Annemarie L. Exarhos

Ultrafast spectral migration of photoluminescence in graphene oxide.

We use subpicosecond time-resolved photoluminescence measurements to study the nature of photoluminescence in graphene oxide and reduced graphene oxide. Our data indicate that, in contrast to prior suggestions, the photoluminescence spectra of graphene oxide and reduced graphene oxide are inhomogeneously broadened. We observe substantial energy redistribution and relaxation among the emitting states within the first few picoseconds, leading to a progressive red shift of the emission spectrum. Blue shifts that arise in time-integrated spectra upon photothermal reduction are easily understood within this dynamical context without invoking a modified distribution of dipole-coupled states. Rather, reduction increases the nonradiative electron-hole recombination rate and curtails the red-shifting process, which is consistent with an increase in quenching through the introduction of larger and/or more numerous sp(2) clusters. Polarization memory measurements show energetic signatures of electron-hole correlations, established on a subpicosecond time scale and developing little thereafter.

Highly Conductive Single-Walled Carbon Nanotube Thin Film Preparation by Direct Alignment on Substrates from Water Dispersions

A safe, scalable method for producing highly conductive aligned films of single-walled carbon nanotubes (SWNTs) from water suspensions is presented. While microfluidic assembly of SWNTs has received significant attention, achieving desirable SWNT dispersion and morphology in fluids without an insulating surfactant or toxic superacid is challenging. We present a method that uniquely produces a noncorrosive ink that can be directly applied to a device in situ, which is different from previous fabrication techniques. Functionalized SWNTs (f-SWNTs) are dispersed in an aqueous urea solution to leverage binding between the amine group of urea and the carboxylic acid group of f-SWNTs and obtain urea-SWNT. Compared with SWNTs dispersed using conventional methods (e.g., superacid and surfactants), the dispersed urea-SWNT aggregates have a higher aspect ratio with a rodlike morphology as measured by light scattering. The Mayer rod technique is used to prepare urea-SWNT, highly aligned films (two-dimensional nematic order parameter of 0.6, 5 μm spot size, via polarized Raman) with resistance values as low as 15-1700 Ω/sq in a transmittance range of 2-80% at 550 nm. These values compete with the best literature values for conductivity of SWNT-enabled thin films. The findings offer promising opportunities for industrial applications relying on highly conductive thin SWNT films.

Direct torsional actuation of microcantilevers using magnetic excitation

Torsional mode dynamic force microscopy can be used for a wide range of studies including mapping lateral contact stiffness, torsional frequency or amplitude modulation imaging, and dynamic friction measurements of various materials. Piezo-actuation of the cantilever is commonly used, but it introduces spurious resonances, limiting the frequency range that can be sampled, and rendering the technique particularly difficult to apply in liquid medium where the cantilever oscillations are significantly damped. Here, we demonstrate a method that enables direct torsional actuation of cantilevers with high uniformity over wide frequency ranges by attaching a micrometer-scale magnetic bead on the back side of the cantilever. We show that when beads are magnetized along the width of the cantilever, efficient torsional actuation of the cantilevers can be achieved using a magnetic field produced from a solenoid placed underneath the sample. We demonstrate the capability of this technique by imaging atomic steps on graphite surfaces in tapping mode near the first torsional resonance of the cantilever in dodecane. The technique is also applied to map the variations in the lateral contact stiffness on the surface of graphite and polydiacetylene monolayers.

Birefringent Stable Glass with Predominantly Isotropic Molecular Orientation

Birefringence in stable glasses produced by physical vapor deposition often implies molecular alignment similar to liquid crystals. As such, it remains unclear whether these glasses share the same energy landscape as liquid-quenched glasses that have been aged for millions of years. Here, we produce stable glasses of 9-(3,5-di(naphthalen-1-yl)phenyl)anthracene molecules that retain three-dimensional shapes and do not preferentially align in a specific direction. Using a combination of angle- and polarization-dependent photoluminescence and ellipsometry experiments, we show that these stable glasses possess a predominantly isotropic molecular orientation while being optically birefringent. The intrinsic birefringence strongly correlates with increased density, showing that molecular ordering is not required to produce stable glasses or optical birefringence, and provides important insights into the process of stable glass formation via surface-mediated equilibration. To our knowledge, such novel amorphous packing has never been reported in the past.