Asiye Nur Dinçer

Evaluation of apically extruded debris associated with several Ni-Ti systems.

AIM To evaluate the apical extrusion of debris associated with several root canal preparation systems in vitro. METHODOLOGY Forty-five extracted human mandibular premolars with single canals and similar lengths were used. The root canals were instrumented using ProTaper Next (Dentsply Maillefer, Ballaigues, Switzerland), Twisted File (SybronEndo, Orange, CA, USA) or WaveOne (Dentsply Maillefer, Ballaigues, Switzerland). Debris extruded apically during instrumentation was collected into pre-weighed Eppendorf tubes. The Eppendorf tubes were then stored in an incubator at 70 °C for 5 days. The Eppendorf tubes were weighed to obtain the final weight of the Eppendorf tubes plus extruded debris. Three consecutive weights were obtained for each tube. The groups were compared using the Kruskal-Wallis one-way analysis of variance on Ranks and Tukeys test. RESULTS The ProTaper Next group produced the highest mean extrusion value whilst WaveOne produced less debris compared with all the other instruments (P > 0.05). There was a significant difference between the ProTaper Next and WaveOne group (P < 0.05). CONCLUSIONS Apically extruded debris was associated with all instrumentation techniques. The WaveOne system extruded less debris compared with the Twisted File and ProTaper Next.

Use of cone-beam computed tomography to evaluate root and canal morphology of mandibular first and second molars in Turkish individuals

Objective: The aim of this study was to investigate the root and canal morphology of mandibular first and second molars in a Turkish population by using cone beam computed tomography (CBCT). Study design: CBCT images of mandibular first (n = 823) and second molar (n = 925) teeth from 605 Turkish patients were analyzed. The root canal configurations were classified according to the method of Vertucci. Results: The majority of mandibular molars (95.8% of first molars, 85.4% of second molars) had two separate roots; however, three roots were identified in 2.06% of first molars and 3.45% of second molars. C-shaped canals occurred 0.85% of first molars and 4.1% of second molars. Three canals were found in 79.9% of first molars and 72.8% of second molars. Most distal roots had a simple type I configuration, whereas mesial roots had more complex canal systems, with more than one canal. The most common root morphology of first and second molars is the two rooted morphology with three canals. Both the mesial and distal roots showed wide variations in canal anatomy with type IV and type I canal configuration predominating in the mesial and distal roots, respectively. Conclusion: Vertucci type I and IV canal configurations were the most prevalent in the distal and mesial roots, respectively, of both the mandibular first and second permanent molar teeth. Key words:Cone-beam CT, Turkish, mandibular molars, root and canal morphology.

The effect of a new-generation flowable composite resin on microleakage in Class V composite restorations as an intermediate layer.

Aim: To evaluate the effect of application a new-generation bulk-fill flowable composite resin as an intermediate material between composite resin and dental substrates on micro-leakage in Class V composite restorations. Materials and Methods: A total of 144 Class V cavities were prepared in 72 human molars. Specimens were then randomly distributed among three groups according to adhesive system applied (Group 1: Clearfil SE Bond; Group 2: Adper Easy One; Group 3: Adhesive 200T), and each group was divided into three subgroups according to liner material used (Group A: No liner-control group; Group B: Aelite Flo LV, low viscosity microhybrid composite; Group C: Smart dentin replacement). All cavities were restored using resin composite (Aelite LS, low shrinkage posterior composite). Specimens were stained with 0.5% basic fuchsin and evaluated dye penetration. Results: There was no significant difference in dye penetration was found between the control and the experimental groups. Conclusions: Micro-leakage is not affected by the application of either conventional or new-generation flowable composite resin as an intermediate material between composite resin and dental substrates.

The Effect of Different Final Irrigant Activation Techniques on the Bond Strength of an Epoxy Resin–based Endodontic Sealer: A Preliminary Study

INTRODUCTION The aim of this study was to evaluate whether or not different final irrigation activation techniques affect the bond strength of an epoxy resin-based endodontic sealer (AH Plus; Dentsply DeTrey, Konstanz, Germany) to the root canal walls of different root thirds. METHODS Eighty single-rooted human mandibular premolars were prepared by using the ProTaper system (Dentsply Maillefer, Ballaigues, Switzerland) to size F4, and a final irrigation regimen using 3% sodium hypochlorite and 17% EDTA was performed. The specimens were randomly divided into 4 groups (n = 20) according to the final irrigation activation technique used as follows: no activation (control), manual dynamic activation (MDA), CanalBrush (Coltene Whaledent, Altststten, Switzerland) activation, and ultrasonic activation. Five specimens from each group were prepared for scanning electron microscopic observation to assess the smear layer removal after the final irrigation procedures. All remaining roots were then obturated with gutta-percha and AH Plus sealer. A push-out test was used to measure the bond strength between the root canal dentin and AH Plus sealer. The data obtained from the push-out test were analyzed using 2-way analysis of variance and Tukey post hoc tests. RESULTS The bond strength values mostly decreased in the coronoapical direction (P < .001). In the coronal and middle thirds, ultrasonic activiation showed a higher bond strength than other groups (P < .05). In the apical third, MDA displayed the highest bond strength to root dentin (P < .05). The majority of specimens exhibited cohesive failures. CONCLUSIONS The bond strength of AH Plus sealer to root canal dentin may improve with ultrasonic activation in the coronal and middle thirds and MDA in the apical third.

Frequency and distribution of early tooth loss and endodontic treatment needs of permanent first molars in a Turkish pediatric population

Objectives: The objective of this study is to evaluate the frequency and distribution of early tooth loss and endodontic treatment needs of permanent first molars in a Turkish pediatric population. Materials and Methods: A total of 7,895 panoramic radiographs taken for routine dental examination at the Department of Oral Maxillofacial Radiology between 2008 and 2012 years were investigated. Two independent specialists evaluated early tooth loss and endodontic treatment needs of permanent first molars using panoramic radiography and patient anamnesis forms. The teeth were classified according to the following data: (a) Missing teeth, (b) teeth requiring extraction, (c) endodontically treated teeth (ETT), (d) teeth requiring endodontic therapy. The data also classified according to four factors: Age group (6-12 and 13-16), gender (boy and girl), jaw (mandible and maxilla) and side (right and left). A Chi-square test was used for statistical analyses. Results: A total of 19,488 and 12,092 teeth were evaluated in the child group and adolescent group respectively. All data were higher in adolescents than children (P < 0.001). For gender factor, only ETT was higher in girls than it was in boys (P < 0.001). For the jaw factor, all data were higher (P < 0.001) in mandible than in the maxilla. For the side factor, no statistical difference existed between right and left. Conclusions: Early tooth loss and endodontic treatment needs of permanent first molars showed variability according to age groups and jaws. When the results were compared according to the side and gender factors, no statistical difference was found (P > 0.05) except with the data of ETT in gender groups.