C. D. Martin

Evaluation of Methods for Determining Crack Initiation in Compression Tests on Low-Porosity Rocks

Laboratory testing of rocks is traditionally carried out to determine the peak strength using the ISRM Suggested Methods or other suitable standards. However, it is well known that in low-porosity crystalline rocks there are at least three distinct stages of compressive loading that can be readily identified if the stress–strain response is monitored during the loading process: (1) crack initiation, (2) unstable crack growth, i.e., crack coalescence and (3) peak strength. Crack initiation is noted as the first stage of stress-induced damage in low-porosity rocks, yet the suggested guidelines of the ISRM for compression tests make no mention of crack initiation. In addition, recent research suggests that crack initiation can be used as an estimate for the in situ spalling strength, commonly observed around underground excavations in massive to moderately jointed brittle rocks. Various methods have been proposed for identifying crack initiation in laboratory tests. These methods are evaluated using ten samples of Äspö Diorite and the results are compared with a simplified method, lateral strain response. Statistically, all methods give acceptable crack-initiation values. It is proposed that the ISRM Suggested Methods be revised to include procedures suitable for establishing the crack-initiation stress.

Evolution of In Situ Rock Mass Damage Induced by Mechanical-Thermal Loading

To understand and predict the in situ brittle rock mass damage process induced by a coupled thermo-mechanical loading, the knowledge of rock mass yielding strength, scaling relationship between laboratory and in situ and microstructure characterization is required. Difficulties have been recognized due to the seldom availability of in situ experiment and appropriate numerical methodologies. The Äspö Pillar Stability Experiment was used to monitor the evolution of rock mass damage in a pillar of rock separating two 1.75-m diameter vertical boreholes. The loading of the pillar was controlled using the in situ stresses, excavation geometry, and locally increasing the rock temperature. The induced loading resulted in a complex discontinuum process that involved fracture initiation, propagation, interaction and buckling, all dominated by a tensile mechanism. Tracking this damage process was carried out in two steps. Initially, a three-dimensional numerical model was used to generate the stresses from the excavation geometry and thermal loading. The plane strain stresses, at selected locations where detailed displacement monitoring was available, were then used to track the evolution of damage caused by these induced stresses. The grain-based discrete element modeling approach described in Lan et al. (2010), which captures the grain scale heterogeneity of the rock, was used to establish the extent of damage. Good agreement was found between the predicted and measured temperatures and displacements. The grain-based model provided new insights into the progressive failure process.