A.N. Hassan

Comparison of the attachment of Escherichia coli O157:H7, Listeria monocytogenes, Salmonella Typhimurium, and Pseudomonas fluorescens to lettuce leaves.

Attachment of Escherichia coli O157:H7, Listeria monocytogenes, Salmonella Typhimurium, and Pseudomonas fluorescens on iceberg lettuce was evaluated by plate count and confocal scanning laser microscopy (CSLM). Attachment of each microorganism (approximately 10(8) CFU/ml) on the surface and the cut edge of lettuce leaves was determined. E. coli O157:H7 and L. monocytogenes attached preferentially to cut edges, while P. fluorescens attached preferentially to the intact surfaces. Differences in attachment at the two sites were greatest with L. monocytogenes. Salmonella Typhimurium attached equally to the two sites. At the surface, P. fluorescens attached in greatest number, followed by E. coli O157:H7, L. monocytogenes, and Salmonella Typhimurium. Attached microorganisms on lettuce were stained with fluorescein isothiocyanate and visualized by CSLM. Images at the surface and the cut edge of lettuce confirmed the plate count data. In addition, microcolony formation by P. fluorescens was observed on the lettuce surface. Some cells of each microorganism at the cut edge were located within the lettuce tissues, indicating that penetration occurred from the cut edge surface. The results of this study indicate that different species of microorganisms attach differently to lettuce structures, and CSLM can be successfully used to detect these differences.

Behavior of Listeria monocytogenes in a Pseudomonas putida Biofilm on a Condensate-Forming Surface

Listeria monocytogenes has been isolated from condensate-forming surfaces in food processing plants. The objective of this research was to observe the behavior of L. monocytogenes on condensate-covered stainless steel with a Pseudomonas putida biofilm. L. monocytogenes-containing biofilms, either with or without added chicken protein, were incubated in a high humidity chamber at 12 degrees C to allow formation of condensate. Samples were analyzed for attached and unattached L. monocytogenes and total plate count periodically for 35 days. Samples were also taken for microscopic observation of Listeria and bacterial extracellular polymeric substances (EPS). L. monocytogenes attached in significantly greater numbers (> 3-log difference) to surfaces with preexisting P. putida biofilms than to Pseudomonas-free surfaces. L. monocytogenes survived in the presence or absence of P. putida with no added nutrients for 35 days, with numbers of survivors in the range of 3 to 4 log CFU/cm2 in the presence of P. putida and less than 2.9 log CFU/cm2 in pure culture. Attached and unattached L. monocytogenes were at similar levels throughout the incubation under all conditions studied. The addition of protein to the biofilms allowed growth of L. monocytogenes in pure culture during the first 7 days of incubation. Numbers of L. monocytogenes were not affected by the presence of P. putida when protein was present. Unattached L. monocytogenes were at levels of 3.6 to 6.7 log CFU/cm2 on the protein-containing surfaces. Microscopic observation of the condensate-covered biofilms indicated that L. monocytogenes formed microcolonies embedded within an EPS matrix over a 28-day period. This research demonstrates that L. monocytogenes can survive on condensate-forming stainless steel in low and high nutrient conditions, with or without the presence of Pseudomonas biofilm. The Listeria can detach and, therefore, have the potential to contaminate product.

Penetration of Escherichia coli O157:H7 into lettuce as influenced by modified atmosphere and temperature.

The effects of temperature and atmospheric oxygen concentration on the respiration rate of iceberg lettuce and Escherichia coli O157:H7 cells attachment to and penetration into damaged lettuce tissues were evaluated. Respiration rate of lettuce decreased as the temperature was reduced from 37 to 10 degrees C. Reducing the temperature further to 4 degrees C did not affect the respiration rate of lettuce. Respiration rate was also reduced by lowering the atmospheric oxygen concentration. Lettuce was submerged in E. coli O157:H7 inoculum at 4, 10, 22, or 37 degrees C under 21 or 2.7% oxygen. Attachment and penetration of E. coli O157:H7 were not related to the respiration rate. The greatest numbers of E. coli O157:H7 cells attached to damaged lettuce tissues at 22 degrees C at both oxygen concentrations. More cells were attached under 21% oxygen than under 2.7% oxygen at each temperature, but this difference was small. Penetration of E. coli O157:H7 into lettuce tissue was determined by immunostaining with a fluorescein isothiocyanate-labeled antibody. Under 21% oxygen, E. coli O157:H7 cells showed greatest penetration when lettuce was held at 4 degrees C, compared to 10, 22. or 37 degrees C, and were detected at an average of 101 microm below the surfaces of cut tissues. However, under 2.7% oxygen, there were no differences in degree of penetration among four incubation temperatures. The degree of E. coli O157:H7 penetration into lettuce tissue at 4 or 22 degrees C was greater under 21% oxygen than under 2.7% oxygen; however, no difference was observed at 37 degrees C. Conditions that promote pathogen penetration into tissue could decrease the effectiveness of decontamination treatments.

Modification of microstructure and texture of rennet curd by using a capsule-forming non-ropy lactic culture

Microstructural and textural characteristics of rennet curd made from rehydrated non-fat dried milk standardized to 40 g fat/l were compared with those of non-fat curd made with capsule-forming non-ropy lactic culture. Microstructure examination using confocal scanning laser microscopy indicated that the presence of a capsule-forming culture produced an open casein network with large pores. Distribution of fat globules was observed within the undisturbed casein structure after staining with a fluorescent lipophilic dye which was added to the milk before coagulation. Bacterial capsules and milk fat reduced curd tension and firmness of rennet curd to similar levels.

Microstructure and rheology of an acid-coagulated cheese (Karish) made with an exopolysaccharide-producing Streptococcus thermophilus strain and its exopolysaccharide non-producing genetic variant

The objective of this research was to determine the effect of exopolysaccharide (EPS) production by lactic acid bacteria on the microstructure and rheology of Karish cheese, a soft acid coagulated cheese made using skim milk. An EPS-producing strain of Streptococcus thermophilus, and its EPS non-producing genetic variant were used to make comparable batches of the cheese. EPS in cheese was visualized by cryo-SEM as a large, dense, filamentous mass. Cheese made with the EPS non-producing culture was characterized by a dense protein network with smaller pores compared to that prepared with the EPS-producing culture. High elastic and viscous moduli measured by dynamic rheology were observed for EPS negative cheese and was attributed to its dense protein network. Creep test experiments demonstrated that cheese prepared with the EPS non-producing strain was more rigid and recovered its deformation, while cheese made using the EPS producing culture was more deformable. These results indicate that EPS-producing cultures can improve the physical properties of Karish cheese by reducing undesirable rigidity.