André Augusto Franco Marques

Biocompatibility Evaluation of Epiphany/Resilon Root Canal Filling System in Subcutaneous Tissue of Rats

INTRODUCTION The purpose of this study was to evaluate the biocompatibility of the root canal filling system Epiphany/Resilon in connective tissue of rats. METHODS Fifteen rats were used, separated into 3 groups in accordance with its period of death (7, 21, 42 days). Four filled dentin tubes were implanted with the tested materials as follows: ERSP group, Epiphany/Resilon with Self-etch Primer; ER group, Epiphany/Resilon without primer; EG group, Endofill/gutta-percha points; and ET group, empty tube. After 7, 21, and 42 days, animals were killed, obtaining 5 samples per group. A grade from I-IV was used to graduate the inflammatory reaction. RESULTS Results showed that Epiphany/Resilon (ERSP and ER groups) induced a slight (II) inflammatory reaction after 42 days. However, in ER group, in which the self-etch primer was not applied, severe (IV) to moderate (III) inflammatory reactions were observed between 7 and 21 days. When compared with the EG and ET groups, it was observed that these groups presented tissue reaction ranging from slight (II, 7 and 21 days) to no inflammation (I, 42 days). CONCLUSIONS Epiphany/Resilon root canal filling system presented satisfactory tissue reaction. It was biocompatible when tested in connective tissue of rats.

Evaluation of marginal leakage of different temporary restorative materials in Endodontics

Aim: The aim of this study is to assess the coronal marginal leakage of three temporary restorative materials used for root canal sealing after endodontic treatment. Materials and Methods: A total of 88 single-rooted teeth were submitted to biomechanical preparation and filled by lateral condensation technique. After obturation process, the teeth were randomly separated into four groups, being two teeth of each group used as positive and negative control. Temporary sealing was performed as follows: GI - Clip F (VOCO); GII - Bioplic (Biodinβmica); GIII - Vitremer (3M ESPE) and GIV - Ketak N100 (3M ESPE). Next, the specimens were immersed into Indian ink for 30 and 60- days, being 10 specimens for each time interval and then submitted to diaphanization to verify the amount of coronal leakage using a measuring microscope. Results: Leakage mean values within the 30-day period were as follows: Vitremer (0.3 mm), Ketak N100 and Clip F (0.6 mm) and Bioplic (1.7 mm). Within the 60-day period, leakage means were 1.1 mm, 1.5 mm, 2.2 mm and 2.6 mm, respectively. Conclusions: None of the materials was capable of preventing marginal leakage within the 30- and 60-day period. In both time intervals, Bioplic presented the highest mean of leakage and Vitremer the lowest.

Morphometrical analysis of cleaning capacity of a hybrid instrumentation in mesial flattened root canals

The cleaning capacity of hybrid and rotary instrumentation techniques in mesial flattened canals of mandibular first molars was evaluated by morphometrical analysis in this study. Twenty human mandibular first molars were randomly assigned into two groups, according to instrumentation technique, as follows: group 1, instrumentation with ProTaper Starter Kit (Dentsply/Maillefer) rotary system; group 2, manual instrumentation using K files (Dentsply/Maillefer) by crown-down technique in middle and apical thirds, cervical preparation with Gates-Glidden #1 and #2 (Dentsply/Maillefer) burs, and to finalise the preparation, ProTaper F2 and F3 rotary files. Serial transverse cross-sections (5 µm) of the apical third, stained with hematoxylin and eosin, were analysed at 100× original magnification. The images were submitted to morphometrical analysis with an integration grid to determine the percentage of root canal area with debris. Statiscal analysis (t-Student, P < 0.05) showed significant difference between the techniques (P < 0.05), although neither completely cleaned the root canal.

Apical Transportation, Centering Ability, and Cleaning Effectiveness of Reciprocating Single-file System Associated with Different Glide Path Techniques.

INTRODUCTION The aim of this study was to evaluate the apical transportation, the centering ability, and the cleaning effectiveness of a reciprocating single-file system associated to different glide path techniques. METHODS The mesial root canals of 52 mandibular molars were randomly distributed into 4 groups (n = 13) according to the different glide path techniques used before biomechanical preparation with Reciproc System (RS): KF/RS (sizes 10 and 15 K-files), NGP/RS (no glide path, only reciprocating system), PF/RS (sizes 13, 16, and 19 PathFile instruments), and NP (no preparation). Cone-beam computed tomography analysis was performed before and after instrumentation for apical third images acquisition. Apical transportation and its direction were evaluated by using the formula D = (X1 - X2) - (Y1 - Y2), and the centering ability was analyzed by the formula CC = (X1 - X2/Y1 - Y2 or Y1 - Y2/X1 - X2). The samples were submitted to histologic processing and analyzed under a digital microscope for debris quantification. The values were statistically analyzed (Kruskal-Wallis, the Dunn multiple comparisons test, P < .05). RESULTS All groups had similar apical transportation values, with no significant difference among them (P > .05). Groups had a tendency toward transportation in the mesial direction. No technique had perfect centering ability (=1.0), with no significant difference among them. KF/RS had larger amount of debris, with statistically significant difference in comparison with NGP/RS (P > .05). CONCLUSIONS The different glide path techniques promoted minimal apical transportation, and the reciprocating single-file system tested remained relatively centralized within the root canal. Also, the different techniques interfered in the cleaning effectiveness of the reciprocating system.

Root canal retreatment using reciprocating and continuous rotary nickel-titanium instruments.

Objective: The complete filling material removal during endodontic retreatment is a clinical procedure difficult to achieve. The aim of this study was to evaluate the efficacy of reciprocating and continuous rotary nickel-titanium instruments used in root canal retreatment. Materials and Methods: Forty freshly extracted human premolars were cleaned and shaped by the crown-down technique, followed by filling by the lateral compaction technique. The teeth were randomly separated into two groups ( n = 20), according to the system used for filling material removal: G1 - Reciproc and G2 - ProTaper Universal Retreatment System. The teeth were photographed under operating microscope at ×8 magnification; and the total area of the root canal and remaining filling material were quantified. Results: No statistically significant difference ( P > 0.05) in residual filling material was observed between groups; however, the time required for filling removal was significantly shorter for Reciproc system ( P Conclusions: It was observed remaining filling material in all teeth, irrespective of the system used; however, root canal retreatment was faster when reciprocating motion was used.Objective: The complete filling material removal during endodontic retreatment is a clinical procedure difficult to achieve. The aim of this study was to evaluate the efficacy of reciprocating and continuous rotary nickel-titanium instruments used in root canal retreatment. Materials and Methods: Forty freshly extracted human premolars were cleaned and shaped by the crown-down technique, followed by filling by the lateral compaction technique. The teeth were randomly separated into two groups (n = 20), according to the system used for filling material removal: G1 - Reciproc and G2 - ProTaper Universal Retreatment System. The teeth were photographed under operating microscope at ×8 magnification; and the total area of the root canal and remaining filling material were quantified. Results: No statistically significant difference (P > 0.05) in residual filling material was observed between groups; however, the time required for filling removal was significantly shorter for Reciproc system (P < 0.05). Conclusions: It was observed remaining filling material in all teeth, irrespective of the system used; however, root canal retreatment was faster when reciprocating motion was used.

Cleaning capacity promoted by motor-driven or manual instrumentation using ProTaper Universal system: Histological analysis

Aim: The aim of this study was to assess the cleaning capacity of the Protaper system using motor-driven or manual instrumentation. Materials and Methods: Ten mandibular molars were randomly separated into 2 groups (n = 5) according to the type of instrumentation performed, as follows: Group 1 - instrumentation with rotary nickel-titanium (Ni-Ti) files using ProTaper Universal System (Dentsply/Maillefer); and, Group 2 - instrumentation with Ni-Ti hand files using ProTaper Universal (Dentsply-Maillefer). Afterwards, the teeth were sectioned transversely and submitted to histotechnical processing to obtain histological sections for microscopic evaluation. The images were analyzed by the Corel Photo-Paint X5 program (Corel Corporation) using an integration grid superimposed on the image. Results: Statistical analysis (U-Mann-Whitney - P < 0.05) demonstrated that G1 presented higher cleaning capacity when compared to G2. Conclusions: The rotary technique presented better cleaning results in the apical third of the root canal system when compared to the manual technique.

Histological evaluation of the cleaning effectiveness of two reciprocating single-file systems in severely curved root canals: Reciproc versus WaveOne.

Objective: The aim of this study was to evaluate the cleaning effectiveness achieved with two reciprocating single-file systems in severely curved root canals: Reciproc and WaveOne. Materials and Methods: Twenty-five mesial roots of mandibular molars were randomly separated into two groups, according to the instrumentation system used. The negative control group consisted of five specimens that were not instrumented. The mesial canals (buccal and lingual) in Reciproc Group were instrumented with file R25 and the WaveOne group with the Primary file. The samples were submitted to histological processing and analyzed under a digital microscope. Results: The WaveOne group presented a larger amount of debris than the Reciproc Group, however, without statistically significant difference (P > 0.05). A larger amount of debris in the control group was observed, with statistically significant difference to Reciproc and WaveOne groups (P < 0.05). Conclusions: The two reciprocating single-file instrumentation systems presented similar effectiveness for root canal cleaning.

Endodontic treatment of mandibular molar with root dilaceration using Reciproc single-file system

Biomechanical preparation of root canals with accentuated curvature is challenging. New rotatory systems, such as Reciproc, require a shorter period of time to prepare curved canals, and became a viable alternative for endodontic treatment of teeth with root dilaceration. Thus, this study aimed to report a clinical case of endodontic therapy of root with accentuated dilaceration using Reciproc single-file system. Mandibular right second molar was diagnosed as asymptomatic irreversible pulpitis. Pulp chamber access was performed, and glide path was created with #10 K-file (Dentsply Maillefer) and PathFile #13, #16 and #19 (Dentsply Maillefer) up to the temporary working length. The working length measured corresponded to 20 mm in the mesio-buccal and mesio-lingual canals, and 22 mm in the distal canal. The R25 file (VDW GmbH) was used in all the canals for instrumentation and final preparation, followed by filling with Reciproc gutta-percha cones (VDW GmbH) and AH Plus sealer (Dentsply Maillefer), using thermal compaction technique. The case has been receiving follow-up for 6 mon and no painful symptomatology or periapical lesions have been found. Despite the difficulties, the treatment could be performed in a shorter period of time than the conventional methods.

Effect of passive ultrasonic agitation during final irrigation on cleaning capacity of hybrid instrumentation

Objectives To evaluate the effect of passive ultrasonic agitation on the cleaning capacity of a hybrid instrumentation technique. Materials and Methods Twenty mandibular incisors with mesiodistal-flattened root shape had their crowns sectioned at 1 mm from the cementoenamel junction. Instrumentation was initiated by catheterization with K-type files (Denstply Maillefer) #10, #15, and #20 at 3 mm from the working length. Cervical preparation was performed with Largo bur #1 (Dentsply Maillefer) followed by apical instrumentation with K-type files #15, #20 and #25, and finishing with ProTaper F2 file (Denstply Maillefer). All files were used up to the working length under irrigation with 1 mL of 2.5% sodium hypochlorite (Biodynâmica) at each instrument change. At the end of instrumentation, the roots were randomly separated into 2 groups (n = 10). All specimens received final irrigation with 1 mL of 2.5% sodium hypochlorite. The solution remained in the root canals in Group 1 for one minute; and ultrasonic agitation was performed in Group 2 for one minute using a straight tip inserted at 1 mm from working length. The specimens were processed histologically and the sections were analyzed under optic microscope (×64) to quantify debris present in the root canal. Results The samples submitted to ultrasonic agitation (Group 2) presented significant decrease in the amount of debris in comparison with those of Group 1 (p < 0.05). Conclusions The hybrid instrumentation technique associated with passive ultrasonic agitation promoted greater debris removal in the apical third of the root canals.

Effect of ultrasonic tip designs on intraradicular post removal

Objectives To evaluate the effect of different ultrasonic tip designs on intraradicular post removal. Materials and Methods The crowns of forty human canine teeth were removed, and after biomechanical preparation and filling, the roots were embedded in acrylic resin blocks. The post spaces were made, and root canal molding was performed with self-cured acrylic resin. After casting (Cu-Al), the posts were cemented with zinc phosphate cement. The specimens were randomly separated into 4 groups (n = 10), as follows: G1 - no ultrasonic vibration (control); G2 - ultrasonic vibration using an elongated cylindrical-shaped and active rounded tip; G3 - ultrasonic vibration with a flattened convex and linear active tip; G4 - ultrasonic vibration with active semicircular tapered tip. Ultrasonic vibration was applied for 15 seconds on each post surface and tensile test was performed in a Universal Testing Machine (Instron 4444 - 1 mm/min). Results G4 presented the highest mean values, however, with no statistically significant difference in comparison to G3 (P > 0.05). G2 presented the lowest mean values with statistically significant difference to G3 and G4 (P < 0.05). Conclusions Ultrasonic vibration with elongated cylindrical-shaped and active rounded tip was most effective in reducing force required for intraradicular post removal.