Barbara May

Shoulder torques resulting from luggage handling tasks in non-inertial frames

BACKGROUND This paper reports on the torques developed in the shoulder joint experienced by occupants of moving vehicles during manual handling tasks. Handling heavy weights can cause musculoskeletal injuries, especially if handling is done with arms extended or at high levels. OBJECTIVE The aim of the study was to measure the longitudinal and lateral accelerations in a variety of passenger vehicles together with the postures of subjects lifting luggage onto storage shelves. This data enabled the application of inverse dynamics methods in a non-inertial reference frame to calculate the shoulder joint torques. METHODS The subjects lifted 3 pieces of luggage of masses of 5 kg, 10 kg and 14 kg onto shelving which were at heights of 1.2 m, 1.6 m and 1.8 m. The movement of subjects was measured using a 12 camera, 3-dimensional optical tracking system. The subjects stood on force plates to measure the ground reaction forces. RESULTS Sixty-three trials were completed, although 9 trials were aborted because subjects felt unable to complete the task. It was found that the shoulder torques exceeded the levels recommend by the UK Health and Safety Executive for manual handling. A lift assistance device is suggested to reduce the shoulder torques required for luggage handling.

A Novel Biomechanical Analysis of Horticultural Digging

Musculoskeletal injuries are commonly reported in workers employed in labor-intensive agricultural-type tasks. A novelmethodof determining joint angles, joint torques, and contact forces, using three-dimensional motion capture and musculoskeletal modeling, was applied to the movements of a sample of workers, engaged in the horticultural task of digging, to determine if objective biomechanical data could be correlated with a subjective visual assessment to predict risk of injury. The joint angle time histories of horticulturists were calculated from the motion capture data, and this was used to articulate a musculoskeletal model of the subjects. The joint torques were calculated using inverse dynamics methods fromwhich the individual muscle loads were established using a cost functionminimization approach. Finally, the joint contact forces were calculated including the muscle forces. The motion capture data of digging trials were observed by a team of horticulturists and physiotherapists who categorized each of the observed trials according to form, efficiency, and risk of injury. Trials demonstrating techniques which were more likely to yield injuries were identified as ‘‘examples of bad technique’’; those judged tobe less likely to yield injurieswere categorized as ‘‘examples of good technique.’’ It was found that the joint torques and contact forces and their variability were lower in the trial which was identified as good technique, and consistentlyhigher in the examples ofbad technique.The results of the study suggest that measurement of joint angles, joint torques, joint contact forces, and forces in themuscles could serve as a valuable tool to develop training programs for horticultural workers engaged in certain high intensity tasks, such as digging, to effectively improve efficiency and reduce incidence of injury. It may also be possible to modify horticulture-related equipment to minimize the internal loads within the body to reduce the risk to health and, therefore, extend active participation in horticulture.