Angela Santilio

Multiresidue analysis of organochlorine and pyrethroid pesticides in ground beef meat by gas chromatography-mass spectrometry

A multiresidue method was developed and optimized for the identification/quantification of organochlorine pesticides (OCPs) and pyrethroids (PYRs) in beef meat samples. Samples extraction was performed by an automated solvent extractor and the extracts were cleaned-up by a tandem-cartridge system consisting of an Extrelut NT3 combined with a Sep-Pack C18 cartridge and a florisil minicartridge. Analysis was finally carried out by gas chromatography coupled with quadrupole mass spectrometry (GC/MS). The performance of the method was investigated in terms of linearity, accuracy, precision, detection limit (LOD) and quantification limit (LOQ). Good linearity was obtained, with correlation coefficients (r2) higher than 0.98. Mean recoveries were found in the ranges 70–110 % and 84–99 % for the investigated OCPs and PYRs, respectively, with the exception of extremely volatile hexachlorobenzene (HCB). RSD% turned out to range from 2 to 15 %. LOQ values were in the range 0.005–0.1 mg/kg for either class of compounds. The method developed was successfully tested on 50 commercial beef meat samples from the market area of Rome (Italy), proving to be a useful tool in routine multiresidue analysis of OCPs and PYRs for monitoring purposes. None of the compounds of interest were observed above their respective LOQ.

Application of solid-phase partition cartridges in the determination of fungicide residues in vegetable samples

Disposable, ready-to-use cartridges filled with a macroporous diatomaceous material are used to extract in a single step fungicide residues with dichloromethane from aqueous acetone extracts of vegetables. This procedure takes the place of some functions (such as separating funnel partition, drying over anhydrous sodium sulphate and clean-up) usually performed by separate steps in classical schemes. Fourteen fungicides (dichloran, vinclozolin, chlorthalonil, triadimefon, dichlofluanide, procymidone, hexaconazole, captan, folpet, ditalimfos, iprodione, captafol, pyrazophos and fenarimol) were determined using the described procedure with recoveries between 83 and 107% at spiking levels ranging for the different compounds from 0.04 to 0.40 mg/kg. Crops subjected to the described procedure included lettuce, strawberry, apple, yellow pepper and peach, and gave extracts containing a mass of co-extractives between 5 and 30 mg. Compared with classical schemes, the described procedure is simple, less labour intensive, allows parallel handling of several extracts and does not require preparation and maintenance of equipment. Troublesome emulsions such as those frequently observed in separating funnel partitioning do not occur.

Solid-matrix partition for separation of organochlorine pesticide residues from fatty materials

A fast, single step and efficient partition between n-hexane and acetonitrile on ready-to-use, disposable cartridges of Kieselghur-type material has been developed for the separation of organochlorine (OC) pesticide residues from oils and fats. The extract is cleaned up with Florisil minocolumn chromatography, followed by a solid-matrix sulphuric acid treatment. Carry-over of lipid material through the partition step is lower comapared to conventional, separatory-funnel partition. Recovery of eighteen OC pesticides from 1.0 g olive oil was between 72% and 104% at spiking levels between 0.01 and 0.15 mg/kg for the different compounds.

Simultaneous quantitative determination of thirteen urea pesticides at sub-ppb levels on a Zorbax SB-C18 column

A simple multi-residue method is described for simultaneously determining ten urea and three benzoylurea pesticides residues in drinking water with quantitation limits below the European regulatory limit of 0.1 microgram/l. The residues were extracted from drinking water with dichloromethane and analysed by HPLC on a Zorbax 5 microns SB-C18 column with diode array detection (DAD) at 240 nm. Recoveries were determined by spiking drinking water with 13 pesticides (benzthiazuron, metoxuron, monuron, fluometuron, isoproturon, diuron, linuron, chloroxuron, chlorbromuron, diflubenzuron, neburon, triflumuron and flucycloxuron) at the 0.05-0.50 microgram/l level.

Determination of acidic herbicides in cereals by QuEChERS extraction and LC/MS/MS.

A simple and rapid method has been studied for the determination of acidic herbicides (2,4-D, Dichlorprop, Dichlorprop-p, Fluazifop, Fluroxypyr, MCPA, Mecoprop and Mecoprop-p) on cereals (rye). The method involves an alkaline hydrolysis with sodium hydroxide in order to release covalently bound compounds, prior to QuEChERS extraction, followed by neutralization and analysis via liquid chromatography-double mass spectrometry LC/MS/MS. The performance of the method either with or without alkaline hydrolysis was studied in terms of recovery rates and limit of quantification (LOQ). In either case, recoveries were determined at four spiking levels (0.02 mg/kg, 0.05 mg/kg, 0.1 mg/kg and 0.5 mg/kg) with 5 replicates for each level. Mean recoveries ranged from 90 to 120 %, whereas relative standard deviations (RSD %) proved to be less than 20 %. Quantitative analysis was carried out by the internal standard (Nicarbazin) and the LC/MS/MS analysis was performed in electrospray ionisation (ESI) negative mode using a Zorbax XCB Eclipse column. The developed method was applied to the analysis of several cereals commercially available like as rye flour, oat meal, oat flakes and dehusked oat. Residue levels were found below the limit of quantification (LOQ) of the method. The method has been tested in EU Proficiency Tests for cereals with good results.

Fast determination of phenoxy acid herbicides in carrots and apples using liquid chromatography coupled triple quadrupole mass spectrometry

A fast, simple and inexpensive method has been developed for the analysis of phenoxy acid herbicides: 2,4-dichlorophenoxyacetic acid (2,4-D), 4-chloro-2-methylphenoxyacetic acid (MCPA), 2-(4-chloro-o-tolyloxy)propionic acid (MCPP), 2-(4-aryloxyphenoxy)propionic acid (Fluazifop) and 2-(4-aryloxyphenoxy)propionic acid (Haloxyfop) in carrots and apples by liquid chromatography coupled to triple quadrupole mass spectrometry (LC/MS/MS). The compounds were analyzed by QuEChERS (quick, easy, cheap, effective, rugged, safe) methodology without cleanup. The recoveries were performed at two spiked levels (0.05 and 0.5 mg/kg) for both matrices with six replicates for each level. The mean recoveries ranged from 70–92% for both apples and carrots. The precision of the method expressed as relative standard deviation (RSD%) was found to be in the range 3–15%. For all compounds, good linearity (r2 > 0.99) was obtained over the range of concentration from 0.05 μ g/mL to 0.5 μ g/mL, corresponding to the pesticide concentrations of 0.05 mg/kg and 0.5 mg/kg, respectively. The determination limits (LOQs) ranged from 0.01 ng/mL to 1.3 ng/mL in solvent, whereas, the LOQs calculated in matrix ranged from 0.05 ng/g to 21.0 ng/g for apples and from 0.06 ng/g to 10.2 ng/g for carrots. The developed methodology combines the advantages of both QuEChERS and LC/MS/MS producing a very rapid, sensitive and cheap method useful for the routine analytical laboratories.

Vertical Mobility of Soil Contaminants: Preliminary Results of a Survey on the Herbicide Atrazine

Abstract Atrazine is considered a potential contaminant of water bodies, where it has been repeatedly detected. Its use in Italy is almost limited to the Northern part of the country where corn monocultures are common. Northern Italy is characterized by the presence of an area with soil quite permeable and where ground waters are often present at not very deep levels. In this area well waters, which represent the main source of drinking water, have been frequently found contaminated by atrazine. A program has been started aimed at studying the role of soil nature and local factors in the process of groundwater contamination. Two atrazine application rates were used at two sites with loamy and loamy-sandy soils. Results clearly show a different mobility of atrazine in the two soil types. Since the two sites have similar organic carbon levels, the major proportion of clay to sand and the lower pH of loamy soil may explain the lower vertical mobility of atrazine in this soil. Work is in progress to study atr...

Estimation of the validation parameters for a fast analysis of herbicide residues by LC-MS/MS

Due to strict regulatory requirements for pesticide residue analysis, only the results of residue analysis with acceptable quality should be reported. As a consequence proper validation of the measurement method is required. In this context, accuracy, precision, specificity, limit of determination (LOQ), matrix effect, linearity, uncertainty calculation and ruggedness become increasingly important. This paper reports a description of the validation parameters of a fast method for the determination of five phenoxy acid herbicides (2,4-D, MCPA, MCPP, haloxyfop and fluazifop) in food crops. The recoveries were performed in the concentration range from 0.05 to 0.5 mg kg–1 for apples, pears, carrots and celeriac with five replicates at each level. The mean recoveries ranged from 70% to 95% for all crops. The precision of the method expressed as a relative standard deviation (RSD%) was found to be in the range 3–14%. For all herbicides, the linearity response of the detector was tested by correlation coefficients (r2 > 0.99) in the concentration range from 0.05 to 0.5 mg kg–1. The LOQ was determined as the lowest spiked level meeting the requirement of accuracy (70–120%) and precision (RSD% < 20% according to European Union guidelines. The uncertainty and robustness were calculated. On the basis of the results, the method can be considered fast, simple and robust and is suitable to be applied to the analysis of studied herbicides in routine testing laboratories.

Screening for coumatetralyl in soft drinks by solid-matrix extraction and high-performance liquid chromatography with diode-array detection.

A method was developed for the rapid determination coumatetralyl in cola- and orange-type soft drinks, which includes extraction using solid-matrix column, clean-up by silica cartridge chromatography and reversed-phase high-performance liquid chromatography with diode-array detection. The recovery of coumatetralyl from 50 ml of soft drinks was better than 80% at spiking levels down to 50 micrograms/kg (ppb).

Determination of dimethyl fumarate (DMFu) in silica gel pouches using gas chromatography coupled ion trap mass spectrometry

A simple method for the determination of dimethyl fumarate (DMFu) in silica gel pouches has been developed. The gas chromatographic behaviour of DMFu was investigated; the instrumental method, based on EI mass spectrometry coupled with an Ion Trap Detector operating whether in full scan mode or in MS/MS mode was also investigated. Several factors have been evaluated and optimized during the development process: solvent and temperature of extraction, type of stationary phase in capillary column. The analytical procedure consists of two steps as follows: (a) the sample preparation using 10 g of sample extracted with acetonitrile in an ultrasonic, heated bath and (b) the determination by gas chromatography-ion trap mass spectrometry. Mass spectrometry in conjunction with chromatographic separation is a very powerful combination for identification of an analyte in the extract in spite of selective detectors employed with GC, such as ECD, FPD and NPD, that offer only limited specificity. Blank samples show no interfering peaks in the areas of interest, so the specificity of the method was assured under the investigated GC/MS conditions. The method has been validated in terms of recovery, repeatability, linearity, detection limits and measurement uncertainty. The results obtained meet both the method validation criteria and requirements of the European/National legislation. The method was verified to be accurate with 97 % mean recoveries at 0.05 mg/kg and 1.00 mg/kg levels; the repeatability (expressed as RSD %) was found to be better than 15 %. Good linearity was found in the range between 0.05 μg/mL and 5.0 μg/mL and a value of R2> 0.9998 was calculated. The procedure ensures high specificity and a good sensitivity with detection limit (ld) of 0.02 mg/kg and quantification limit (LOQ) of 0.05 mg/kg. This procedure has been successfully applied for the analysis of several hundred of real samples collected during a monitoring control plan started last year in our country. All samples exceeding the maximum allowed level of DMFu (0, 1 mg/kg) were confirmed by GC/MS/MS (ITD) for a higher degree of confidence in identification. The main advantages of this method include: rapidity, simplicity (few, simple steps), reliability, cheapness, no need for long and difficult clean-up and evaporation steps, high specificity by using GC/MS and GC/MS/MS, availability for routine monitoring.