Antonela Ninčević Grassino

Ultrasound assisted extraction and characterization of pectin from tomato waste

Pectin was extracted from tomato waste using two different extraction methods to assess its potential utilization as an alternative source of commercial pectin production. Tomato waste was treated with ammonium oxalate/oxalic acid by conventional extraction (CE), under reflux and ultrasound assisted extraction (UAE) at 37 kHz and temperatures of 60 °C and 80 °C. The pectin obtained from these methods was analysed and compared in terms of yield, chemical properties and structure. Among examined methods, CE at 60 °C resulted with the highest yield, but UAE during 15 min of sonication produced the pectin of better quality (anhydrouronic acid, methoxy and calcium pectate contents and degree of esterification). NMR and FTIR spectroscopy of isolated pectins revealed predominantly esterified structure, irrespective of extraction conditions. The comparison of the pectin yields obtained after extraction at 80 °C, indicate that similar values were found at times of 24h and 15 min for CE and UAE, respectively. According to obtained results it can be concluded that main advantage of UAE is considerable shortening of extraction procedure with strong emphasis on environmental friendly processing approach. Therefore, these results suggested that UAE could be used as an efficient technique for the extraction of pectin from tomato waste and by-products.

Corrosion inhibition with different protective layers in tinplate cans for food preservation.

BACKGROUND In this work the influence of essential onion oil (EOO) on the protection of tinplates was compared with dioctyl sebacate oil (DOS) and epoxy phenolic lacquers, which are frequently used in the food canning industry. RESULTS When EOO as the protective layer instead of DOS oil was used, tinplate porosity, measured electrochemically (7.58 ± 1.97 µA cm(-2) and 23.0 ± 1.3 µA cm(-2), respectively), and iron coating mass, calculated from AAS data (1.52 ± 0.15 mg m(-2) and 3.14 ± 0.42, respectively), was much lower indicating better corrosion protection. At higher storing temperature (36 °C) the addition of EOO to canned tomato purée enhanced the formation of hydrogen with time. The increasing volume fraction of H(2) (from 34.0 to 90.9% for cans without nitrates, and from 33.8 to 89.2% for cans with nitrates) is an indicator that corrosion takes place. CONCLUSION As the use of EOO improves the protection of tinplate compared with DOS oil, and is almost as effective as epoxy phenolic lacquer, the addition of EOO can be recommended due to lower cost of canned food production and enhanced organoleptic properties, but the storage temperature has to be lower then 36 °C.

Analytical tools used for the identification and quantification of pectin extracted from plant food matrices, wastes and by-products: A review

Pectin is the methylated ester of polygalacturonic acid and has a wide range of applications. It can be used in food and animal feed as well as in pharmaceutical and cosmetic products. Pectin is traditionally used as a gelling agent in fruit-based products, as a stabilizer in some fruit juices and milk drinks and fruit filling for bakery and confectionary products, but their potential applications differ according to their chemical composition. Therefore, at this stage of development, it is of a great importance to find fast, reliable methods to not only identify and quantify pectin, but also to determine its chemical structure and composition when it is extracted from plant matrices, wastes and by-products. The present review will focus on the analytical tools used to identify and quantify the amount of pectin obtained from plant matrices, wastes and by-products as well as determining its chemical and structural composition.