Bing-Feng Liu

Optimization of culture conditions for hydrogen production by Ethanoligenens harbinense B49 using response surface methodology

The design of an optimum and cost-efficient medium for high-level production of hydrogen by Ethanoligenens harbinense B49 was attempted by using response surface methodology (RSM). Based on the Plackett-Burman design, Fe(2+) and Mg(2+) were selected as the most critical nutrient salts. Subsequently, the optimum combination of the selected factors and the sole carbon source glucose were investigated by the Box-Behnken design. Results showed that the maximum hydrogen yield of 2.21 mol/mol glucose was predicted when the concentrations of glucose, Fe(2+) and Mg(2+) were 14.57 g/L, 177.28 mg/L and 691.98 mg/L, respectively. The results were further verified by triplicate experiments. The batch reactors were operated under an optimized condition of the respective glucose, Fe(2+) and Mg(2+) concentration of 14.5 g/L, 180 mg/L and 690 mg/L, the initial pH of 6.0 and experimental temperature of 35+/-1(o)C. Without further pH adjustment, the maximum hydrogen yield of 2.20 mol/mol glucose was obtained based on the optimized medium with further verified the practicability of this optimum strategy.

Enhanced hydrogen production from waste activated sludge by cascade utilization of organic matter in microbial electrolysis cells

Fermentative hydrogen production from waste activated sludge (WAS) has low H2 yield because WAS contains limited amounts of carbohydrate suitable for use by hydrogen-producing bacteria. Here, augmentation of hydrogen production from WAS by microbial electrolysis cells (MECs) was implemented. H2 yields of 3.89±0.39 mg-H2/g-DS (5.67±0.61 mg-H2/g-VSS) from raw WAS and 6.78±0.94 mg-H2/g-DS (15.08±1.41 mg-H2/g-VSS) from alkaline-pretreated WAS were obtained in the two-chamber MECs (TMECs). This was several times higher than yields obtained previously by fermentation. Single-chamber MECs (SMECs) with low internal resistance showed a H2 production rate that 13 times that of TMECs with similar H2 yield when alkaline-pretreated WAS was used. However, methanogenesis was detected after several batch cycles. A yield balance calculation revealed that carbohydrates were not the only substrates for electrohydrogenesis. Protein and its acidification products, such as volatile fatty acids are also responsible for a portion of H2 generation in MEC. Characterization of WAS in TMECs by three-dimensional excitation-emission matrix (EEM) fluorescence spectroscopy with parallel factor analysis indicated that electrohydrogenesis reacted on the extracellular polymeric substances and intracellular substances of WAS. Cascade utilization of organic matter in MECs increased hydrogen production from WAS. MECs showed high hydrogen yield from WAS, fewer H2 sinks, and insensitivity to temperature. Optimizing MEC configurations and operation conditions and improving the pretreatment processes of WAS are necessary before practical application can take place on a large scale.

Biological hydrogen production by dark fermentation: challenges and prospects towards scaled-up production

Among different technologies of hydrogen production, bio-hydrogen production exhibits perhaps the greatest potential to replace fossil fuels. Based on recent research on dark fermentative hydrogen production, this article reviews the following aspects towards scaled-up application of this technology: bioreactor development and parameter optimization, process modeling and simulation, exploitation of cheaper raw materials and combining dark-fermentation with photo-fermentation. Bioreactors are necessary for dark-fermentation hydrogen production, so the design of reactor type and optimization of parameters are essential. Process modeling and simulation can help engineers design and optimize large-scale systems and operations. Use of cheaper raw materials will surely accelerate the pace of scaled-up production of biological hydrogen. And finally, combining dark-fermentation with photo-fermentation holds considerable promise, and has successfully achieved maximum overall hydrogen yield from a single substrate. Future development of bio-hydrogen production will also be discussed.

Hydrogen production with R. faecalis RLD-53 isolated from freshwater pond sludge.

The Rhodopseudomonas faecalis strain RLD-53 was isolated from freshwater pond sludge and was demonstrated it could produce hydrogen. This study to investigate their ability of hydrogen production under some conditions in batch culture experiments. At pH 7.0, temperature 35 degrees C and light intensity of 4000 lux, the H(2) yield was 2.64 mol-H(2)/mol-acetate, 2.34 mol-H(2)/mol-propionate, 1.75 mol-H(2)/mol-lactate and 3.55 mol-H(2)/mol-malate, respectively. The maximal H(2) production rate of 32.62 ml-H(2)/l/h and H(2) yield of 2.84 mol-H(2)/mol-acetate were achieved when beef extract was used as nitrogen source. Light intensity is the most important factor for H(2) production, H(2) production yield and rate decreased with increasing light intensity and reached highest under light intensity of 3000-5000 lux. Result indicated the strain RLD-53 was a high efficient bacteria for hydrogen production.

Electricity generation from food wastes and microbial community structure in microbial fuel cells

Microbial fuel cell (MFC) was studied as an alternate and a novel way to dispose food wastes (FWs) in a waste-to-energy form. Different organic loading rate obviously affected the performance of MFCs fed with FWs. The maximum power density of ~18 W/m(3) (~556 mW/m(2)) was obtained at COD of 3200±400 mg/L and the maximum coulombic efficiency (CE) was ~27.0% at COD of 4900±350 mg/L. The maximum removals of COD, total carbohydrate (TC) and total nitrogen (TN) were ~86.4%, ~95.9% and ~16.1%, respectively. Microbial community analysis using 454 pyrosequencing of 16S rRNA gene demonstrated the combination of the dominant genera of the exoelectrogenic Geobacter and fermentative Bacteroides effectively drove highly efficient and reliable MFC systems with functions of organic matters degradation and electricity generation.

Hydrogen production by the newly isolated Clostridium beijerinckii RZF-1108.

A fermentative hydrogen-producing strain, RZF-1108, was isolated from a biohydrogen reactor, and identified as Clostridium beijerinckii on the basis of the 16S rRNA gene analysis and physiobiochemical characteristics. The effects of culture conditions on hydrogen production by C. beijerinckii RZF-1108 were investigated in batch cultures. The hydrogen production and growth of strain RZF-1108 were highly dependent on temperature, initial pH and substrate concentration. Yeast extract was a favorable nitrogen source for hydrogen production and growth of RZF-1108. Hydrogen production corresponded to cell biomass yield in different culture conditions. The maximum hydrogen evolution, yield and production rate of 2209ml H2/l medium, 1.97 mol H2/mol glucose and 104.20 ml H2/g CDWh(-1) were obtained at 9 g/l of glucose, initial pH of 7.0, inoculum volume of 8% and temperature of 35 °C, respectively. These results demonstrate that C. beijerinckii can efficiently produce H2, and is another model microorganism for biohydrogen investigations.

Enhanced bio-hydrogen production by the combination of dark- and photo-fermentation in batch culture

In this study, some key factors, for example, diluted ratio of effluents, the ratio of dark-photo bacteria, light intensity and light/dark cycle influencing hydrogen production by combining Clostridium butyricum and immobilized Rhodopseudomonas faecalis RLD-53 in batch culture, were investigated. Experimental results showed the photo-hydrogen yield decreased when increasing diluted ratio from 1:0.5 to 1:3, and it reached the maximum value of 4368 ml-H(2)/l-effluents at the ratio of 1:0.5. When the ratio of dark-photo bacteria was at 1:2, the hydrogen yield reached highest value of 4.946 mol-H(2)/mol-glucose and cumulative hydrogen volume was 5357 ml-H(2)/l-culture during the combination process. When the light intensity was at 10.25 W/m(2), the hydrogen volume of photo-fermentation and the combination process reached maximum value of 4260 ml-H(2)/l-effluents and 5892 ml-H(2)/l-culture, respectively. During the combination process, maximum total hydrogen yield was 5.374 mol-H(2)/mol-glucose. Meanwhile, hydrogen production under light/dark cycle was evaluated.

Hydrogen production by immobilized R. faecalis RLD-53 using soluble metabolites from ethanol fermentation bacteria E. harbinense B49

In order to increase the hydrogen yield from glucose, hydrogen production by immobilized Rhodopseudomonas faecalis RLD-53 using soluble metabolites from ethanol fermentation bacteria Ethanoligenens harbinense B49 was investigated. The soluble metabolites from dark-fermentation mainly were ethanol and acetate, which could be further utilized for photo-hydrogen production. Hydrogen production by B49 was noticeably affected by the glucose and phosphate buffer concentration. The maximum hydrogen yield (1.83 mol H(2)/mol glucose) was obtained at 9 g/l glucose. In addition, we found that the ratio of acetate/ethanol (A/E) increased with increasing phosphate buffer concentration, which is favorable to further photo-hydrogen production. The total hydrogen yield during dark- and photo-fermentation reached its maximum value (6.32 mol H(2)/mol glucose) using 9 g/l glucose, 30 mmol/l phosphate buffers and immobilized R. faecalis RLD-53. Results demonstrated that the combination of dark- and photo- fermentation was an effective and efficient process to improve hydrogen yield from a single substrate.

Enhanced lipid accumulation of green microalga Scenedesmus sp. by metal ions and EDTA addition

Effects of Fe(3+) (0-0.12 g/L), Mg(2+) (0-0.73 g/L) and Ca(2+) (0-0.98 g/L) on the biomass and lipid accumulation of heterotrophic microalgae were investigated in dark environment. The biomass and lipid production exhibited an increasing trend with increasing the concentrations of metal ions. In cultures with 1.2 × 10(-3) g/L Fe(3+), 7.3 × 10(-3) g/L Mg(2+) and 9.8 × 10(-4) g/L Ca(2+), the maximum biomass, total lipid content and lipid productivity reached 3.49 g/L, 47.4% and 275.7 mg/L/d, respectively. More importantly, EDTA addition (1.0 × 10(-3) g/L) could enhance the solubility of metal ions (iron and calcium) and increase their availability by microalgae, which evidently promote the lipid accumulation. Compared with the control, the total lipid content and lipid productivity increased 28.2% and 29.7%, respectively. These show that appropriate concentrations of metal ions and EDTA in the culture medium were beneficial to lipid accumulation of heterotrophic Scenedesmus sp. cells.

Hydrogen and lipid production from starch wastewater by co-culture of anaerobic sludge and oleaginous microalgae with simultaneous COD, nitrogen and phosphorus removal

Anaerobic sludge (AS) and microalgae were co-cultured to enhance the energy conversion and nutrients removal from starch wastewater. Mixed ratio, starch concentration and initial pH played critical roles on the hydrogen and lipid production of the co-culture system. The maximum hydrogen production of 1508.3 mL L(-1) and total lipid concentration of 0.36 g L(-1) were obtained under the optimized mixed ratio (algae:AS) of 30:1, starch concentration of 6 g L(-1) and initial pH of 8. The main soluble metabolites in dark fermentation were acetate and butyrate, most of which can be consumed in co-cultivation. When sweet potato starch wastewater was used as the substrate, the highest COD, TN and TP removal and energy conversion efficiencies reached 80.5%, 88.7%, 80.1% and 34.2%, which were 176%, 178%, 200% and 119% higher than that of the control group (dark fermentation), respectively. This research provided a novel approach and achieved efficient simultaneous energy recovery and nutrients removal from starch wastewater by the co-culture system.