Amandine Racaud

Wavelength-tunable ultraviolet photodissociation (UVPD) of heparin-derived disaccharides in a linear ion trap.

A set of three heparin-derived disaccharide deprotonated ions was isolated in a linear ion trap and subjected to UV laser irradiation in the 220–290 nm wavelength range. The dissociation yields of the deprotonated molecular ions were recorded as a function of laser wavelength. They revealed maximum absorption at 220 nm for the nonsulfated disaccharide, but centered at 240 nm for the sulfated species. The comparison of the fragmentation patterns between ultraviolet photodissociation (UVPD) at 240 nm and CID modes showed roughly the same distribution of fragment ions resulting from glycosidic bond cleavages. Interestingly, UVPD favored additional cross ring cleavages of A and X type ion series enabling easier sulfate group location. It also reduced small neutral losses (H2O).

Photoinduced dissociation of heparin-derived oligosaccharides controlled by charge location.

The development of strategies based on mass spectrometry to help for deep structural analysis of acidic oligosaccharides remains topical. We thus examined the dissociation behavior of deprotonated ions of heparin-derived di- to tetra-saccharides under UV irradiation at 220 nm. Depending on the ionization state of the carboxylic groups, an oxidized species issued from electron photodetachment was observed in complement to photoinduced fragmentation of precursor ions. The influence of the charge location in the oligosaccharide dianions on the balance between photodissociation and electron photodetachment is examined and a way to direct the relaxation pathways, (i.e., dissociation versus electron detachment), is proposed using sodium adducts. The oxidized species was subjected to activated-electron photodetachment (activated-EPD) leading to complementary informative fragment ions to those issued from photodissociation. Directed photoinduced dissociation at 220 nm and activated-EPD should complement the more conventional CAD and IRMPD activation modes for deeper structural analysis of acidic oligosaccharides-derived anions.

Rapid analysis of lubricants by atmospheric solid analysis probe-ion mobility mass spectrometry.

Formulated lubricants are complex mixtures composed of base oil(s) and additives with various functions (detergents, corrosion inhibiter, antioxidant, viscosity modifiers, etc.). Because of the aliphatic nature of base oil and the chemical diversity of additives, the characterization of lubricant is currently a long and complex process. The comprehensive analysis of lubricant samples involves several techniques such as nuclear magnetic resonance, mass spectrometry, chromatography and infrared spectroscopy. The coupling of atmospheric solid analysis probe (ASAP) with ion mobility-mass spectrometry (IM-MS) has been shown to be an efficient tool for the characterization of complex mixture containing vaporizable polar to non-polar compounds. This approach affords the coupling of a direct ionization technique that does not require sample preparation, with a bi-dimensional separation method with high peak capacity. In this work, we show that ASAP-IM-MS is a suitable method for rapid and direct characterization of lubricant samples. Indeed, base oil and additives yielded, by ASAP, ions series which could be separated by IM-MS. Molecular additives such as Zn-dithiocarbamate, phosphite, thiophosphate and Alkyl diphenylamine were ionized as molecular ions [M](+•) or protonated molecules [M + H](+), depending of their polarity. In some cases, fragment ions were observed, confirming the additive identification. In addition, high molecular weight polymeric additives such as poly(alkyl methacrylate) (PAM) were pyrolized in the ASAP source leading to characteristic fragment ions. ASAP-IM-MS is shown to be a powerful tool for studying complex mixtures, allowing the first comprehensive analysis of lubricants in just a few minutes.

Rapid analysis of lubricants by atmospheric solid analysis probe-ion mobility mass spectrometry

Formulated lubricants are complex mixtures composed of base oil(s) and additives with various functions (detergents, corrosion inhibiter, antioxidant, viscosity modifiers, etc.). Because of the aliphatic nature of base oil and the chemical diversity of additives, the characterization of lubricant is currently a long and complex process. The comprehensive analysis of lubricant samples involves several techniques such as nuclear magnetic resonance, mass spectrometry, chromatography and infrared spectroscopy. The coupling of atmospheric solid analysis probe (ASAP) with ion mobility-mass spectrometry (IM-MS) has been shown to be an efficient tool for the characterization of complex mixture containing vaporizable polar to non-polar compounds. This approach affords the coupling of a direct ionization technique that does not require sample preparation, with a bi-dimensional separation method with high peak capacity. In this work, we show that ASAP-IM-MS is a suitable method for rapid and direct characterization of lubricant samples. Indeed, base oil and additives yielded, by ASAP, ions series which could be separated by IM-MS. Molecular additives such as Zn-dithiocarbamate, phosphite, thiophosphate and Alkyl diphenylamine were ionized as molecular ions [M](+•) or protonated molecules [M + H](+), depending of their polarity. In some cases, fragment ions were observed, confirming the additive identification. In addition, high molecular weight polymeric additives such as poly(alkyl methacrylate) (PAM) were pyrolized in the ASAP source leading to characteristic fragment ions. ASAP-IM-MS is shown to be a powerful tool for studying complex mixtures, allowing the first comprehensive analysis of lubricants in just a few minutes.

Photodissociation pathways and lifetimes of protonated peptides and their dimers

Photodissociation lifetimes and fragment channels of gas-phase, protonated YA(n) (n = 1,2) peptides and their dimers were measured with 266 nm photons. The protonated monomers were found to have a fast dissociation channel with an exponential lifetime of ~200 ns while the protonated dimers show an additional slow dissociation component with a lifetime of ~2 μs. Laser power dependence measurements enabled us to ascribe the fast channel in the monomer and the slow channel in the dimer to a one-photon process, whereas the fast dimer channel is from a two-photon process. The slow (1 photon) dissociation channel in the dimer was found to result in cleavage of the H-bonds after energy transfer through these H-bonds. In general, the dissociation of these protonated peptides is non-prompt and the decay time was found to increase with the size of the peptides. Quantum RRKM calculations of the microcanonical rate constants also confirmed a statistical nature of the photodissociation processes in the dipeptide monomers and dimers. The classical RRKM expression gives a rate constant as an analytical function of the number of active vibrational modes in the system, estimated separately on the basis of the equipartition theorem. It demonstrates encouraging results in predicting fragmentation lifetimes of protonated peptides. Finally, we present the first experimental evidence for a photo-induced conversion of tyrosine-containing peptides into monocyclic aromatic hydrocarbon along with a formamide molecule both found in space.

Optical properties of a visible push-pull chromophore covalently bound to carbohydrates: solution and gas-phase spectroscopy combined to theoretical investigations.

The use of visible absorbing and fluorescent tags for sensing and structural analysis of carbohydrates is a promising route in a variety of medical, diagnostic, and therapeutic contexts. Here we report an easy method for covalent attachment of nonfluorescent push-pull chromophores based on the 4-cyano-5-dicyanomethylene-2-oxo-3-pyrroline ring to carbohydrate moieties. The impact of sugar grafting on the optical properties of the push-pull chromophore in the gas phase and in solution was investigated by absorption and action spectroscopy and theoretical methods. The labeled sugars efficiently absorb photons in the visible range, as demonstrated by their intense photodissociation in a quadrupole ion trap. A strong blue shift (-70 nm) of the gas-phase photodissociation intensity maximum is observed upon sugar grafting, whereas no such effect is visible on the solution absorption spectra. Molecular dynamics simulations of labeled maltose in the gas phase describe strong interactions between the sulfonated chromophore and the carbohydrate, which lead to cyclic conformations. These are not observed in the simulations with explicit solvation. Time-dependent density functional theory (TD-DFT) calculations on model molecules permit us to attribute the observed shift to the formation of such cyclic conformations and to the displacement of the negative charge relative to the aromatic moiety of the chromophore.

Atmospheric Solid Analysis Probe Coupled to Ion Mobility Spectrometry-Mass Spectrometry, a Fast and Simple Method for Polyalphaolefin Characterization

AbstractPolyalphaolefins (PAOs) are polymers produced from linear alpha olefins through catalytic oligomerization processes. The PAOs are known as synthetic high-performance base stock fluids used to improve the efficiency of many other synthetic products. In this study, we report the direct characterization of PAOs using atmospheric solid analysis probe (ASAP) coupled with ion mobility spectrometry-mass spectrometry (IMS-MS). We studied different PAOs grades exhibiting low- and high-viscosity index. Specific adjustments of the ASAP source parameters permitted the monitoring of ionization processes as three mechanisms could occur for these compounds: hydride abstraction, nitrogen addition, and/or the formation of [M−2H]+• ions. Several series of fragment ions were obtained, which allowed the identification of the alpha olefin used to synthesize the PAO. The use of the ion mobility separation dimension provides information on isomeric species. In addition, the drift time versus m/z plots permitted rapid comparison between PAO samples and to evidence their complexity. These 2D plots appear as fingerprints of PAO samples. To conclude, the resort to ASAP-IMS-MS provides a rapid characterization of the PAO samples in a direct analysis approach, without any sample preparation. Graphical Abstractᅟ