A. E. Gomez

The metal content of bulge field stars from FLAMES-GIRAFFE spectra - I. Stellar parameters and iron abundances

Aims. We determine the iron distribution function (IDF) for bulge field stars, in three different fields along the Galactic minor axis and at latitudes b = −4 ◦ , b = −6 ◦ ,a ndb = −12 ◦ . A fourth field including NGC 6553 is also included in the discussion. Methods. About 800 bulge field K giants were observed with the GIRAFFE spectrograph of FLAMES@VLT at spectral resolution R ∼ 20 000. Several of them were observed again with UVES at R ∼ 45 000 to insure the accuracy of the measurements. The LTE abundance analysis yielded stellar parameters and iron abundances that allowed us to construct an IDF for the bulge that, for the first time, is based on high-resolution spectroscopy for each individual star. Results. The IDF derived here is centered on solar metallicity, and extends from [Fe/H] ∼− 1.5 to [Fe/H] ∼ +0.5. The distribution is asymmetric, with a sharper cutoff on the high-metallicity side, and it is narrower than previously measured. A variation in the mean metallicity along the bulge minor axis is clearly between b = −4 ◦ and b = −6 ◦ ([Fe/H] decreasing ∼ by 0.6 dex per kpc). The field at b = −12 ◦ is consistent with the presence of a gradient, but its quantification is complicated by the higher disk/bulge fraction in this field. Conclusions. Our findings support a scenario in which both infall and outflow were important during the bulge formation, and then suggest the presence of a radial gradient, which poses some challenges to the scenario in which the bulge would result solely from the vertical heating of the bar.

The metallicity distribution of bulge clump giants in Baade’s window

Aims. We seek to constrain the formation of the Galactic bulge by analysing the detailed chemical composition of a large sample of red clump stars in Baade’s window. These stars were selected to minimise the contamination by other Galactic components, so they are good tracers of the bulge metallicity distribution in Baade’s window, at least for stars more metal-rich than ∼−1.5. Methods. We used an automatic procedure to measure [Fe/H] differentially with respect to the metal-rich star μLeo in a sample of 219 bulge red clump stars from R = 20 000 resolution spectra obtained with FLAMES/GIRAFFE at the VLT. For a subsample of 162 stars, we also derived [Mg/H] from spectral synthesis around the Mg i triplet at λ 6319 A. Results. The Fe and Mg metallicity distributions are both asymmetric with median values of +0.16 and +0.21, respectively. They show only a small proportion of stars at low metallicities, extending down to [Fe/H] = −1. 1o r [Mg/H] = −0.7. The iron distribution is clearly bimodal, as revealed both by a deconvolution (from observational errors) and a Gaussian decomposition. The decomposition of the observed Fe and Mg metallicity distributions into Gaussian components yields two populations of equal sizes (50% each): a metal-poor component centred on [Fe/H] = −0.30 and [Mg/H] = −0.06 with a large dispersion and a narrow metal-rich component centred on [Fe/H] =+ 0.32 and [Mg/H] =+ 0.35. The metal-poor component shows high [Mg/Fe] ratios (around 0.3), while stars in the metal-rich component are found to have nearly solar ratios. Kinematical differences between the two components have also been found: the metal-poor component shows kinematics compatible with an old spheroid, while the metal-rich component is consistent with a population supporting a bar. In view of their chemical and kinematical properties, we suggest different formation scenarii for the two populations: a rapid formation time scale as an old spheroid for the metal-poor component (old bulge) and for the metal-rich component, a formation on a longer time scale driven by the evolution of the bar (pseudo-bulge). The observations are described well by a simple model consisting of two components: a simple closed box model to predict the metal-poor population contribution and a local thin disc metallicity distribution, shifted in metallicity, to represent the metal-rich population. The pseudo-bulge is compatible with its being formed from the inner thin disc, assuming high (but plausible) values of the gradients in the early Galactic disc.

Insights on the Milky Way bulge formation from the correlations between kinematics and metallicity

Context. Two main scenarios for the formation of the Galactic bulge are invoked, the first one through gravitational collapse or hierarchical merging of subclumps, the second through secular evolution of the Galactic disc. Aims. We aim to constrain the formation of the Galactic bulge through studies of the correlation between kinematics and metallicities in Baades Window (l = 1°, b = -4°) and two other fields along the bulge minor axis (l = 0°, b = -6° and b = -12°). Methods. We combine the radial velocity and the [Fe/H] measurements obtained with FLAMES/GIRAFFE at the VLT with a spectral resolution of R = 20 000, plus for the Baades Window field the OGLE-II proper motions, and compare these with published N-body simulations of the Galactic bulge. Results. We confirm the presence of two distinct populations in Baades Window found in Hill et al. (2010, A&A, submitted): the metal-rich population presents bar-like kinematics while the metal-poor population shows kinematics corresponding to an old spheroid or a thick disc. In this context the metallicity gradient along the bulge minor axis observed by Zoccali et al. (2008, A&A, 486, 177), visible also in the kinematics, can be related to a varying mix of these two populations as one moves away from the Galactic plane, alleviating the apparent contradiction between the kinematic evidence of a bar and the existence of a metallicity gradient. Conclusions. We show evidence that the two main scenarios for the bulge formation co-exist within the Milky Way bulge.

Alpha element abundances and gradients in the Milky Way bulge from FLAMES-GIRAFFE spectra of 650 K giants

Aims. We present the analysis of the [α/Fe] abundance ratios for a large number of stars at several locations in the Milky Way bulge with the aim of constraining its formation scenario. Methods. We obtained FLAMES-GIRAFFE spectra (R = 22 500) at the ESO Very Large Telescope for 650 bulge red giant branch (RGB) stars and performed spectral synthesis to measure Mg, Ca, Ti, and Si abundances. This sample is composed of 474 giant stars observed in 3 fields along the minor axis of the Galactic bulge and at latitudes b = −4 ◦ , b = −6 ◦ , b = −12 ◦ . Another 176 stars belong to a field containing the globular cluster NGC 6553, located at b = −3 ◦ and 5 ◦ away from the other three fields along the major axis. Stellar parameters and metallicities for these stars were presented in Zoccali et al. (2008, A&A, 486, 177). We have also re-derived stellar parameters and abundances for the sample of thick and thin disk red giants analyzed in Alves-Brito et al. (2010, A&A, 513, A35). Therefore using a homogeneous abundance database for the bulge, thick and thin disk, we have performed a differential analysis minimizing systematic errors, to compare the formation scenarios of these Galactic components. Results. Our results confirm, with large number statistics, the chemical similarity between the Galactic bulge and thick disk, which are both enhanced in alpha elements when compared to the thin disk. In the same context, we analyze [α/Fe] vs. [Fe/H] trends across different bulge regions. The most metal rich stars, showing low [α/Fe] ratios at b = −4 ◦ disappear at higher Galactic latitudes in agreement with the observed metallicity gradient in the bulge. Metal-poor stars ([Fe/H] < −0.2) show a remarkable homogeneity at different bulge locations. Conclusions. We have obtained further constrains for the formation scenario of the Galactic bulge. A metal-poor component chemically indistinguishable from the thick disk hints for a fast and early formation for both the bulge and the thick disk. Such a component shows no variation, neither in abundances nor kinematics, among different bulge regions. A metal-rich component showing low [α/Fe] similar to those of the thin disk disappears at larger latitudes. This allows us to trace a component formed through fast early mergers (classical bulge) and a disk/bar component formed on a more extended timescale.

Mapping a stellar disk into a boxy bulge: The outside-in part of the Milky Way bulge formation

By means of idealized, dissipationless N-body simulations which follow the formation and subsequent buckling of a stellar bar, we study the characteristics of boxy/peanut-shaped bulges and compare them with the properties of the stellar populations in the Milky Way bulge. The main results of our modeling, valid for the general family of boxy/peanut shaped bulges, are the following: (i) because of the spatial redistribution in the disk initiated at the ep och of bar formation, stars from the innermost regions to the outer Lindblad resonance of the stellar bar are mapped into a boxy bulge; (ii) the contribution of stars to the local bulge density depends on their birth radius: stars born in the innermost disk tend to dominate the innermost regions of the boxy bulge, while stars originating closer to the OLR are preferentially found in the outer regions of the boxy/peanut structure; (iii) stellar birth radii are imprinted in the bulge kinematics, the larger the birth radii of stars ending up in t he bulge, the greater their rotational support and the highe r their line-ofsight velocity dispersions (but note that this last trend de pends on the bar viewing angle); (iv) the higher the classical bulge-over-disk ratio, the larger its fractional contribution of stars at la rge vertical distance from the galaxy mid-plane. Comparing these results with the properties of the stellar populations of the Milky Way’s bulge recently revealed by the ARGOS survey, we conclude that: (I) the two most metal-rich populations of the MW bulge, labeled A and B in the ARGOS survey, originate in the disk, with the population of A having formed on average closer to the Galaxy center than the population of component B; (II) a massive (B/D∼0.25) classical spheroid can be excluded for the Milky Way, thus confirming pr evious findings that the Milky Way bulge is composed of popula tions that mostly have a disk origin. On the basis of their chemical and kinematic characteristics, the results of our modeling suggests that the populations A, B and C, as defined by the ARGOS survey, can b e associated, respectively, with the inner thin disk, to the young thick and to the old thick disk, following the nomenclature recently suggested for stars in the solar neighborhood by Haywood et al. (2013).

Reconstructing the star formation history of the Milky Way disc(s) from chemical abundances

We develop a chemical evolution model in order to study the star formation history of the Milky Way. Our model assumes that the Milky Way is formed from a closed box-like system in the inner regions, while the outer parts of the disc experience some accretion. Unlike the usual procedure, we do not fix the star formation prescription (e.g. Kennicutt law) in order to reproduce the chemical abundance trends. Instead, we fit the abundance trends with age in order to recover the star formation history of the Galaxy. Our method enables one to recover with unprecedented accuracy the star formation history of the Milky Way in the first Gyrs, in both the inner (R 9-10kpc) discs as sampled in the solar vicinity. We show that, in the inner disc, half of the stellar mass formed during the thick disc phase, in the first 4-5 Gyr. This phase was followed by a significant dip in the star formation activity (at 8-9 Gyr) and a period of roughly constant lower level star formation for the remaining 8 Gyr. The thick disc phase has produced as many metals in 4 Gyr as the thin disc in the remaining 8 Gyr. Our results suggest that a closed box model is able to fit all the available constraints in the inner disc. A closed box system is qualitatively equivalent to a regime where the accretion rate, at high redshift, maintains a high gas fraction in the inner disc. In such conditions, the SFR is mainly governed by the high turbulence of the ISM. By z~1 it is possible that most of the accretion takes place in the outer disc, while the star formation activity in the inner disc is mostly sustained by the gas not consumed during the thick disc phase, and the continuous ejecta from earlier generations of stars. The outer disc follows a star formation history very similar to that of the inner disc, although initiated at z~2, about 2 Gyr before the onset of the thin disc formation in the inner disc.

Why the Milky Way’s bulge is not only a bar formed from a cold thin disk

By analyzing a N-body simulation of a bulge formed simply via a bar instability mechanism operating on a kinematically cold stellar disk, and by comparing the results of this analysis with the structural and kinematic properties of the main stellar populations of the Milky Way bulge, we conclude that the bulge of our Galaxy is not a pure stellar bar formed from a pre-existing thin stellar disk, as some studies have recently suggested. On the basis of several arguments emphasized in this paper, we propose that the bulge population which, in the Milky Way, is observed not to be part of the peanut structure corresponds to the old galactic thick disk, thus implying that the Milky Way is a pure thin+thick disk galaxy, with only a possible limited contribution of a classical bulge.

When the Milky Way turned off the lights: APOGEE provides evidence of star formation quenching in our Galaxy

Quenching, the cessation of star formation, is one of the most significant events in the life cycle of galaxies. We show here the first evidence that the Milky Way experienced a generalised quenching of its star formation at the end of its thick disk formation

Metallicity and kinematics of the bar in situ

\sim

Li-rich red giant branch stars in the Galactic bulge

9 Gyr ago. Elemental abundances of stars studied as part of the APOGEE survey reveal indeed that in less than