A. R. Kovsh

InAs/InGaAs quantum dot structures on GaAs substrates emitting at 1.3 μm

InAs self-organized quantum dots inserted in InGaAs quantum well have been grown on GaAs substrates by molecular beam epitaxy. The lateral size of the InAs islands has been found to be approximately 1.5 times larger as compared to the InAs/GaAs case, whereas the island heights and surface densities were close in both cases. The quantum dot emission wavelength can be controllably changed from 1.1 to 1.3 μm by varying the composition of the InGaAs quantum well matrix. Photoluminescence at 1.33 μm from vertical optical microcavities containing the InAs/InGaAs quantum dot array was demonstrated.

Quantum dot lasers

We presents both edge emitting and surface emitting quantum dot laser research. Growth is by both MOCVD and MBE.

The role of Auger recombination in the temperature-dependent output characteristics (T0=∞) of p-doped 1.3 μm quantum dot lasers

Temperature invariant output slope efficiency and threshold current (T0=∞) in the temperature range of 5–75 °C have been measured for 1.3 μm p-doped self-organized quantum dot lasers. Similar undoped quantum dot lasers exhibit T0=69K in the same temperature range. A self-consistent model has been employed to calculate the various radiative and nonradiative current components in p-doped and undoped lasers and to analyze the measured data. It is observed that Auger recombination in the dots plays an important role in determining the threshold current of the p-doped lasers.

QUANTUM DOT LASERS: BREAKTHROUGH IN OPTOELECTRONICS

Abstract Semiconductor heterostructures with self-organized quantum dots (QDs) have experimentally exhibited properties expected for zero-dimensional systems. When used as active layer in the injection lasers, these advantages help to strongly increase material gain and differential gain, to improve temperature stability of the threshold current, and to provide improved dynamic properties. Molecular beam epitaxy (MBE) represents a developed technology well suited for fabrication of self-organized QDs. Optimization of deposition parameters can ensure that the self-organized islands are small (∼10 nm), have a similar size and shape and form dense arrays. Saturation material gain is as high as 150000 cm −1 compared with QW values of about 3000 cm −1 . Maximum differential gain reported for QD lasers approaches 10 −12 cm 2 and exceeds the QW laser values by about three orders of magnitude. Direct observation of relaxation oscillations reveals present cut-off frequencies close to 10 GHz. High internal (>96%) and differential (70%) efficiencies at 300 K are realized. Using the novel concept of electronically-coupled QDs and oxide-defined 10 μm apertures, CW lasing with J th =180 A/cm 2 , is realized in surface-emitting QD lasers (300 K). Wall-plug efficiencies are up to 16%. Total currents as low as 68 μA are measured for 1μm apertures. GaAs-based lasers for the 1.3 μm range with low J th (65 A/cm 2 ) at room temperature (RT) are realized using InAs/InGaAs/GaAs QDs obtained by activated spinodal decomposition. In stripes the lasing occurs via the QD ground state ( J th =90 A/cm 2 ) for cavity lengths L >1 mm (uncoated). Differential efficiency is 55% and internal losses are 1.5 cm −1 . A characteristic temperature near RT is 160 K. 3W CW operation at RT is achieved. The recent progress in lasers based on self-organized MBE QDs already made it possible to fabricate devices with dramatically improved characteristics as compared to recent QW devices for the most important commercial applications.

High-power picosecond and femtosecond pulse generation from a two-section mode-locked quantum-dot laser

We demonstrate mode locking in a two-section quantum-dot laser that produces output powers up to 45 mW at 1260 nm. The pulse duration could be varied from 2 ps to as short as 400 fs at the 21 GHz pulse repetition rate.

High power temperature-insensitive 1.3 µm InAs/InGaAs/GaAs quantum dot lasers

We report on GaAs-based broad area (100 µm) 1.3 µm quantum dot (QD) lasers with high CW output power (5 W) and wall-plug efficiency (56%). The reliability of the devices has been demonstrated beyond 3000 h of CW operation at 0.9 W and 40 °C heat sink temperature with 2% degradation in performance. P-doped QD lasers with a temperature-insensitive threshold current (T0 > 650 K) and differential efficiency (T1 = infinity) up to 80 °C have been realized.

Continuous-wave operation of long-wavelength quantum-dot diode laser on a GaAs substrate

Continuous-wave operation near 1.3 /spl mu/m or a diode laser based on self-organized quantum dots (QDs) on a GaAs substrate is demonstrated. Multiple stacking of InAs QD planes covered by thin InGaAs layers allows us to prevent gain saturation and achieve long-wavelength lasing with low threshold current density (90-105 A/cm/sup 2/) and high output power (2.7 W) at 17/spl deg/C heatsink temperature. It is thus confirmed that QD lasers of this kind are potential candidates to substitute InP-based lasers in optical fiber systems.

Long-wavelength lasing from multiply stacked InAs/InGaAs quantum dots on GaAs substrates

An InAs quantum dot (QD) array covered by a thin InGaAs layer was used as the active region of diode lasers grown by molecular beam epitaxy on GaAs substrates. The wavelength of the ground-state transition in such heterostructures is in the 1.3 μm range. In the laser based on the single layer of QDs, lasing proceeds via the excited states due to insufficient gain of the ground level. Stacking of three QD planes prevents gain saturation and results in a low threshold (85 A/cm2 in broad-area 1.9-mm-long stripe) long-wavelength (1.25 μm) lasing at room temperature via the QD ground state with relatively high differential efficiency (>50%).

Quantum dot laser with 75 nm broad spectrum of emission

We report on a quantum dot laser having an emission spectrum as broad as 74.9 nm at 25 degrees C in the 1.2-1.28 wavelength interval with a total pulsed output power of 750 mW in single lateral mode regime and the average spectral power density of >10 mW/nm. A significant overlap and approximate equalization of the ground-state and the excited-state emission bands in the lasers spectrum is achieved by means of intentional inhomogeneous broadening of the quantum dot energy levels.

Effect of matrix on InAs self-organized quantum dots on InP substrate

InAs self-organized quantum dots in In0.53Ga0.47As and In0.52Al0.48As matrices have been grown on InP substrates by molecular beam epitaxy. The dot size in InGaAs has been found to be 3–4 times larger, but the areal density about an order of magnitude smaller than that in InAlAs. Low-temperature photoluminescence (PL) of the InAs/InGaAs quantum dots is characterized by a narrow (35 meV) PL line as compared to that of InAs/InAlAs quantum dots (170 meV). Quantum dot formation increases the carrier localization energy as compared to quantum well structures with the same InAs thickness in a similar manner for both InAs/InGaAs and InAs/InAlAs structures. The effect of the barrier band gap on the optical transition energy is qualitatively the same for quantum well and quantum dot structures. The results demonstrate a possibility of controlling the quantum dot emission wavelength by varying the matrix composition.