in the previous stage. Filter paper, xylan, and alkali lignin were used as representatives of cellulose, hemicellulose, and lignin whose pyrolysis was analyzed with the assumption of the orders of reaction being 1, 2, and 3, respectively. For most of the biomass pyrolysis, kinetic parameters were properly determined and reaction rate profiles were adequately simulated by regarding the order of reaction as 1. This new method should be applicable to most of the biomass pyrolysis and similar reactions whose (1-α)(m) is acquirable, representative, and reliable.

Microwave torrefaction of rice straw and pennisetum.

Microwave torrefaction of rice straw and pennisetum was researched in this article. Higher microwave power levels contributed to higher heating rate and reaction temperature, and thus produced the torrefied biomass with higher heating value and lower H/C and O/C ratios. Kinetic parameters were determined with good coefficients of determination, so the microwave torrefaction of biomass might be very close to first-order reaction. Only 150W microwave power levels and 10min processing time were needed to meet about 70% mass yield and 80% energy yield for torrefied biomass. The energy density of torrefied biomass was about 14% higher than that of raw biomass. The byproducts (liquid and gas) possessed about 30% mass and 20% energy of raw biomass, and they can be seen as energy sources for heat or electricity. Microwave torrefaction of biomass could be a competitive technology to employ the least energy and to retain the most bioenergy.

Catalytic pyrolysis of sugarcane bagasse by using microwave heating.

The aim of this study was to research the catalytic effects on the microwave pyrolysis of sugarcane bagasse and thus to discuss the reaction performance, product distribution, and kinetic analysis. With the addition of metal-oxides served as catalysts, reaction results such as mass reduction ratio and reaction rate increased, even the maximum temperature decreased. Adding either NiO or CaO slightly increased the production of H2, while adding either CuO or MgO slightly decreased it. The addition of either CaO or MgO enhanced the gaseous production, and either NiO or CuO addition enhanced the liquid production. There could be several secondary reactions such as self-gasification and interactions among the gases originally produced during the pyrolysis stage to alter the composition of gaseous product and the final three-phase product distribution. The catalyst addition slightly increased the activation energy but greatly increased the pre-exponential factor.

Microwave pyrolysis of rice straw: products, mechanism, and kinetics.

Rice straw is an abundant resource for the production of biofuels and bio-based products. How to convert the recalcitrant lignocellulose effectually is a critical issue. The objective of this study was to investigate the products, mechanism, and kinetics of rice straw pyrolysis by using microwave heating. The highest energy densification ratio of solid residues was achieved at the microwave power level of 300 W. The atomic H/C and O/C ratios of solid residues were much lower than those of rice straw. The primary components of gaseous product were CO, H2, CO2, and CH4, whose molecular fractions were 57%, 21%, 14%, and 8%, respectively. The more gaseous product and the less solid residues were obtained at higher microwave power levels, while the liquid production remained the same and showed a maximum of about 50 wt.%. The kinetic parameters of rice straw pyrolysis were increased with increasing microwave power level.

Life cycle assessment of biochar cofiring with coal.

This study used life cycle assessment software SimaPro 7.2 and impact assessment model IMPACT 2002+ to evaluate the environmental impact and benefits of a biochar cofiring supply chain used for electricity generation. The biochar was assumed to be produced by rice straw torrefaction and the case study was located in Taoyuan County, Taiwan. This supply chain may provide impact reduction benefits in five categories (aquatic ecotoxicity, terrestrial ecotoxicity, land occupation, global warming, and non-renewable energy) but cause higher impacts than coal firing systems in other categories. Damage assessment of cofiring systems indicated that damage to human health was higher while the damage categories of ecosystem quality, climate change, and resources were lower. Carbon reduction could be 4.32 and 4.68metric tons CO2eq/ha/yr at 10% and 20% cofiring ratios, respectively. The improvement of electricity generation efficiency of cofiring systems may be the most important factor for reducing its environmental impact.