Aymeric Girard

Performance of molten salt solar power towers in Chile

Chile is facing important challenges to develop its energy sector. Estimations demonstrate that in its electricity consumption Chile will grow at an annual rate of 4.6% until 2030, despite ongoing efficiency improvements. To satisfy this demand in a sustainable way, the national energy policy promotes the integration of novel and clean power generation into the national power mix, with special emphasis on concentrated solar power (CSP). The present paper assesses the development of solar-based electricity generation in Chile by CSP, achieved by a Solar Power Tower plant (SPT) using molten salt as heat carrier and store. Such SPTs can be installed at different locations in Chile, and connected to the main national grid. Results show that each SPT plant can generate around 76 GWhel of net electricity, when considering solar irradiation as the sole energy source and at a 16% overall efficiency of the SPT process. For operation in a continuous mode, a hybrid configuration with integrated gas backup system inc...

A validated design simulation tool for passive solar space heating: Results from a monitored house in West Lothian, Scotland

Determining the availability of renewable sources on a particular site would result in increasing the efficiency of buildings through appropriate design. The overall aim of the project is to develop a pioneering software tool allowing the assessment of possible energy sources for any building design project. The package would allow the user to simulate the efficiency of the Passive Solar Space Heating referred in the Low and Zero Carbon Energy Sources (LZCES) Strategic Guide stated by the Office of the Deputy Prime Minister (2006) and the Building Regulations. This research paper presents the tool for modelling the passive solar sources availability in relation to low-carbon building. A 3-month experimental set up monitoring a solar house in West Lothian, Scotland, was also undertaken to validate the simulation tool. Experimental and simulation results were found in good agreement following a one-to-one relationship demonstrating the ability of the newly developed tool to assess potential solar gain available for buildings. This modelling tool is highly valuable in consideration of the part L of the Building Regulations (updated in 2010).