Bernd Jenewein

Comparison of the reactivity of different Pd-O species in CO oxidation.

The reactivity of several Pd-O species toward CO oxidation was compared experimentally, making use of chemically, structurally and morphologically different model systems such as single-crystalline Pd(111) covered by adsorbed oxygen or a Pd(5)O(4) surface oxide layer, an oriented Pd(111) thin film on NiAl oxidized toward PdO(x) suboxide and silica-supported uniform Pd nanoparticles oxidized to PdO. The oxygen reactivity decreased with increasing oxidation state: O(ad) on metallic Pd(111) exhibited the highest reactivity and could be reduced within a few minutes already at 223 K, using low CO beam fluxes around 0.02 ML s(-1). The Pd(5)O(4) surface oxide on Pd(111) could be reacted by CO at a comparable rate above 330 K using the same low CO beam flux. The more deeply oxidized Pd(111) thin film supported on NiAl was already much less reactive, and reduction in 10(-6) mbar CO at T > 500 K led only to partial reduction toward PdO(x) suboxide, and the metallic state of Pd could not be re-established under these conditions. The fully oxidized PdO nanoparticles required even rougher reaction conditions such as 10 mbar CO for 15 min at 523 K in order to re-establish the metallic state. As a general explanation for the observed activity trends we propose kinetic long-range transport limitations for the formation of an extended, crystalline metal phase. These mass-transport limitations are not involved in the reduction of O(ad), and less demanding in case of the 2-D Pd(5)O(4) surface oxide conversion back to metallic Pd(111). They presumably become rate-limiting in the complex separation process from an extended 3-D bulk oxide state toward a well ordered 3-D metallic phase.

Growth and decomposition of aligned and ordered PdO nanoparticles

The formation, thermal decomposition, and reduction of small PdO particles were studied by high-resolution transmission electron microscopy and selected area electron diffraction. Well-defined Pd particles (mean size of 5-7 nm) were grown epitaxially on NaCl (001) surfaces and subsequently covered by a layer of amorphous SiO2 (25 nm), prepared by reactive deposition of SiO in 10(-2) Pa O2. The resulting films were exposed to molecular O2 in the temperature range of 373-673 K, and the growth of PdO was studied. The formation of a PdO phase starts at 623 K and is almost completed at 673 K. The high-resolution experiments suggest a topotactic growth of PdO crystallites on top of the original Pd particles. Subsequent reaction of the PdO in 10 mbar CO for 15 min and thermal decomposition in 1 bar He for 1 h were also investigated in the temperature range from 373 to 573 K. Reductive treatments in CO up to 493 K do not cause a significant change in the PdO structure. The reduction of PdO starts at 503 K and is completed at 523 K. In contrast, PdO decomposes in 1 bar He at around 573 K. The mechanism of PdO growth and decay is discussed and compared to results of previous studies on other metals, e.g., on rhodium.

Surface reactions on inverse model catalysts: CO adsorption and CO hydrogenation on vanadia- and ceria-modified surfaces of rhodium and palladium

Reducible transition metal oxides are well-known promoters of the hydrogenation of CO on noble metal surfaces. In this study the promotional effect of vanadia and ceria adlayers on Rh and Pd surfaces was investigated with emphasis on the effect of the oxidation state on CO adsorption and catalytic activity. “Inverse supported catalysts” were prepared by UHV deposition of V and Ce on the noble metal surface (Rh(111), Pd(111) or Rh foil). After oxidation and specified reduction, the reaction kinetics on polycrystalline Rh was measured at atmospheric pressure, and the molecular and dissociative chemisorption of CO on Rh(111) and Pd(111) and the methanation kinetics on Rh(111) were investigated by molecular beam techniques. On Rh(111), the probability of CO dissociation and the reaction rate are enhanced by submonolayer VOx deposits. Local pressures between 10-2 and 1 mbar are sufficient to drive the methanation at 573 K with measurable amounts of products, accompanied by significant restructuring of the catalyst surface. Although the reaction on Rh is generally promoted by small quantities of vanadia and ceria, the reaction rates depend strongly on the extent and temperature of hydrogen reduction. The observed increase of the reaction rate by reduction up to 673 K can be correlated to concomitant changes of the structure and composition of the VOx deposits. If the reduction temperature is raised above 673 K, metallic V is partially dissolved in the bulk, and the resulting V/Rh subsurface alloy exhibits a particularly high activity. Contrary to vanadia, ceria islands on Rh promote the initial reaction only after a low-temperature reduction, but the activity decreases after reduction above 573 K.

Structural and redox properties of VOx and Pd/VOx thin film model catalysts studied by TEM and SAED.

The oxidation of pure V(2)O(3) and Pd/V(2)O(3) films was studied by Transmission Electron Microscopy (TEM) and Selected Area Electron Diffraction (SAED) in the temperature range 673-773 K. Thin films of V(2)O(3) were prepared by reactive deposition of V metal in 10(-2) Pa O(2) on NaCl(001) cleavage faces. Pd particles were epitaxially grown on NaCl(001) and subsequently embedded in V(2)O(3). Oxidation of both pure V(2)O(3) and Pd/V(2)O(3) at 673 K transforms V(2)O(3) into a platelet-like V(2)O(5) structure. At temperatures T>or= 773 K, a reconstruction of the platelet-like V(2)O(5) structure into an array of oblong and needle-type V(2)O(5) nanocrystals of different size occurs. Subsequent reduction of the so-prepared structures in 1 bar H(2) at 573-673 K results in the formation of the cubic VO phase, whereby the external shape of the original crystals is partially maintained. Upon oxidation at 723 K, Pd is transformed into PdO, but its formation is suppressed in comparison with Pd supported on Al(2)O(3) and occurs only at an about 100 K higher temperature than on Pd/Al(2)O(3). The Pd particles are stabilized against oxidation up to 673 K, PdO decomposes upon reduction in hydrogen between 573 and 673 K.