Benjamin Probst

An efficient homogeneous intermolecular rhenium based photocatalytic system for the production of H2

We present an artificial photocatalytic model for photosystem I (PSI) using [ReBr(CO)(3)bipy)] (1) as a photosensitizer, [Co(dmgH)(2)] (2) as a hydrogen evolution reaction catalyst, and triethanolamine as an irreversible reductive quencher. Complex 1 is more robust in the long run, and turnover numbers were more than doubled in the present study as compared to the commonly used photosensitizer [Ru(bipy)(3)](2+). The quantum yield for hydrogen production with 1 was found to be 26 +/- 2% (H produced per absorbed photon). Forward electron transfer between 1(-) and 2 was found to occur at a rate close to diffusion control (k(1) = 2.5 +/- 0.1 x 10(8) M(-1) s(-1)). The rate of hydrogen production exhibited a linear dependence on the photon flux and a quadratic dependence on the total concentration of Co (k(obs) = 3.7 +/- 0.1 M(-1) s(-1)). Therefore, a second-order process in Co(III)-H is proposed. The process showed a complex dependence on [AcOH]. An excess of dimethylglyoxime was systematically added to the system to ensure the complete formation of 2 and reduce the portion of free [Co](solv)(2+), an efficient quencher of the excited state of 1.

Photocatalytic H2 production from water with rhenium and cobalt complexes.

Photocatalytic hydrogen production in pure water for three component systems using a series of rhenium-based photosensitizers (PS) and cobalt-based water reduction catalysts (WRC), with triethanolamine (TEOA) as an irreversible electron donor, is described. Besides the feasibility of this reaction in water, key findings are reductive quenching of the excited state of the PS by TEOA (k(q) = 5-8 × 10(7) M(-1) s(-1); Φ(cage) = 0.75) and subsequent transfer of an electron to the WRC (k(Co(III)) = 1.1 × 10(9) M(-1) s(-1)). Turnover numbers in rhenium (TON(Re), H/Re) above 500 were obtained, whereas TON(Co) (H(2)/Co) did not exceed 17. It is shown that the cobalt-based WRC limits long-term performance. Long-term performance critically depends on pH and the type of WRC used but is unaffected by the type of PS or the concentration of WRC. A quantum yield of 30% was obtained (H/photon).

Sorption enhanced CO2 methanation

The transformation from the fatuous consumption of fossil energy towards a sustainable energy circle is most easily marketable by not changing the underlying energy carrier but generating it from renewable energy. Hydrocarbons can be principally produced from renewable hydrogen and carbon dioxide collected by biomass. However, research is needed to increase the energetic and economic efficiency of the process. We demonstrate the enhancement of CO2 methanation by sorption enhanced catalysis. The preparation and catalytic activity of sorption catalysts based on Ni particles in zeolites is reported. The functioning of the sorption catalysis is discussed together with the determination of the reaction mechanism, providing implications for new ways in catalysis.

General Scheme for Oxidative Quenching of a Copper Bis-Phenanthroline Photosensitizer for Light-Driven Hydrogen Production.

A new, general reaction scheme for photocatalytic hydrogen production is presented based on oxidative quenching of a homoleptic copper(I) bis-1,10-phenanthroline photosensitizer (PS) by 1-methyl-4-phenyl-pyridinium (MPP(+) ) as the electron relay and subsequent regeneration of the so formed copper(II) complex by a sacrificial electron donor. Electron transfer from the relay to various cobalt based water reduction catalysts and subsequent H2 production was shown to close the catalytic cycle. Transient absorption experiments unambiguously confirmed the proposed pathway, both the oxidative quenching and subsequent regeneration of oxidized PS. Photocatalytic test runs further confirmed the role of MPP(+) and up to 10 turnovers were achieved in the relay. The performance limiting factor of the system was shown to be the decomplexation of the copper PS. Quantum yields of the system were 0.03 for H2 production, but 0.6 for MPP(.) formation, clearly indicating that unproductive pathways still prevail.

Quinones as Reversible Electron Relays in Artificial Photosynthesis

We explore the potential of various hydroquinone/quinone redox couples as electron relays in a homogenous water reduction system between a Re-based photosensitizer and a sacrificial electron donor [tris-(2-carboxyethyl)-phosphine, TCEP]. By using transient IR spectroscopy, flash photolysis as well as stopped-flow techniques covering timescales from picoseconds to 100 ms, we determine quenching rates and cage escape yields, the kinetics of the follow-up chemistry of the semiquinone, the recombination rates, as well as the re-reduction rates by TCEP. The overall quantum yield of hydrogen production is low, and we show that the limiting factors are the small cage escape yields and, more importantly, the slow regeneration rate by TCEP in comparison to the undesired charge recombination with the reduced water reduction catalyst.

SnIV Metalloporphyrin/CoIII Complex: An All-Abundant-Element System for the Photocatalytic Production of H2 in Aqueous Solution

A new, molecular system for the light-driven production of hydrogen in aqueous solution was developed by combining a water-soluble tin porphyrin ([Sn(IV)Cl2TPPC], A) acting as photosensitizer with a cobalt-based proton-reduction catalyst ([Co(III)Cl(dmgH)2(py)], C). Under visible light illumination and with triethanolamine (TEOA) as electron source, the system evolves H2 for hours and is clearly catalytic in both dye and catalyst. A detailed analysis of the relevant redox potentials in combination with time-resolved spectroscopy resulted in the development of a Z-scheme type model for the flow of electrons in this system. Key intermediates of the proposed mechanism for the pathway leading to H2 are the porphyrin dyes highly oxidizing singlet excited state (1)A* (E ∼ +1.3 V vs NHE), its strongly reducing isobacteriochlorin analogue (E ∼ +0.95 V), and the Co(I) form of C (E ∼ -0.8 V), acting as catalyst for H2 formation. Among other results, the suggested reaction sequence is supported by the detection of a shortened excited-state lifetime for singlet (1)A* (τ ∼ 1.75 ns) in the presence of TEOA and the ultraviolet-visible detection of the Sn(IV) isobacteriochlorin intermediate at λ = 610 nm. Thus, a molecular, conceptually biomimetic, and precious-metal-free reaction chain was found which photocatalytically generates H2 in a 100% aqueous system from an electron donor with a high oxidation potential (E(TEOA) ∼ +1.1 V). On the other hand, at identical conditions, this photoreaction chain yields H2 markedly slower than a system using the photosensitizer [Re(I)(CO)3(bpy) (py)](+), probably due to the much longer excited-state lifetime (τ ∼ 120 ns) of the rhenium dye and better electron-transfer rates caused by its simple single-electron photoreduction chemistry.

Closing the pressure gap in x-ray photoelectron spectroscopy by membrane hydrogenation

Comprehensive studies of gas-solid reactions require the in-situ interaction of the gas at a pressure beyond the operating pressure of ultrahigh vacuum (UHV) X-ray photoelectron spectroscopy (XPS). The recent progress of near ambient pressure XPS allows to dose gases to the sample up to a pressure of 20 mbar. The present work describes an alternative to this experimental challenge, with a focus on H2 as the interacting gas. Instead of exposing the sample under investigation to gaseous hydrogen, the sample is in contact with a hydrogen permeation membrane, through which hydrogen is transported from the outside to the sample as atomic hydrogen. Thereby, we can reach local hydrogen concentrations at the sample inside an UHV chamber, which is equipped with surface science tools, and this corresponds to a hydrogen pressure up to 1 bar without affecting the sensitivity or energy resolution of the spectrometer. This experimental approach is validated by two examples, that is, the reduction of a catalyst precursor for CO2 hydrogenation and the hydrogenation of a water reduction catalyst for photocatalytic H2 production, but it opens the possibility of the new in situ characterisation of energy materials and catalysts.

Centimeter-Sized Single-Orientation Monolayer Hexagonal Boron Nitride With or Without Nanovoids

Large-area hexagonal boron nitride (h-BN) promises many new applications of two-dimensional materials, such as the protective packing of reactive surfaces or as membranes in liquids. However, scalable production beyond exfoliation from bulk single crystals remained a major challenge. Single-orientation monolayer h-BN nanomesh is grown on 4 in. wafer single crystalline rhodium films and transferred on arbitrary substrates such as SiO2, germanium, or transmission electron microscopy grids. The transfer process involves application of tetraoctylammonium bromide before electrochemical hydrogen delamination. The material performance is demonstrated with two applications. First, protective sealing of h-BN is shown by preserving germanium from oxidation in air at high temperatures. Second, the membrane functionality of the single h-BN layer is demonstrated in aqueous solutions. Here, we employ a growth substrate intrinsic preparation scheme to create regular 2 nm holes that serve as ion channels in liquids.

Atomically dispersed hybrid nickel-iridium sites for photoelectrocatalysis

Atomically dispersed supported catalysts can maximize atom efficiency and minimize cost. In spite of much progress in gas-phase catalysis, applying such catalysts in the field of renewable energy coupled with electrochemistry remains a challenge due to their limited durability in electrolyte. Here, we report a robust and atomically dispersed hybrid catalyst formed in situ on a hematite semiconductor support during photoelectrochemical oxygen evolution by electrostatic adsorption of soluble monomeric [Ir(OH)6]2− coupled to positively charged NiOx sites. The alkali-stable [Ir(OH)6]2− features synergistically enhanced activity toward water oxidation through NiOx that acts as a “movable bridge” of charge transfer from the hematite surface to the single iridium center. This hybrid catalyst sustains high performance and stability in alkaline electrolyte for >80 h of operation. Our findings provide a promising path for soluble catalysts that are weakly and reversibly bound to semiconductor-supported hole-accumulation inorganic materials under catalytic reaction conditions as hybrid active sites for photoelectrocatalysis.Atomically disperse catalysts can offer promising activity due to the high exposure of active sites. Here, iridium complexes in solution undergo a binding equilibrium with a nickel oxide surface resulting in atomically disperse iridium and high turnover frequencies for oxygen evolution.

Structure-Activity and Stability Relationships for Cobalt Polypyridyl based Hydrogen Evolving Catalysts in Water

A series of eight new and three known cobalt polypyridyl-based hydrogen-evolving catalysts (HECs) with distinct electronic and structural differences are benchmarked in photocatalytic runs in water. Methylene-bridged bis-bipyridyl is the preferred scaffold, both in terms of stability and rate. For a cobalt complex of the tetradentate methanol-bridged bispyridyl-bipyridyl complex [CoII Br(tpy)]Br, a detailed mechanistic picture is obtained by combining electrochemistry, spectroscopy, and photocatalysis. In the acidic branch, a proton-coupled electron transfer, assigned to formation of CoIII -H, is found upon reduction of CoII , in line with a pKa (CoIII -H) of approximately 7.25. Subsequent reduction (-0.94 V vs. NHE) and protonation close the catalytic cycle. Methoxy substitution on the bipyridyl scaffold results in the expected cathodic shift of the reduction, but fails to change the pKa (CoIII -H). An analysis of the outcome of the benchmarking in view of this postulated mechanism is given along with an outlook for design criteria for new generations of catalysts.