Andrey Y. Khalimon

Diversity of Catalysis by an Imido-Hydrido Complex of Molybdenum. Mechanism of Carbonyl Hydrosilylation and Silane Alcoholysis

New Imido hydride complex 1 catalyzes a variety of silylation reactions that proceed via initial substrate activation but not silane addition.

Nickel‐Catalyzed Direct Carboxylation of Olefins with CO2: One‐Pot Synthesis of α,β‐Unsaturated Carboxylic Acid Salts

The nickel-catalyzed direct carboxylation of alkenes with the cheap and abundantly available C1 building block carbon dioxide (CO2 ) in the presence of a base has been achieved. The one-pot reaction allows for the direct and selective synthesis of a wide range of α,β-unsaturated carboxylates (TON>100, TOF up to 6 h(-1) , TON=turnover number, TOF=turnover frequency). Thus, it is possible, in one step, to synthesize sodium acrylate from ethylene, CO2 , and a sodium salt. Acrylates are industrially important products, the synthesis of which has hitherto required multiple steps.

Mechanistic Aspects of Hydrosilylation Catalyzed by (ArN=)Mo(H)(Cl)(PMe3)3

The reaction of (ArN=)MoCl(2)(PMe(3))(3) (Ar = 2,6-diisopropylphenyl) with L-Selectride gives the hydrido-chloride complex (ArN=)Mo(H)(Cl)(PMe(3))(3) (2). Complex 2 was found to catalyze the hydrosilylation of carbonyls and nitriles as well as the dehydrogenative silylation of alcohols and water. Compound 2 does not show any productive reaction with PhSiH(3); however, a slow H/D exchange and formation of (ArN=)Mo(D)(Cl)(PMe(3))(3) (2(D)) was observed upon addition of PhSiD(3). Reactivity of 2 toward organic substrates was studied. Stoichiometric reactions of 2 with benzaldehyde and cyclohexanone start with dissociation of the trans-to-hydride PMe(3) ligand followed by coordination and insertion of carbonyls into the Mo-H bond to form alkoxy derivatives (ArN=)Mo(Cl)(OR)(PMe(2))L(2) (3: R = OCH(2)Ph, L(2) = 2 PMe(3); 5: R = OCH(2)Ph, L(2) = η(2)-PhC(O)H; 6: R = OCy, L(2) = 2 PMe(3)). The latter species reacts with PhSiH(3) to furnish the corresponding silyl ethers and to recover the hydride 2. An analogous mechanism was suggested for the dehydrogenative ethanolysis with PhSiH(3), with the key intermediate being the ethoxy complex (ArN=)Mo(Cl)(OEt)(PMe(3))(3) (7). In the case of hydrosilylation of acetophenone, a D-labeling experiment, i.e., a reaction of 2 with acetophenone and PhSiD(3) in the 1:1:1 ratio, suggests an alternative mechanism that does not involve the intermediacy of an alkoxy complex. In this particular case, the reaction presumably proceeds via Lewis acid catalysis. Similar to the case of benzaldehyde, treatment of 2 with styrene gives trans-(ArN=)Mo(H)(η(2)-CH(2)═CHPh)(PMe(3))(2) (8). Complex 8 slowly decomposes via the release of ethylbenzene, indicating only a slow insertion of styrene ligand into the Mo-H bond of 8.

An unexpected mechanism of hydrosilylation by a silyl hydride complex of molybdenum.

Carbonyl hydrosilylation catalyzed by (ArN)Mo(H)(SiH(2)Ph)(PMe(3))(3) (3) is unusual in that it does not involve the expected Si-O elimination from intermediate (ArN)Mo(SiH(2)Ph)(O(i)Pr)(PMe(3))(2) (7). Instead, 7 reversibly transfers β-CH hydrogen from the alkoxide ligand to metal.

Agostic NSiH⋅⋅⋅Mo Complexes: From Curiosity to Catalysis

2a,b with a d configuration (Scheme 1). Bonding in these species can be represented by two canonical forms (B and C ; Scheme 1), one of which has a silanimine character (C). This fact suggests that 1 and 2a,b could serve as intermediates for silanimine complexes, which, although very scarce, are known to exhibit a wealth of reactivity. Herein, we describe the preparation, structure, and reactivity of a new agostic silylamido complex, 3. For the first time, we report the catalytic and stoichiometric reactions of such a complex and provide evidence for the intermediacy of a silanimine complex. The reaction of bis(imido) compound (ArN)2Mo(PMe3)3 (Ar= 2,6-diisopropylphenyl) with two equivalents of PhSiH3 leads to a product of double silane addition, the b-agostic NSi H···Mo complex 3 [Eq. (1)]. The structure of 3 is fluxional at room temperature, but at 223 K the H NMR spectrum shows an up-field signal characteristic of the proton of an agostic Si Ha moiety at d = 4.35 ppm (brm), which is coupled to a signal assigned to the terminal Si H proton at d = 6.03 ppm (d, JH,H = 5.4 Hz). The diastereotopic protons

Synthesis and Molecular and Electronic Structure of an Unusual Paramagnetic Borohydride Complex Mo(NAr)2(PMe3)2(η2-BH4)†

Reaction of Mo(NAr)2Cl2(DME) (Ar=2,6-C6H3iPr2, DME=1,2-dimethoxyethane) with NaBH4 and PMe3 in THF formed the paramagnetic Mo(V) d1 borohydride complex Mo(NAr)2(PMe3)2(eta2-BH4) (1). Compound 1, which was characterized by EPR spectroscopy and X-ray diffraction analysis, provides a rare example both of a paramagnetic bis(imido) group 6 compound and a structurally characterized molybdenum borohydride complex. Density functional theory calculations were used to determine the electronic structure and bonding parameters of 1 and showed that it is best viewed as a 19 valence electron compound (having a primarily metal-based SOMO) in which the BH4- ligand behaves as a sigma-only, 2-electron donor.

A photo Lewis acid generator (PhLAG): controlled photorelease of B(C6F5)3.

A molecule that releases the strong organometallic Lewis acid B(C(6)F(5))(3) upon irradiation with 254 nm light has been developed. This photo Lewis acid generator (PhLAG) now enables the photocontrolled initiation of several reactions catalyzed by this important Lewis acid. Herein is described the synthesis of the triphenylsulfonium salt of a carbamato borate based on a carbazole function, its establishment as a PhLAG, and the application of the photorelease of B(C(6)F(5))(3) to the fabrication of thin films of a polysiloxane material.

Imido–hydrido complexes of Mo(IV): catalysis and mechanistic aspects of hydroboration reactions

Imido-hydrido complexes (ArN)Mo(H)(Cl)(PMe3)3 (1) and (ArN)Mo(H)2(PMe3)3 (2) (Ar = 2,6-diisopropylphenyl) catalyse a variety of hydroboration reactions, including the rare examples of addition of HBCat to nitriles to form bis(borylated) amines RCH2N(BCat)2. Stoichiometric reactivity of complexes 1 and 2 with nitriles and HBCat suggest that catalytic reactions proceed via a series of agostic borylamido and borylamino complexes. For complex 1, catalysis starts with addition of nitriles across the Mo-H bond to give (ArN)Mo(Cl)(N[double bond, length as m-dash]CHR)(PMe3)2; whereas for complex 2 stoichiometric reactions suggest initial addition of HBCat to form the agostic complex Mo(H)2(PMe3)3(η(3)-NAr-HBcat) (16).

Multiple coupling of silanes with imido complexes of Mo.

The bis(imido) complexes ((t)BuN[double bond, length as m-dash])2Mo(PMe3)(L) (L = PMe3, C2H4) react with up to three equivalents of silane PhSiH3 to give the imido-bridged disilyl silyl Mo(vi) complex ((t)BuN){μ-(t)BuN(SiHPh)2}Mo(H)(SiH2Ph)(PMe3)2 (3) studied by NMR, IR and X-ray diffraction. NMR data supported by DFT calculations show that complex 3 is an unusual example of a silyl hydride of Mo(VI), without significant SiH interaction. Mechanistic NMR studies revealed that silane addition proceeds in a stepwise manner via a series of Si-H∙∙∙M agostic and silanimine complexes whose structures were further elucidated by DFT calculations.

Photo Lewis Acid Generators: Photorelease of B(C6F5)3 and Applications to Catalysis.

A series of molecules capable of releasing of the strong organometallic Lewis acid B(C6F5)3 upon exposure to 254 nm light have been developed. These photo Lewis acid generators (PhLAGs) can now serve as photoinitiators for several important B(C6F5)3-catalyzed reactions. Herein is described the synthesis of the triphenylsulfonium and diphenyliodonium salts of carbamato- and hydridoborates, their establishment as PhLAGs, and studies aimed at defining the mechanism of borane release. Factors affecting these photolytic reactions and the application of this concept to photoinduced hydrosilylation reactions and construction of siloxane scaffolds are also discussed.