A. N. Sosnin

Determination of energetic neutron spatial distribution using neutron induced nuclear recoil events

Abstract Neutron induced nuclear recoils were used to determine the spatial distribution of the weakly moderated spallation neutrons produced in the interaction of 1 GeV protons with lead and uranium–lead targets. CR39 plastic track detectors were used to record neutron-induced recoil tracks. The track density measurements were carried out using a fully automated optical microscope. The experimental results were compared with Monte Carlo simulations using MCNPX-2.1.5 code and an extension code that was written for this purpose. A good agreement was found between the experiment and calculations for normalised results. Applicability of the MCNPX-2.1.5 code for absolute recoil track density determination is discussed.

SSNTD and radiochemical studies on the transmutation of nuclei using relativistic ions

Extended targets were irradiated for transmutation studies with relativistic heavy ions. For this, a metal core was surrounded by a paraffin moderator. The metal is either copper or lead and it was irradiated with deuterium, alpha, or carbon beams of 1.5 or 3.7 GeV/u at the SYNCHROPHASOTRON, LHE, JINR, Dubna, Russia. During this irradiation copious amounts of secondary neutrons are produced and studied with SSNTD detectors and radiochemical sensors, for example: 139 La (n,γ) 140 La→ B- . The yield of reaction products allows an estimation of secondary neutron fluxes. The yields of all kinds of reactions produced with deuterium and alpha beams obey to some extent the law of limiting fragmentation, i.e. they show little influence on the energy and the kind of incoming particles. However, one observes with 44 GeV 12 C ions always enhanced nuclear cross-sections induced by secondary particles. This behavior could not be confirmed with theoretical estimations based on the Dubna Cascade Model in its Cascade Evaporation Model version (DCM-CEM). Finally, some results for transmutation studies on 127 I and Cu will be presented.

Secondary neutron production from thick Pb target by light particle irradiation

Abstract Neutron multiplicities from spallation neutron sources were measured by Solid State Nuclear Track Detectors. Light particles as protons, deuterons and alphas in the GeV range were used on Pb targets. For neutron thermalization the targets were covered by 6 cm paraffin moderator. Neutron multiplicity distributions were studied inside and on the moderator surface. Comparison of SSNTDs results were made for thermal-epithermal neutrons with 139 La activation method as well as with Dubna DCM/CEM code. Discussion including previous 12 C results are given.

Monitor reactions in Al-foils for high energy proton beams bombarding a thick target

Abstract During the bombardment of U and Pb targets (each 21 cm thick) with protons of energy 1.0 and 1.5 GeV, the reactions 27Al(p, 3pn)24Na and nat.Cu(p, X)24Na were studied as monitor reactions. The influence of 27Al(n, α)24Na on the monitor reaction 27Al(p, 3pn)24Na was investigated experimentally and theoretically. In order to avoid the influence of (n, α) reaction, placing of the Al-monitors 35 cm upstream the massive targets is recommended. This method may be used in Accelerator-Driven-Transmutation (ADT) studies of long-lived nuclear waste, where one always uses a massive heavy element target irradiated with protons at about 1 GeV. The experiments were performed at the Laboratory of High Energies, JINR, Dubna, Russian Federation.

Transmutation studies using ssntd and radiochemistry and the associated production of secondary neutrons

Abstract Experiments using 1.5 GeV, 3.7 GeV and 7.4 GeV protons from the Synchrophasotron, LHE, JINR, Dubna, Russia, on extended Pb- and U-targets were carried out using SSNTD and radiochemical sensors for the study of secondary neutron fluences. We also carried out first transmulation studies on the long-lived radwaste nuclei 129I and 237Np. In addition, we carried out computer code simulation studies on these systems using LAHET and DCM/CEM codes. We have difficulties to understand rather large transmutation rates observed experimentally when they are compared with computer simulations. There seems to be a rather fundamental problem understanding the large transmutation rates as observed experimentally in Dubna and CERN, as compared to those theoretical computer simulations mentioned above.

Transmutation of 239 Pu with spallation neutrons

Incineration studies of plutonium were carried out at the Synchrophasotron of the Joint Institute for Nuclear Research (JINR), Dubna, using proton beams with energies of 0.53 GeV and 1.0 GeV. Solid lead targets (8 cm in diameter and 20 cm long) were surrounded with 6 cm thick paraffin as neutron moderator and then irradiated. The transmutation of 239 Pu and the associated production of fission products 91 Sr, 92 Sr, 97 Zr, 99 Mo, 103 Ru, 105 Ru, 129 Sb, 132 Te, 133 I, 135 I and 143 Ce were studied in the present work. The plutonium samples (each 449 mg) were placed on the outer surface of moderator. For 1.0 GeV proton beam, the fission rate of 239 Pu is 0.0032 atoms per proton in one gram plutonium samples, for 0.53 GeV proton, this value is 0.0022. The experimental uncertainty is about 15%. The experiments are compared to two theoretical model calculations with moderate success, using the Dubna Cascade Model (CEM) and the LAHET code. The practical incineration rate of 239 Pu is very high. For example: if one uses 10 mA, 1 GeV proton beams under the same (fictive) experimental conditions, the incineration rate of 239 Pu via fission is 3 mg out of the 449 mg sample per day. For 0.53 GeV protons the corresponding rate is 2 mg per day.

Application of activation methods on the Dubna experimental transmutation set-ups.

High spallation neutron fluxes were produced by irradiating massive heavy targets with proton beams in the GeV range. The experiments were performed at the Dubna High Energy Laboratory using the nuclotron accelerator. Two different experimental set-ups were used to produce neutron spectra convenient for transmutation of radioactive waste by (n,x) reactions. By a theoretical analysis neutron spectra can be reproduced from activation measurements. Thermal-epithermal and fast-super-fast neutron fluxes were estimated using the 197Au, 238U (n,gamma) and (n,2n) reactions, respectively. Depleted uranium transmutation rates were also studied in both experiments.

Studies on neutron production in the interaction of 7.4 GeV protons with extended lead target

Abstract A cylindrical lead target of diameter 8 cm and length 20 cm was irradiated with 7.4 GeV protons along the axis of the cylinder. The lead target was surrounded with a paraffin layer of thickness 6 cm to moderate the neutrons produced in p + Pb reactions. The spatial distribution of the slow and fast neutrons on different surfaces of the moderator were determined using LR 115 2B detectors (through 10 B(n,α) 7 Li reactions) and CR39 detectors (through proton recoils) respectively. Such results can be valuable in the studies and design of Accelerator Driven Subcritical Nuclear Reactors and Nuclear Waste Incinerators.

Interactions of Relativistic Heavy Ions in Thick Heavy Element Targets and Some Unresolved Problems

Interactions of relativistic heavy ions with total energies above 30 GeV in thick Cu and Pb targets (≥ 2 cm) have been studied with various techniques. Radiochemical irradiation experiments using thick Cu targets, both in a compact form or as diluted “2π-Cu targets” have been carried out with several relativistic heavy ions, such as 44 GeV 12C (JINR, Dubna, Russia) and 72 GeV 40Ar (LBL, Berkeley, USA). Neutron measuring experiments using thick targets irradiated with various relativistic heavy ions up to 44 GeV 12C have been performed at the JINR. In addition, the number of “black prongs” in nuclear interactions (due to protons with energies less than 30 MeV and emitted from the target-like interaction partner at rest) produced with 72 GeV 22Ne ions in nuclear emulsion plates has been measured in the first nuclear interaction of the primary 22Ne ion and in the following second nuclear interaction of the secondary heavy (Z > 1) ion. Some essential results have been obtained. (1) Spallation products produced by relativistic secondary fragments in interactions ([44 GeV 12C or 72 GeV 40Ar] + Cu) within thick copper yield fewer products close to the target and many more products far away from the target as compared to primary beam interactions. This applies also to secondary particles emitted into large angles (Θ > 10°). (2) The neutron production of 44 GeV 12C within thick Cu and Pb targets is beyond the estimated yield as based on experiments with 12 GeV 12C. These rather independent experimental results cannot be understood within well-accepted nuclear reaction models. They appear to present unresolved problems.

Precision half-life measurement of 140La with Ge-detector

Abstract Half-life is one of the fundamental properties of radioactive nuclei, and the precision required for its numerous applications in modern physics sometimes approaches the level of 10−4–10−5. Most part of the T1/2 measurements performed up to now was made with proportional chambers, and the results were sometimes hardly reproducible within the error limits. Using Ge-detectors for that purpose brought some significant advantages but electronic unit related effects and spectra analysis procedures still remain the sources of the errors influencing the accuracy of the T1/2 attained. In this work, 140 La samples were obtained in the 139 La(n,γ) 140 La reaction, employing a microtron as a neutron source and the half-life measurements were performed with a HPGe-detector. Influencing factors such as photopeak and background shape, electronic circuitry dead time and deadtime variations during the measurements, as well as pulse pileup are studied altogether. Values of the 140 La T1/2=1.6808(18) d, λ=0.47749(20)×10−5, agreeing within the uncertainities with the most accurate evaluated ones (T1/2=1.6781(3) d, λ=0.47807(9)×10−5) [2] were obtained in two series of measurements.