Arun K. Upadhyay

Protein recovery from inclusion bodies of Escherichia coli using mild solubilization process

Formation of inclusion bodies in bacterial hosts poses a major challenge for large scale recovery of bioactive proteins. The process of obtaining bioactive protein from inclusion bodies is labor intensive and the yields of recombinant protein are often low. Here we review the developments in the field that are targeted at improving the yield, as well as quality of the recombinant protein by optimizing the individual steps of the process, especially solubilization of the inclusion bodies and refolding of the solubilized protein. Mild solubilization methods have been discussed which are based on the understanding of the fact that protein molecules in inclusion body aggregates have native-like structure. These methods solubilize the inclusion body aggregates while preserving the native-like protein structure. Subsequent protein refolding and purification results in high recovery of bioactive protein. Other parameters which influence the overall recovery of bioactive protein from inclusion bodies have also been discussed. A schematic model describing the utility of mild solubilization methods for high throughput recovery of bioactive protein has also been presented.

Kinetics of Inclusion Body Formation and Its Correlation with the Characteristics of Protein Aggregates in Escherichia coli

The objective of the research was to understand the structural determinants governing protein aggregation into inclusion bodies during expression of recombinant proteins in Escherichia coli. Recombinant human growth hormone (hGH) and asparaginase were expressed as inclusion bodies in E.coli and the kinetics of aggregate formation was analyzed in details. Asparaginase inclusion bodies were of smaller size (200 nm) and the size of the aggregates did not increase with induction time. In contrast, the seeding and growth behavior of hGH inclusion bodies were found to be sequential, kinetically stable and the aggregate size increased from 200 to 800 nm with induction time. Human growth hormone inclusion bodies showed higher resistance to denaturants and proteinase K degradation in comparison to those of asparaginase inclusion bodies. Asparaginase inclusion bodies were completely solubilized at 2–3 M urea concentration and could be refolded into active protein, whereas 7 M urea was required for complete solubilization of hGH inclusion bodies. Both hGH and asparaginase inclusion bodies showed binding with amyloid specific dyes. In spite of its low β-sheet content, binding with dyes was more prominent in case of hGH inclusion bodies than that of asparaginase. Arrangements of protein molecules present in the surface as well as in the core of inclusion bodies were similar. Hydrophobic interactions between partially folded amphiphillic and hydrophobic alpha-helices were found to be one of the main determinants of hGH inclusion body formation. Aggregation behavior of the protein molecules decides the nature and properties of inclusion bodies.

Solubilization of inclusion body proteins using n-propanol and its refolding into bioactive form.

Inclusion bodies of recombinant human growth hormone (r-hGH) were isolated from Escherichia coli, enriched and solubilized in 100mM Tris buffer containing 6M n-propanol and 2M urea. Around 4 mg/ml of r-hGH from inclusion bodies were solubilized in 6M n-propanol-based buffer containing 2M urea. Existence of native-like secondary structure of r-hGH in 6M n-propanol solution was confirmed by CD and fluorescence spectra. Solubilized r-hGH was subsequently refolded by pulsatile dilution, purified to homogeneity and found to be functionally active. Tris buffer containing 6M n-propanol and 2M urea also effectively solubilized a number of proteins expressed as inclusion bodies in E. coli. Mild solubilization of inclusion body proteins, chaotropic effect of n-propanol at high concentration and kosmotropic effect at lower concentration helped in improved refolding of the solubilized protein. Around 40% of the r-hGH in the form of inclusion body aggregates was refolded into bioactive form while using n-propanol as solubilization agent. Solubilization with 6M n-propanol solution thus can be a viable alternative for achieving high throughput recovery of bioactive protein from inclusion bodies of E. coli.

Refolding and purification of recombinant L-asparaginase from inclusion bodies of E. coli into active tetrameric protein

A tetrameric protein of therapeutic importance, Escherichia coli L-asparaginase-II was expressed in Escherichia coli as inclusion bodies (IBs). Asparaginase IBs were solubilized using low concentration of urea and refolded into active tetrameric protein using pulsatile dilution method. Refolded asparaginase was purified in two steps by ion-exchange and gel filtration chromatographic techniques. The recovery of bioactive asparaginase from IBs was around 50%. The melting temperature (Tm) of the purified asparaginase was found to be 64°C. The specific activity of refolded, purified asparaginase was found to be comparable to the commercial asparaginase (190 IU/mg). Enzymatic activity of the refolded asparaginase was high even at four molar urea solutions, where the IB aggregates are completely solubilized. From the comparison of chemical denaturation data and activity at different concentrations of guanidine hydrochloride, it was observed that dissociation of monomeric units precedes the complete loss of helical secondary structures. Protection of the existing native-like protein structure during solubilization of IB aggregates with 4 M urea improved the propensity of monomer units to form oligomeric structure. Our mild solubilization technique retaining native-like structures, improved recovery of asparaginase in bioactive tetrameric form.

Influences of process and formulation parameters on powder flow properties and immunogenicity of spray dried polymer particles entrapping recombinant pneumococcal surface protein A

Particle size, antigen load and its release characteristic are the three the main attributes of polymer particles based vaccine delivery systems. The present studies focus on the formulation of spray dried polylactide microparticles entrapping pneumococcal surface protein A (PspA). Influence of process variables during polymer particle formation were optimized by using half-factorial design. Feed rate and atomization pressure during spray drying were found to be the most important parameters for achieving uniform size particles. Spray drying of preformed particles from different stages of solvent evaporation method resulted in formation of particle having different porosity and protein release profile. Presence of polyvinyl alcohol in the external aqueous phase not only contributed towards regulating the size of particles but also influenced the burst release of protein from particles. Polymer particles entrapping PspA elicited robust IgG responses both in mice and in rats. Antigen load in microparticles correlated with the antibody titer indicating the maintenance of protein integrity during particle formation using spray drying. Both, process engineering and formulation parameters during spray drying influenced the particles in terms of size, load and antigen release characteristics.

Delivery of polysaccharides using polymer particles: implications on size-dependent immunogenicity, opsonophagocytosis, and protective immunity.

Bacterial capsular polysaccharides are components of many modern vaccines, but they are weakly immunogenic. Herein, we describe the delivery of pneumococcal capsular polysaccharide serotype-1 (PCP-1) in polylactide polymeric particles to enhance its immunogenicity. Immunization with PCP-1-entrapped particles elicited long-term memory antibody responses from a single intramuscular injection. PCP-1-entrapped nanoparticles (NPs) elicited significantly higher anti-PCP-1 IgG responses than that observed with soluble and microparticles (MPs) formulations. Delivering PCP-1 and pneumococcal proteins in same particles did not improve the IgG response. The sera of animals immunized with PCP-1-entrapped particles promoted efficient opsonophagocytosis of pneumococci by macrophages. Single-dose immunization with PCP-1-entrapped particles conferred a long-term serotype-specific protection against lethal pneumococcal challenge. The higher immunogenicity of PCP-1 nanoparticles showed correlation with enhanced uptake by antigen-presenting cells. The results highlight the potential of polymeric nanoparticles as an efficient means of presenting polysaccharide antigens to the immune system.

Biochemical, serological and molecular confirmation of Salmonella isolates

Salmonellosis is one of the most frequently reported food-borne diseases world-wide commonly caused by Salmonella Typhimurium and Salmonella Enteritidis serovars. The present study was undertaken to confirm Salmonella isolates by various techniques. All the 94 isolates were confirmed to be S. Typhimurium through various morphological, biochemical, serological and molecular methods.