Asha A. Juwarkar

Bioreactors for treatment of VOCs and odours – A review

Volatile organic compounds (VOCs) and odorous compounds discharged into the environment create ecological and health hazards. In the recent past, biological waste air treatment processes using bioreactors have gained popularity in control of VOCs and odour, since they offer a cost effective and environment friendly alternative to conventional air pollution control technologies. This review provides an overview of the various bioreactors that are used in VOC and odour abatement, along with details on their configuration and design, mechanism of operation, insights into the microbial biodegradation process and future R&D needs in this area.

Distillery and curd whey wastes as viable alternative sources for biosurfactant production

Biosurfactant production from synthetic medium and industrial waste, viz. distillery and whey wastes was investigated by using an oily sludge isolate Pseudomonas aeruginosa strain BS2. In synthetic medium separately supplemented with glucose and hexadecane as water-soluble and -insoluble carbon sources, respectively, strain BS2 reduced the surface tension of the fermentation broth from 57 to 27 mN/m. The culture produced biosurfactant during the stationary growth phase and its yield was 0.97 g/l. The culture utilized distillery and whey wastes for its growth, as maximum cell counts reached to 54 × 108 and 64 × 109 c.f.u./ml from an initial inoculum size of 1 × 05 c.f.u./ml, respectively, within 48 h of incubation and in these wastes the yields of biosurfactant obtained were 0.91 and 0.92 g/l, respectively. In synthetic medium, distillery and whey wastes, strain BS2 produced a crystalline biosurfactant which belonged to the category of secondary metabolites and its maximum production occurred after the onset of nitrogen-limiting conditions. After recovering biosurfactant from the fermented waste, the chemical oxygen demand (COD) of distillery and whey wastes was significantly reduced by 81 and 87%, respectively. Total acids, nitrogen and phosphate levels in distillery waste were reduced by 90, 92 and 92%, respectively, while in case of whey waste the concentration of these nutrients was reduced by 88, 95 and 93%, respectively. The isolated biosurfactant possessed potent surface active properties, as it effectively reduced the surface tension of water from 72 to 27 mN/m and formed 100% stable emulsions of a variety of water-insoluble compounds such as hydrocarbons, viz. hexadecane, crude oil, kerosene and oily sludge and pesticides, viz. dichlorodiphenyltrichloroethane (DDT) and benzene hexachloride (BHC). The effectiveness of biosurfactant was also evident from its low critical micellar concentration (CMC) which was 0.028 mg/ml.

Bioaccumulation and phyto-translocation of arsenic, chromium and zinc by Jatropha curcas L.: Impact of dairy sludge and biofertilizer

The present study was planned to remediate the metalloid and metal contaminated soil by using non-edible and economic plant species Jatropha curcas L. The experiment was conducted on pots to improve the survival rate, metal tolerance and growth response of the plant on soil; having different concentrations of arsenic, chromium and zinc. The soil was amended with dairy sludge and bacterial inoculum (Azotobacter chroococcum) as biofertilizer. The results of the study showed that the bioaccumulation potential was increased with increase in metalloid and metal concentration in soil system. Application of dairy sludge significantly reduces the DTPA-extractable As, Cr and Zn concentration in soil. The application of organic amendment stabilizes the As, Cr and Zn and reduced their uptake in plant tissues.

Kinetics of biosurfactant production by Pseudomonas aeruginosa strain BS2 from industrial wastes

SummaryBatch kinetic studies were carried out on rhamnolipid biosurfactant production from synthetic medium, industrial wastes viz. distillery and whey waste as substrates. The results indicated that the specific growth rates (μ max) and specific product formation rates (V max) from both the wastes are comparatively better than the synthetic medium, revealing that both the industrial wastes (distillery and whey) can be successfully utilized as substrates for biosurfactant production.

Bioremediation of multi-metal contaminated soil using biosurfactant — a novel approach

An unconventional nutrient medium, distillery spent wash (1:3) diluted) was used to produce di-rhamnolipid biosurfactant by Pseudomonas aeruginosa strain BS2. This research further assessed the potential of the biosurfactant as a washing agent for metal removal from multimetal contaminated soil (Cr-940 ppm; Pb-900 ppm; Cd-430 ppm; Ni-880 ppm; Cu-480 ppm). Out of the treatments of contaminated soil with tap water and rhamnolipid biosurfactant, the latter was found to be potent in mobilization of metal and decontamination of contaminated soil. Within 36 hours of leaching study, di-rhamnolipid as compared to tap water facilitated 13 folds higher removal of Cr from the heavy metal spiked soil whereas removal of Pb and Cu was 9–10 and 14 folds higher respectively. Leaching of Cd and Ni was 25 folds higher from the spiked soil. This shows that leaching behavior of biosurfactant was different for different metals. The use of wastewater for production of biosurfactant and its efficient use in metal removal make it a strong applicant for bioremediation.

Adsorption—;Desorption Process Using Wood‐Based Activated Carbon for Recovery of Biosurfactant from Fermented Distillery Wastewater

Methods used for biosurfactant recovery include solvent extraction, precipitation, crystallization, centrifugation and foam fractionation. These methods cannot be used when distillery wastewater (DW) is used as the nutrient medium for biosurfactant production by Pseudomonas aeruginosa strain BS2, because recovery of biosurfactant by any of these methods imparts color to the biosurfactant. The biosurfactant has a nonaesthetic appearance with lowered surface active properties. These methods cannot be used for continuous recovery of biosurfactant during cultivation. Hence, a new downstream technique for biosurfactant recovery from fermented DW comprised of adsorption‐desorption processes using wood‐based activated carbon (WAC) was developed. This study involves batch experiments to standardize the factors affecting the rate of biosurfactant adsorption onto WAC. WAC was the most efficient adsorbent among various ones tested (i.e., silica gel, activated alumina and zeolite). The WAC (1% w v−1), equilibrium time (90 min), pH range of 5–10 and temperature of 40 °C were optimum to achieve 99.5% adsorption efficiency. Adsorption kinetics and intraparticle diffusion studies revealed the involvement of both boundary layer diffusion and intraparticle diffusion. The Langmuir adsorption isotherm of WAC indicated the formation of a monolayer coverage of the biosurfactant over a homogeneous carbon surface, while the Freundlich isotherm showed high adsorption at strong solute concentrations and low adsorption at dilute solute concentrations. WAC concentration of 4% w v−1 facilitated complete removal of the biosurfactant from collapsed foam (contained 5‐fold higher concentration of biosurfactant than was present in fermented DW). Biosurfactant adsorption was of chemisorption type. Acetone (polar solvent) was a specific viable eluant screened among various ones tested because it selectively facilitated maximum recovery, i.e., 89% biosurfactant from WAC. By acetone treatment, complete regeneration of WAC was feasible and WAC can be reused for biosurfactant recovery up to 3 cycles. The recovered biosurfactant showed improved surface‐active property (i.e., much lower critical micelle concentration value of 0.013 verses 0.028 mg mL−1 for biosurfactant recovered by classical methods). The reuse potential of WAC was assessed and results suggest that the carbon can be reused for three consecutive cycles for biosurfactant adsorption from fermented wastewater without any decrease in adsorption efficiency. Thus, this process forms a basis for continuous recovery of biosurfactant from fermented DW and concentrated foam. This process reduces the use of high cost solvent, avoids end product inhibition and minimizes product degradation.

Growth responses and metal accumulation capabilities of woody plants during the phytoremediation of tannery sludge.

Five woody plants species (i.e. Terminalia arjuna, Prosopis juliflora, Populus alba, Eucalyptus tereticornis and Dendrocalamus strictus) were selected for phytoremediation and grow on tannery sludge dumps of Common Effluent Treatment Plant (CETP), Unnao (Uttar Pradesh), India. Concentration of toxic metals were observed high in the raw tannery sludge i.e. Fe-1667>Cr-628>Zn-592>Pb-427>Cu-354>Mn-210>Cd-125>Ni-76 mg kg(-1) dw, respectively. Besides, physico-chemical properties of the raw sludge represented the toxic nature to human health and may pose numerous risks to local environment. The growth performances of woody plants were assessed in terms of various growth parameters such as height, diameter at breast height (DBH) and canopy area of plants. All the plant species have the capabilities to accumulate substantial amount of toxic metals in their tissues during the remediation. The ratio of accumulated metals in the plants were found in the order Fe>Cr>Mn>Pb>Zn>Cu>Cd>Ni and significant changes in physico-chemical parameters of tannery sludge were observed after treatment. All the woody plants indicated high bioconcentration factor for different metals in the order Fe>Cr>Mn>Ni>Cd>Pb>Zn>Cu. After one year of phytoremediation, the level of toxic metals were removed from tannery sludge up to Cr (70.22)%, Ni (59.21)%, Cd (58.4)%, Fe (49.75)%, Mn (30.95)%, Zn (22.80)%, Cu (20.46)% and Pb (14.05)%, respectively.

Assessment of bioaccumulation of heavy metals by different plant species grown on fly ash dump

A field experiment was conducted on a 10-hectare area on fly ash dump at Khaperkheda Thermal Power Plant, Nagpur, India, where different ecologically and economically important plant species were planted using bioremediation technology. The technology involves the use of organic amendment and selection of suitable plant species along with site-specific nitrogen-fixing strains of biofertilizers. The study was conducted to find out the metal accumulation potential of different plant species. The total heavy metal contents in fly ash were determined and their relative abundance was found in the order of Fe>Mn>Zn>Cu>Ni>Cr>Pb>Cd. Fly ash samples had acidic pH, low electrical conductivity, low level of organic carbon and trace amounts of N and P. Plantation of divergent species was done on fly ash dump using the bioremediation technique. After 3 years of plantation, luxuriant growth of these species was found covering almost the entire fly ash dump. The results of the metal analysis of these species indicated that iron accumulated to the greatest extent in vegetation followed by Mn, Ni, Zn, Cu, Cr and Pb. Cassia siamea was found to accumulate all metals at higher concentrations compared to other species. The experimental study revealed that C. siamea could be used as a hyper-accumulator plant for bioremediation of fly ash dump.

Impact of distillery effluent application to land on soil microflora.

A pot culture experiment was conducted to evaluate the effect of different treatments of distillery wastewater, i.e. raw, treated, diluted and raw distillery wastewater mixed with domestic waste stabilization pond effluent (1:1) on populations of bacteria, fungi, actinomycetes and nitrogen fixing bacteria. The results indicated that raw wastewater decreased the population of bacteria, fungi and actinomycetes. The growth rates of Rhizobium and Azotobacter were also reduced after raw wastewater application. The toxic effect of raw wastewater was minimized when it was mixed with stabilization pond effluent (1:1), this was demonstrated by an increase in the populations of all the microorganisms studied. When a groundnut plant was irrigated with raw distillery wastewater, no fruits were produced and there was also less nodulation. This study indicates that raw distillery wastewater is very toxic to the soil microorganisms which are important in the soil ecosystem.

Differential antioxidative enzyme responses of Jatropha curcas L. to chromium stress

Chromium (Cr) tolerant and accumulation capability of Jatropha curcas L. was tested in Cr spiked soil amended with biosludge and biofertilizer. Plants were cultivated in soils containing 0, 25, 50, 100 and 250 mg kg(-1) of Cr for one year with and without amendment. Plant tissue analysis showed that combined application of biosludge and biofertilizer could significantly reduce Cr uptake and boost the plant biomass, whereas biofertilizer alone did not affect the uptake and plant growth. Antioxidative responses of catalase (CAT), ascorbate peroxidase (APX) and glutathione S-transferase (GST) were increased with increasing Cr concentration in plant. Hyperactivity of the CAT and GST indicated that antioxidant enzymes played an important role in protecting the plant from Cr toxicity. However, APX took a little part in detoxification of H(2)O(2) due to its sensitivity to Cr. Therefore, reduced APX activity was recorded. Reduced glutathione (GSH) activity was recorded in plant grown on/above 100 mg kg(-1) of Cr in soil. The study concludes that J. curcas could grow under chromium stress. Furthermore, the results encouraged that J. curcas is a suitable candidate for the restoration of Cr contaminated soils with the concomitant application of biosludge and biofertilizer.