Athanasios Kouras

Removal of pesticides from aqueous solutions by combined physicochemical processes—the behaviour of lindane

Abstract The adsorption of the insecticide lindane on powdered activated carbon (PAC) from aqueous solutions with and without the simultaneous presence of coagulants has been studied. Ferric chloride and basic polyaluminium chlorosulfate were examined as coagulants, in laboratory experiments aided in certain cases by polyacrylamide (a common polyelectrolyte) addition, in order to evaluate and optimize the various process parameters, such as coagulant and carbon concentrations, solution pH and position of coagulant addition (before or after PAC). The obtained results indicated that PAC adsorption efficiency was not highly affected by solution pH, while PAC doses greater than 20 mg/L were found to be necessary in order to reduce lindane from initial concentration of 10 μg/L down to 0.1 μg/L within 1 h contact time. However, when coagulants have been added after the addition of PAC, a certain decrease of adsorbent efficiency was observed and, therefore, double PAC concentration (40 mg/L) was necessary for the aforementioned removal. In order to evaluate the effect of position of coagulant addition on the removal efficiency of PAC, the respective adsorption isotherms were calculated and rate studies were performed.

Increased biomass burning due to the economic crisis in Greece and its adverse impact on wintertime air quality in Thessaloniki.

The recent economic crisis in Greece resulted in a serious wintertime air pollution episode in Thessaloniki. This air quality deterioration was mostly due to the increased price of fuel oil, conventionally used as a source of energy for domestic heating, which encouraged the residents to burn the less expensive wood/biomass during the cold season. A wintertime sampling campaign for fine particles (PM2.5) was conducted in Thessaloniki during the winters of 2012 and 2013 in an effort to quantify the extent to which the ambient air was impacted by the increased wood smoke emissions. The results indicated a 30% increase in the PM2.5 mass concentration as well as a 2-5-fold increase in the concentration of wood smoke tracers, including potassium, levoglucosan, mannosan, and galactosan. The concentrations of fuel oil tracers (e.g., Ni and V), on the other hand, declined by 20-30% during 2013 compared with 2012. Moreover, a distinct diurnal variation was observed for wood smoke tracers, with significantly higher concentrations in the evening period compared with the morning. Correlation analysis indicated a strong association between reactive oxygen species (ROS) activity and the concentrations of levoglucosan, galactosan, and potassium, underscoring the potential impact of wood smoke on PM-induced toxicity during the winter months in Thessaloniki.

Chemical composition and mass closure of ambient coarse particles at traffic and urban-background sites in Thessaloniki, Greece

Concentrations and chemical composition of the coarse particle fraction (PMc) were investigated at two urban sites in the city of Thessaloniki, Greece, through concurrent sampling of PM10 and PM2.5 during the warm and the cold months of the year. PMc levels at the urban-traffic site (UT) were among the highest found in literature worldwide exhibiting higher values in the cold period. PMc levels at the urban-background site (UB) were significantly lower exhibiting a reverse seasonal trend. Concentration levels of minerals and most trace metals were also higher at the UT site suggesting a stronger impact from traffic-related sources (road dust resuspension, brake and tire abrasion, road wear). According to the chemical mass closure obtained, minerals (oxides of Si, Al, Ca, Mg, Fe, Ti, and K) dominated the PMc profile, regardless of the site and the period, with organic matter and secondary inorganic aerosols (mainly nitrate) also contributing considerably to the PMc mass, particularly in the warm period. The influence of wind speed to dilution and/or resuspension of coarse particles was investigated. The source of origin of coarse particles was also investigated using surface wind data and atmospheric back-trajectory modeling. Finally, the contribution of resuspension to PMc levels was estimated for air quality management perspectives.

Polycyclic aromatic hydrocarbons (PAHs) at traffic and urban background sites of northern Greece: source apportionment of ambient PAH levels and PAH-induced lung cancer risk

Thirteen particle-phase PAHs, including nine >4-ring congeners [Benz[a]anthracene (BaAn), Chrysene (Chry), Benzo[b]fluoranthene (BbF), Benzo[k]fluoranthene (BkF), Benzo[e]pyrene (BeP), Benzo[a]pyrene (BaP), Dibenzo[a,h]anthracene (dBaAn), Benzo[g,h,i]perylene (BghiPe), Indeno(1,2,3-c,d)pyrene (IP)], listed by IARC (International Agency for Research on Cancer) as class 1, class 2A, and 2B carcinogens, plus four ≤4-ring congeners [Phenanthrene (Ph), Anthracene (An), Fluoranthene (Fl), Pyrene (Py)], were concurrently measured in inhalable and respirable particle fractions (PM10 and PM2.5) at a heavy-traffic and an urban background site in Thessaloniki, northern Greece, during the warm and the cold period of the year. Carcinogenic and mutagenic potencies of the PAH-bearing particles were calculated, and the inhalation cancer risk (ICR) for local population was estimated. Finally, Chemical Mass Balance (CMB) modeling was employed for the source apportionment of ambient PAH levels and the estimated lung cancer risk. Resulted inhalation cancer risk during winter was found to be equivalent in the city center and the urban background area suggesting that residential wood burning may offset the benefits from minor traffic emissions.

Redox activity and in vitro bioactivity of the water-soluble fraction of urban particulate matter in relation to particle size and chemical composition.

Chemical and toxicological characterization of the water-soluble fraction of size-segregated urban particulate matter (PM) (<0.49, 0.49-0.97, 0.97-1.5, 1.5-3.0, 3.0-7.2 and >7.2 μm) was carried out at two urban sites, traffic and urban background, during the cold and the warm period. Chemical analysis of the water-soluble PM fraction included ionic species (NO3(-), SO4(2-), Cl(-), Na(+), NH4(+), K(+), Mg(2+), Ca(2+)), water-soluble organic carbon (WSOC), and trace elements (Al, As, Ba, Cd, Cr, Cu, Fe, Pb, Mn, Ni, Zn, Pt, Pd, Rh, Ru, Ir, Ca, and Mg). The dithiothreitol (DTT) assay was employed for the abiotic assessment of the oxidative PM activity. Cytotoxic responses were investigated in vitro by applying the mitochondrial dehydrogenase (MTT) and the lactate dehydrogenase (LDH) bioassays on human lung cells (MRC-5), while DNA damage was estimated by the single cell gel electrophoresis assay, known as Comet assay. The correlations between the observed bioactivity responses and the concentrations of water-soluble chemical PM constituents in the various size ranges were investigated. The results of the current study corroborate that short-term bioassays using lung human cells and abiotic assays, such as the DTT assay, could be relevant to complete the routine chemical analysis and to obtain a preliminary screening of the potential effects of PM-associated airborne pollutants on human health.

Concentrations and source apportionment of PM10 and associated major and trace elements in the Rhodes Island, Greece.

Ambient concentrations of PM(10) and associated major and trace elements were measured over the cold and the warm season of 2007 at two sites located in the Rhodes Island (Greece), in Eastern Mediterranean, aimed at source apportionment by Chemical Mass Balance (CMB) receptor modeling. Source chemical profiles, necessary in CMB modeling, were obtained for a variety of emission sources that could possibly affect the study area, including sea spray, geological material, soot emissions from the nearby oil-fuelled thermal power plant, and other anthropogenic activities, such as vehicular traffic, residential oil combustion, wood burning, and uncontrolled open-air burning of agricultural biomass and municipal waste. Source apportionment of PM(10) and elemental components was carried out by employing an advanced CMB version, the Robotic Chemical Mass Balance model (RCMB). Vehicular emissions were found to be major PM(10) contributor accounting, on average, for 36.8% and 31.7% during the cold period, and for 40.9% and 39.2% in the warm period at the two sites, respectively. The second largest source of ambient PM(10), with minor seasonal variation, was secondary sulfates (mainly ammonium and calcium sulfates), with total average contribution around 16.5% and 18% at the two sites. Soil dust was also a remarkable source contributing around 22% in the warm period, whereas only around 10% in the cold season. Soot emitted from the thermal power plant was found to be negligible contributor to ambient PM(10) (<1%), however it appeared to appreciably contribute to the ambient V and Ni (11.3% and 5.1%, respectively) at one of the sites during the warm period, when electricity production is intensified. Trajectory analysis did not indicate any transport of Sahara dust; on the contrary, long range transport of soil dust from arid continental regions of Minor Asia and of biomass burning aerosol from the countries surrounding the Black Sea was considered possible.

Removal of pesticides from surface waters by combined physicochemical processes. Part I: Dodine

The simultaneous action of powdered activated carbon and several coagulant agents on the removal of the fungicide dodine from spiked distilled water, was studied. As coagulants, ferric chloride (FeCl3) and basic polyaluminium chlorosulfate ([Al(OH)xCly(SO4)z]n) were examined, using polyacrylamide, in certain cases, as coagulant aid (polyelectrolyte). The efficiency of dodine removal was investigated with respect to the added amount of powdered activated carbon (PAC), the pH value, as well as the type and dose of coagulant and polyelectrolyte. The experiments were performed applying the standard jar-test procedure. The initial concentration of dodine was 250 μg/L. At this concentration and pH range 5–8 it was found that a dose of 100 mg/L PAC was necessary to achieve more than 98% removal of dodine, whereas lower removal (91–93%) was obtained applying half the dose of PAC under the same conditions. However, when 10–100 mg/L FeCl3 were simultaneously added with PAC, the removal efficiency increased to >98%, even with the half PAC dose.

Spatial and seasonal variations of the chemical, mineralogical and morphological features of quasi-ultrafine particles (PM 0.49) at urban sites.

Combining chemical and physical-structural information of particles is a key issue in PM investigations. Chemical, mineralogical, and morphological characterization of quasi-ultrafine particles (PM 0.49) was carried out at two urban sites of varying traffic-influence (roadside and urban background) in Thessaloniki, northern Greece, during the cold and the warm period of 2013. Bulk analyses of chemical species included organic and elemental carbon (OC, EC), water soluble organic carbon (WSOC), ionic species (NO3(-), SO4(2-), Cl(-), Na(+), NH4(+), K(+), Mg(2+), Ca(2+)) and trace elements (As, Ba, Cd, Cr, Cu, Fe, Pb, Mn, Ni, Zn, Pt, Pd, Rh, Ru, and Ir). X-ray diffractometry (XRD) was employed for the mineralogical analysis of PM 0.49 in order to identify and quantify amorphous and crystalline phases. In addition, scanning electron microscopy coupled with energy dispersive spectrometry (SEM-EDS) was employed for morphological characterization and elemental microanalysis of individual particles. Findings of this work could provide the basis for designing epidemiological and toxicity studies to mitigate population exposure to UFPs.

Study on distribution and origin of boron in groundwater in the area of Chalkidiki, Northern Greece by employing chemical and isotopic tracers

This paper presents an integrate study on the occurrence and distribution of boron in groundwater in the area of Chalkidiki, Northern Greece. Groundwater samples were collected from wells used for drinking and irrigation purposes. Samples were analysed for boron, various physicochemical parameters (T, pH, EC, Ca, Mg, Na, K, Br, Cl, HCO(3), SO(4), NO(3) and As) and isotopes ((18)O, (2)H, (11)B). Boron showed high spatial variation ranged from 0.04 to 6.5mg/L. Almost 60% of the examined wells exhibited boron concentration higher than the limit of 1mg/L proposed for water intended for human consumption. The higher concentrations were determined in geothermal waters with relatively high temperature. Correlation analysis and hierarchical cluster analysis were employed to find out possible relationships among the examined parameters and groundwater samples. Chemical and isotopic fingerprints have been used to investigate the origin of boron.

Modeling Methodology Based on Stacked Neural Networks Applied to the Photocatalytic Degradation of Triclopyr

In the present paper, we propose a modeling methodology based on stacked neural networks by combining several individual networks in parallel, whose outputs are weighted to provide the output of the stack. Also, a procedure was included for finding the optimal set of weights that leads to the best performance of modeling, on both training and validation data. As a case study, we consider the photocatalytic oxidation of triclopyr where the final concentration was evaluated depending on the reaction conditions, irradiation time and amounts of reactants. We show that the performance of the stack is better than those of individual networks, especially for the validation phase.