Andreas B. Dahlin

Label-free plasmonic detection of biomolecular binding by a single gold nanorod.

We report the use of individual gold nanorods as plasmonic transducers to detect the binding of streptavidin to individual biotin-conjugated nanorods in real time on a surface. Label-free detection at the single-nanorod level was performed by tracking the wavelength shift of the nanorod-localized surface plasmon resonant scattering spectrum using a dark-field microspectroscopy system. The lowest streptavidin concentration that was experimentally measured was 1 nM, which is a factor of 1000-fold lower than the previously reported detection limit for streptavidin binding by biotinylated single plasmonic nanostructures. We believe that the current optical setup is able to reliably measure wavelength shifts as small as 0.3 nm. Binding of streptavidin at 1 nM concentration induces a mean resonant wavelength shift of 0.59 nm suggesting that we are currently operating at close to the limit of detection of the system.

Locally Functionalized Short-Range Ordered Nanoplasmonic Pores for Bioanalytical Sensing

Nanoplasmonic sensors based on short-range ordered nanoholes in thin metal films and discrete metal nanoparticles are known to provide similar sensing performance. However, a perforated metal film is unique in the sense that the holes can be designed to penetrate through the substrate, thereby also fulfilling the role of nanofluidic channels. This paper presents a bioanalytical sensing concept based on short-range ordered nanoplasmonic pores (diameter 150 nm) penetrating through a thin (around 250 nm) multilayer membrane composed of gold and silicon nitride (SiN) that is supported on a Si wafer. Also, a fabrication scheme that enables parallel production of multiple (more than 50) separate sensor chips or more than 1000 separate nanoplasmonic membranes on a single wafer is presented. Together with the localization of the sensitivity to within such short-range ordered nanoholes, the structure provides a two-dimensional nanofluidic network, sized in the order of 100 x 100 microm(2), with nanoplasmon active regions localized to each individual nanochannel. A material-specific surface-modification scheme was developed to promote specific binding of target molecules on the optically active gold regions only, while suppressing nonspecific adsorption on SiN. Using this protocol, and by monitoring the temporal variation in the plasmon resonance of the structure, we demonstrate flow-through nanoplasmonic sensing of specific biorecognition reactions with a signal-to-noise ratio of around 50 at a temporal resolution below 190 ms. With flow, the uptake was demonstrated to be at least 1 order of magnitude faster than under stagnant conditions, while still keeping the sample consumption at a minimum.

High-Resolution Microspectroscopy of Plasmonic Nanostructures for Miniaturized Biosensing

In this article, we demonstrate how to perform microscale spectroscopy of plasmonic nanostructures in order to minimize the noise when determining the resonance peak wavelength. This is accomplished using an experimental setup containing standard optical components mounted on an ordinary light microscope. We present a detailed comparison between extinction spectroscopy in transmission mode and scattering spectroscopy under dark field illumination, which shows that extinction measurements provide higher signal-to-noise in almost all situations. Furthermore, it is shown that rational selection of nanostructure, hardware components, and data analysis algorithms enables tracking of the particle plasmon resonance wavelength from a 10 microm x 50 microm area with a resolution of 10(-3) nm in transmission mode. We investigate how the temporal resolution, which can be improved down to 17 ms, affects the noise characteristics. In addition, we show how data can be acquired from an area as small as 2 microm x 10 microm (approximately 240 particles) at the expense of higher noise on longer time scales. In comparison with previous work on macroscopic sensor designs, this represents a sensor miniaturization of 5 orders of magnitude, without any loss in signal-to-noise performance. As a model system, we illustrate biomolecular detection using gold nanodisks prepared by colloidal lithography. The microextinction measurements of nanodisks described here provide detection of protein surface coverages as low as 40 pg/cm(2) (<0.1% of saturated binding). In fact, the miniaturized system provides a detection limit in terms of surface coverage comparable to state of the art macroscopic sensors, while simultaneously being as close to single protein molecule detection as sensors based on a single nanoparticle.

Electrochemistry on a Localized Surface Plasmon Resonance Sensor

The optical signal of a localized surface plasmon resonance (LSPR)-based sensor combined with electrochemistry was investigated. Gold nanoparticles were immobilized on an indium tin oxide (ITO) substrate, which functioned as working electrode. Using cyclic voltammetry synchronized with LSPR sensing, surface reactions on gold were detected both electrically and optically. In the capacitive charging regime, optical signals linear to the applied potential were detected. Gold was found to be dissolved above the oxidation potential and partially redeposited during the reduction, which changed size and conformation of the gold nanoparticles. In kinetic measurements, slower potential establishment was observed at lower salt concentrations. Simulations by multiple multipole program (MMP) suggested the formation of a lossy layer by combination of charge depletion of gold and negative ion adsorption even below the reaction potential. We consider the results presented here of importance for any future sensors based on combined plasmonics and electrochemistry.

Electrochemical plasmonic sensors

The enormous progress of nanotechnology during the last decade has made it possible to fabricate a great variety of nanostructures. On the nanoscale, metals exhibit special electrical and optical properties, which can be utilized for novel applications. In particular, plasmonic sensors including both the established technique of surface plasmon resonance and more recent nanoplasmonic sensors, have recently attracted much attention. However, some of the simplest and most successful sensors, such as the glucose biosensor, are based on electrical readout. In this review we describe the implementation of electrochemistry with plasmonic nanostructures for combined electrical and optical signal transduction. We highlight results from different types of metallic nanostructures such as nanoparticles, nanowires, nanoholes or simply films of nanoscale thickness. We briefly give an overview of their optical properties and discuss implementation of electrochemical methods. In particular, we review studies on how electrochemical potentials influence the plasmon resonances in different nanostructures, as this type of fundamental understanding is necessary for successful combination of the methods. Although several combined platforms exist, many are not yet in use as sensors partly because of the complicated effects from electrochemical potentials on plasmon resonances. Yet, there are clearly promising aspects of these sensor combinations and we conclude this review by discussing the advantages of synchronized electrical and optical readout, illustrating the versatility of these technologies.

Plasmon Enhanced Internal Photoemission in Antenna-Spacer-Mirror Based Au/TiO2 Nanostructures

Emission of photoexcited hot electrons from plasmonic metal nanostructures to semiconductors is key to a number of proposed nanophotonics technologies for solar harvesting, water splitting, photocatalysis, and a variety of optical sensing and photodetector applications. Favorable materials and catalytic properties make systems based on gold and TiO2 particularly interesting, but the internal photoemission efficiency for visible light is low because of the wide bandgap of the semiconductor. We investigated the incident photon-to-electron conversion efficiency of thin TiO2 films decorated with Au nanodisk antennas in an electrochemical circuit and found that incorporation of a Au mirror beneath the semiconductor amplified the photoresponse for light with wavelength λ = 500-950 nm by a factor 2-10 compared to identical structures lacking the mirror component. Classical electrodynamics simulations showed that the enhancement effect is caused by a favorable interplay between localized surface plasmon excitations and cavity modes that together amplify the light absorption in the Au/TiO2 interface. The experimentally determined internal quantum efficiency for hot electron transfer decreases monotonically with wavelength, similar to the probability for interband excitations with energy higher than the Schottky barrier obtained from a density functional theory band structure simulation of a thin Au/TiO2 slab.

Synchronized Quartz Crystal Microbalance and Nanoplasmonic Sensing of Biomolecular Recognition Reactions

We present a method providing synchronized measurements using the two techniques: quartz crystal microbalance with dissipation (QCM-D) monitoring and localized surface plasmon resonance (LSPR). This was achieved by letting a thin gold film perforated with short-ranged ordered plasmon-active nanoholes act as one of the electrodes of a QCM-D crystal. This enabled transmission-mode optical spectroscopy to be used to temporally resolve colorimetric changes of the LSPR active substrate induced upon biomolecular binding events. The LSPR response could thus be compared with simultaneously obtained changes in resonance frequency, Deltaf, and energy dissipation, DeltaD, of the QCM-D device. Since the LSPR technique is preferentially sensitive to changes within the voids of the nanoholes, while the QCM-D technique is preferentially sensitive to reactions on the planar region between the holes, a surface chemistry providing the same binding kinetics on both gold and silica was used. This was achieved by coating the substrate with poly(L-lysine)-graft-poly(ethylene glycol) (PLL-g-PEG), which was shown to bind in the same manner on silica and gold modified with a carboxyl-terminated thiol. In this way, the combined setup provided new information about structural changes upon PLL-g-PEG adsorption. We also demonstrate subsequent binding of NeutrAvidin and an immunoreaction utilizing biotin-modified IgG. The combined information from the synchronized measurements was also used in a new way to estimate the sensing volume of the LSPR sensor.

Size Matters: Problems and Advantages Associated with Highly Miniaturized Sensors

There is no doubt that the recent advances in nanotechnology have made it possible to realize a great variety of new sensors with signal transduction mechanisms utilizing physical phenomena at the nanoscale. Some examples are conductivity measurements in nanowires, deflection of cantilevers and spectroscopy of plasmonic nanoparticles. The fact that these techniques are based on the special properties of nanostructural entities provides for extreme sensor miniaturization since a single structural unit often can be used as transducer. This review discusses the advantages and problems with such small sensors, with focus on biosensing applications and label-free real-time analysis of liquid samples. Many aspects of sensor design are considered, such as thermodynamic and diffusion aspects on binding kinetics as well as multiplexing and noise issues. Still, all issues discussed are generic in the sense that the conclusions apply to practically all types of surface sensitive techniques. As a counterweight to the current research trend, it is argued that in many real world applications, better performance is achieved if the active sensor is larger than that in typical nanosensors. Although there are certain specific sensing applications where nanoscale transducers are necessary, it is argued herein that this represents a relatively rare situation. Instead, it is suggested that sensing on the microscale often offers a good compromise between utilizing some possible advantages of miniaturization while avoiding the complications. This means that ensemble measurements on multiple nanoscale sensors are preferable instead of utilizing a single transducer entity.

Nanoplasmonic sensing of metal–halide complex formation and the electric double layer capacitor

Many nanotechnological devices are based on implementing electrochemistry with plasmonic nanostructures, but these systems are challenging to understand. We present a detailed study of the influence of electrochemical potentials on plasmon resonances, in the absence of surface coatings and redox active molecules, by synchronized voltammetry and spectroscopy. The experiments are performed on gold nanodisks and nanohole arrays in thin gold films, which are fabricated by improved methods. New insights are provided by high resolution spectroscopy and variable scan rates. Furthermore, we introduce new analytical models in order to understand the spectral changes quantitatively. In contrast to most previous literature, we find that the plasmonic signal is caused almost entirely by the formation of ionic complexes on the metal surface, most likely gold chloride in this study. The refractometric sensing effect from the ions in the electric double layer can be fully neglected, and the charging of the metal gives a surprisingly small effect for these systems. Our conclusions are consistent for both localized nanoparticle plasmons and propagating surface plasmons. We consider the results in this work especially important in the context of combined electrochemical and optical sensors.

Promises and Challenges of Nanoplasmonic Devices for Refractometric Biosensing

Abstract Optical biosensors based on surface plasmon resonance (SPR) in metallic thin films are currently standard tools for measuring molecular binding kinetics and affinities – an important task for biophysical studies and pharmaceutical development. Motivated by recent progress in the design and fabrication of metallic nanostructures, such as nanoparticles or nanoholes of various shapes, researchers have been pursuing a new generation of biosensors harnessing tailored plasmonic effects in these engineered nanostructures. Nanoplasmonic devices, while demanding nanofabrication, offer tunability with respect to sensor dimension and physical properties, thereby enabling novel biological interfacing opportunities and extreme miniaturization. Here we provide an integrated overview of refractometric biosensing with nanoplasmonic devices and highlight some recent examples of nanoplasmonic sensors capable of unique functions that are difficult to accomplish with conventional SPR. For example, since the local field strength and spatial distribution can be readily tuned by varying the shape and arrangement of nanostructures, biomolecular interactions can be controlled to occur in regions of high field strength. This may improve signal-to-noise and also enable sensing a small number of molecules. Furthermore, the nanoscale plasmonic sensor elements may, in combination with nanofabrication and materials-selective surface-modifications, make it possible to merge affinity biosensing with nanofluidic liquid handling.