Aleksandar Popović

Active moss biomonitoring for extensive screening of urban air pollution: Magnetic and chemical analyses.

In this study, active magnetic biomonitoring of moss for particulate air pollution and an assessment of heavy metals and polycyclic aromatic hydrocarbons (PAHs) were performed for the entire metropolitan area of Belgrade. Two mosses, Sphagnum girgensohnii (a species of the most recommended biomonitoring moss genus) and Hypnum cupressiforme (a common moss in the study area), were used. During the summer of 2013, moss bags were exposed at 153 sampling sites, forming a dense network of sites. A type II regression model was applied to test the interchangeable use of the two moss species. Significantly higher levels of all measured pollutants were recorded by S. girgensohnii in comparison with H. cupressiforme. Based on the results, the mosses could not be interchangeably used in urban areas, except for the biomonitoring of Cu. Nevertheless, according to the relative accumulation factors obtained for both moss species, similar city zones related to high, moderate and low levels of air pollution were distinguished. Moreover, new pollution hotspots, omitted by regulatory monitoring, were identified. The results demonstrate that moss magnetic analysis represents an effective first step for obtaining an overview of particulate air pollution before more expensive chemical analyses. Active moss biomonitoring could be applied as a pragmatic approach for optimizing the representativeness of regulatory monitoring networks.

Residential heating contribution to level of air pollutants (PAHs, major, trace, and rare earth elements): a moss bag case study

In areas with moderate to continental climates, emissions from residential heating system lead to the winter air pollution peaks. The EU legislation requires only the monitoring of airborne concentrations of particulate matter, As, Cd, Hg, Ni, and B[a]P. Transition metals and rare earth elements (REEs) have also arisen questions about their detrimental health effects. In that sense, this study examined the level of extensive set of air pollutants: 16 polycyclic aromatic hydrocarbons (PAHs), and 41 major elements, trace elements, and REEs using Sphagnum girgensohnii moss bag technique. During the winter of 2013/2014, the moss bags were exposed across Belgrade (Serbia) to study the influence of residential heating system to the overall air quality. The study was set as an extension to our previous survey during the summer, i.e., non-heating season. Markedly higher concentrations of all PAHs, Sb, Cu, V, Ni, and Zn were observed in the exposed moss in comparison to the initial values. The patterns of the moss REE concentrations normalized to North American Shale Composite and Post-Archean Australian Shales were identical across the study area but enhanced by anthropogenic activities. The results clearly demonstrate the seasonal variations in the moss enrichment of the air pollutants. Moreover, the results point out a need for monitoring of air quality during the whole year, and also of various pollutants, not only those regulated by the EU Directive.

Moss bag biomonitoring of airborne toxic element decrease on a small scale: A street study in Belgrade, Serbia.

A database of potentially hazardous substances, necessary for estimating the exposure of humans to air pollutants, may be deficient because of a limited number of regulatory monitoring stations. This study was inspired by undeniably harmful effects of human long-term exposure to intense traffic emissions in urban area. Moss bag biomonitors were used to characterize spatial variation of airborne toxic elements near crossroads and two- and one-lane streets. The Sphagnum girgensohnii and Hypnum cupressiforme moss bags were exposed for 10 weeks to 48 sampling sites across Belgrade (Serbia) during the summer of 2014. In addition, oven-drying pretreatment of the moss bags was tested. During the experimental period, traffic flows were estimated at each site by counting the number of vehicles during the rush hours. The concentrations of 39 elements were determined in the moss samples. There was no significant difference between the results obtained for nontreated and oven-dried moss bags. For the majority of elements, the moss bags identified a common pattern of decrease in the concentration from crossroads to two- and one-lane streets. The exposed moss bags were enriched with Sb, Cu and Cr. The correlation coefficients (r=0.65-0.70) between the moss concentrations of Cr, Cu, Fe and Sb and the site-counted traffic flows also confirmed a dependence of the airborne element content on traffic emissions. A strong correlation with traffic flows makes Sb, Cu and Cr reliable traffic tracers.

Comparison of single extraction procedures and the application of an index for the assessment of heavy metal bioavailability in river sediments

Metals in sediments are present in different chemical forms which affect their ability to transfer. The objective of this body of work was to compare different extraction methods for the bioavailability evaluation of some elements, such as Ba, Cd, Co, Cr, Cu, Fe, K, Mg, Mn, Ni, Pb, V and Zn from Serbian river sediments. A bioavailability risk assessment index (BRAI) was used for the quantification of heavy metal bioavailability in the sediments. Actual and potential element availability was assessed by single extractions with mild (CaCl2 and CH3COONH4) and acidic (CH3COOH) extractants and complexing agents (EDTA). Aqua regia extraction was used for the determination of the pseudo-total element content in river sediments. In different single extraction tests, higher extraction of Cd, Cu, Zn and Pb was observed than for the other elements. The results of the single extraction tests revealed that there is a considerable chance of metal leaching from the sediments assessed in this study. When the BRAI was applied, the results showed a high risk of heavy metal bioavailability in Serbian river sediments.

Synthesis and characterization of a new type of levan-graft-polystyrene copolymer.

Novel macromolecular graft copolymers were synthesized by reaction of the hydroxyl groups of the microbial polysaccharide levan, produced using Bacillus licheniformis, with polystyrene (Lev-g-PS). Synthesis was performed by the free radical reaction using potassium persulfate (PPS) as initiator. The prepared copolymer was characterized by FTIR, SEM, TG/DTA, XRD and (13)C NMR. The influence of the different conditions (reaction temperature, air or nitrogen atmosphere, reaction time, type of amines and ascorbic acid (AA) concentration) on the grafting reaction was investigated. Results showed that maximum percentage of grafting (58.1%) was achieved at a reaction temperature 70°C, in a nitrogen atmosphere and using dimethylethanolamine (DMEA) as the amine activator. On the basis of the obtained results, the likely reaction mechanism was proposed. Synthesized copolymers have better thermal stability in comparison with their initial components. Copolymers such as Lev-g-PS could potentially have many applications, such as compatibilizers and material for membranes.

Trace and Major Elements in Ash of “Nikola Tesla A” Power Plant Dump (I)—Leached Concentrations and Environmental Implications

Eight samples each of coal ash taken from active, currently filled, and passive, previously filled cassettes of “Nikola Tesla A” power plant dump (Obrenovac near Belgrade, Serbia) were subjected to a sequential extraction, comprising of the following five phases: distilled water, 1 M ammonium acetate, 0.2 M ammonium oxalate/0.2 M oxalic acid, acidic solution of H2O2, and 6 M solution of HCl. Leached concentrations were discussed from the standpoint of their environmental significance, keeping in mind the processes occurring during and after coal ash transport to the dump, as well as the concentrations washed from the original filter lignite ash.

The first survey of airborne trace elements at airport using moss bag technique

Air traffic represents an important way of social mobility in the world, and many ongoing discussions are related to the impacts that air transportation has on local air quality. In this study, moss Sphagnum girgensohnii was used for the first time in the assessment of trace element content at the international airport. The moss bags were exposed during the summer of 2013 at four sampling sites at the airport ‘Nikola Tesla’ (Belgrade, Serbia): runway (two), auxiliary runway and parking lot. According to the relative accumulation factor (RAF) and the limit of quantification of the moss bag technique (LOQT), the most abundant elements in the samples were Zn, Na, Cr, V, Cu and Fe. A comparison between the element concentrations at the airport and the corresponding values in different land use classes (urban central, suburban, industrial and green zones) across the city of Belgrade did not point out that the air traffic and associated activities significantly contribute to the trace element air pollution. This study emphasised an easy operational and robust (bio)monitoring, using moss bags as a suitable method for assessment of air quality within various microenvironments with restriction in positioning referent instrumental devices.

Estimation of Cadmium uptake by tobacco plants from laboratory leaching tests

ABSTRACT The objective of the present study was to determine the impact of cadmium (Cd) concentration in the soil on its uptake by tobacco plants, and to compare the ability of diverse extraction procedures for determining Cd bioavailability and predicting soil-to-plant transfer and Cd plant concentrations. The pseudo-total digestion procedure, modified Tessier sequential extraction and six standard single-extraction tests for estimation of metal mobility and bioavailability were used for the leaching of Cd from a native soil, as well as samples artificially contaminated over a wide range of Cd concentrations. The results of various leaching tests were compared between each other, as well as with the amounts of Cd taken up by tobacco plants in pot experiments. In the native soil sample, most of the Cd was found in fractions not readily available under natural conditions, but with increasing pollution level, Cd amounts in readily available forms increased. With increasing concentrations of Cd in the soil, the quantity of pollutant taken up in tobacco also increased, while the transfer factor (TF) decreased. Linear and non-linear empirical models were developed for predicting the uptake of Cd by tobacco plants based on the results of selected leaching tests. The non-linear equations for ISO 14870 (diethylenetriaminepentaacetic acid extraction – DTPA), ISO/TS 21268-2 (CaCl2 leaching procedure), US EPA 1311 (toxicity characteristic leaching procedure – TCLP) single step extractions, and the sum of the first two fractions of the sequential extraction, exhibited the best correlation with the experimentally determined concentrations of Cd in plants over the entire range of pollutant concentrations. This approach can improve and facilitate the assessment of human exposure to Cd by tobacco smoking, but may also have wider applicability in predicting soil-to-plant transfer.

Integrated approach to environmental pollution investigation – Spatial and temporal patterns of potentially toxic elements and magnetic particles in vineyard through the entire grapevine season

An integrated approach to the investigation of potentially toxic elements (PTEs) was applied to the soil and grapevine leaf samples collected from vineyard environment through the grapevine season. To investigate mobile and bioavailable concentrations of PTEs, six single extraction procedures and pseudo-total digestion were applied to the samples. The element concentrations in the samples were measured using inductively coupled plasma-optical emission spectrometry (ICP-OES) and inductively coupled plasma-mass spectrometry (ICP-MS). To assess atmospheric particle deposition, saturation isothermal remanent magnetisation (SIRM) was applied to the leaf samples. The obtained PTE concentrations in samples were used for calculating various ecological implications in the vineyard environment. The notable environmental pollution implications were estimated for As, B, Cd, Co, Cr, Cu, Mn, Ni and Sr. The environmental risk (RI) of the elements soluble under low-acid conditions influenced soil bioavailability risk. The most bioavailable elements from soil to leaves were Mn, Ni and Sr, followed by Cr and Cu. Cadmium and Co were strongly-bonded in the soil and were not bioavailable. The most suitable extractants for assessing bioavailability in the soil-leaf system were chelating agent Na2EDTA, and weak salt solutions CaCl2 and NH4NO3. The biological accumulation concentrations (BACs) of B, Ba, Cd, Co, Ni and Zn were decreasing in the leaves through the grapevine growing phases, that is contributed to the decreasing agrochemical application through the season. The BACs of Co, Cr, Sb and Pb, in July (veraison), were higher than in other phases, which indicate anthropogenic activities. According to correlations between biogeochemical index (BGI) and BAC, Cu and Na were mostly bioaccumulated from soil to leaves due to agrochemical applications, while bioaccumulation of B, Cd, Sb and Sr could be influenced by the other anthropogenic sources. Significant correlations between PTE concentrations and SIRM imply that leaves indicate Co, Cr and Ni air pollution in the vineyard environment.

Ranking and similarity of conventional, microwave and ultrasound element sequential extraction methods

This study aims to compare three extraction techniques of four sequential element extraction steps from soil and sediment samples that were taken from the location of the Pančevo petrochemical industry (Serbia). Elements were extracted using three different techniques: conventional, microwave and ultrasound extraction. A novel procedure - sum of the ranking differences (SRD) - was able to rank the techniques and elements, to see whether this method is a suitable tool to reveal the similarities and dissimilarities in element extraction techniques, provided that a proper ranking reference is available. The concentrations of the following elements Al, Ba, Ca, Cd, Co, Cr, Cu, Fe, K, Mg, Mn, Na, Ni, Pb, Si, Sn, Sr, V and Zn were determined through ICP OES. The different efficiencies and recovery values of element concentrations using each of the three extraction techniques were examined by the CRM BCR-701. By using SRD, we obtained a better separation between the different extraction techniques and steps when we rank their differences among the samples while lower separation was obtained according to analysed elements. Appling this method for ordering the elements could be useful for three purposes: (i) to find possible associations among the elements; (ii) to find possible elements that have outlier concentrations or (iii) detect differences in geochemical origin or behaviour of elements. Cross-validation of the SRD values in combination with cluster and principal component analysis revealed the same groups of extraction steps and techniques.