Brandon J. O’Neill

Self-Assembled Block Copolymer Thin Films as Water Filtration Membranes

Nanoporous membranes containing monodisperse pores of 24 nm diameter are fabricated using poly(styrene-b-lactide) block copolymers to template the pore structure. A 4 mum thin film of the block copolymer is cast onto a microporous membrane that provides mechanical reinforcement; by casting the copolymer film from the appropriate solvents and controlling the solvent evaporation rate, greater than 100 cm(2) of a thin film with polylactide cylinders oriented perpendicular to the thin dimension is produced. Exposing the composite membrane to a dilute aqueous base selectively etches the polylactide block, producing the porous structure. The ability of these pores to reject dissolved poly(ethylene oxide) molecules of varying molecular weight matches existing theories for transport through small pores.

Diffusion and flow across nanoporous polydicyclopentadiene-based membranes.

We report gas and liquid transport measurements through membranes that have 40% voids made of 14 nm pores. A reactive polylactide-polynorbornenylethylstyrene block polymer is used as a structural template in the polymerization of dicyclopentadiene during the membrane formation process. After the membrane is cast, the pore structure is formed by etching the polylactide component using dilute aqueous base. The pore structure is isotropic; therefore, there is no need for special alignment techniques. Knudsen diffusion experiments and water flow experiments show pores with a tortuosity of 1.81 and a size of 14 nm, a diameter consistent with nitrogen adsorption and small-angle X-ray scattering measurements. These membranes are effective for ultrafiltration, with molecular weight cutoffs (MWCO) consistent with theoretical predictions with no adjustable parameters. These MWCOs can be tuned by changing the size of the constituent blocks in the templating copolymer.

Tuning Acid-Base Properties Using Mg-Al Oxide Atomic Layer Deposition.

Atomic layer deposition (ALD) was used to coat γ-Al2O3 particles with oxide films of varying Mg/Al atomic ratios, which resulted in systematic variation of the acid and base site areal densities. Variation of Mg/Al also affected morphological features such as crystalline phase, pore size distribution, and base site proximity. Areal base site density increased with increasing Mg content, while acid site density went through a maximum with a similar number of Mg and Al atoms in the coating. This behavior leads to nonlinearity in the relationship between Mg/Al and acid/base site ratio. The physical and chemical properties were elucidated using scanning electron microscopy (SEM), energy-dispersive X-ray spectroscopy (EDS), powder X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), N2 physisorption, and CO2 and NH3 temperature-programmed desorption (TPD). Fluorescence emission spectroscopy of samples grafted with 1-pyrenebutyric acid (PBA) was used for analysis of base site proximity. The degree of base site clustering was correlated to acid site density. Catalytic activity in the self-condensation of acetone was dependent on sample base site density and independent of acid site density.