C. Van Peteghem

Immunochemical methods for rapid mycotoxin detection: evolution from single to multiple analyte screening: a review.

This review focuses on recent developments in immunochemical methods for detection of mycotoxins, with a particular emphasis on simultaneous multiple analyte determination. This includes high-throughput instrumental analysis for the laboratory environment (microtitre plate enzyme-linked immunoabsorbant assay (ELISA), different kinds of immunosensors, fluorescence polarization immunoassay, and capillary electrophoretic immunoassay), as well as rapid visual tests for on-site testing (lateral-flow, dipstick, flow-through and column tests). For each type of immunoassay, perspectives for multiple analyte application are discussed and examples cited.

Development and validation of an LC-MS/MS method for the simultaneous determination of deoxynivalenol, zearalenone, T-2-toxin and some masked metabolites in different cereals and cereal-derived food

An LC-MS/MS method was developed and validated for the simultaneous determination of deoxynivalenol, zearalenone, T-2-toxin, HT-2-toxin and metabolites, including 3-acetyldeoxynivalenol, 15-acetyldeoxynivalenol, deoxynivalenol-3-glucoside, α-zearalenol, β-zearalenol, zearalenone-4-glucoside, α-zearalenol-4-glucoside, β-zearalenol-4-glucoside and zearalenone-4-sulfate in maize, wheat, oats, cornflakes and bread. Extraction was performed with acetonitrile/water/acetic acid (79/20/1, v/v/v) followed by a hexane defatting step. After filtration, the extract was evaporated and the residue was redissolved in mobile phase for injection. The mobile phase, which consisted of a mixture of methanol and water with 10 mM ammonium acetate, was adjusted to pH 3 with glacial acetic acid. A sample clean-up procedure was not included because of the low recoveries of free and masked mycotoxins and their differences in polarity. The method allowed the simultaneous determination of 13 Fusarium mycotoxins in a one-step chromatographic run using a Waters Acquity UPLC system coupled to a Quattro Premier XE mass spectrometer. The method was validated for several parameters such as linearity, apparent recovery, limit of detection, limit of quantification, precision, expanded measurement uncertainty and specificity. The limits of detection varied from 5 to 13 ng g−1; those for the limit of quantification from 10 to 26 ng g−1. The results of the performance characteristics of the developed LC-MS/MS method were in good agreement with the criteria mentioned in Commission Regulation (EC) No. 401/2006. Thirty samples of a variety of food and feed matrices were sampled and analysed between July 2010 and January 2011.

Validation of multi-residue methods for the detection of anabolic steroids by GC-MS in muscle tissues and urine samples from cattle†

The use of anabolic steroids is prohibited in the European Community by Directive 96/22/EC and the control of compliance is regulated by Directive 96/23/EC. Multi-residue methods are necessary for screening for the use of forbidden substances. Because accreditation is gaining more and more importance, validation of the methods used and of the results obtained has become indispensable. The developed GC-MS methods for the detection of anabolic steroids in urine and muscle tissue were validated with regard to the following parameters: specificity, recovery at the 2 micrograms kg-1 level and limit of detection. For urine the recoveries ranged from 17 to 81% and for muscle tissue from 26 to 65%. The limit of detection ranged from 0.1 to 2.6 micrograms kg-1 for urine and from 0.3 to 4.6 micrograms kg-1 for muscle tissue. Specificity was guaranteed in both matrices by the selection of four specific ions. Blank samples were evaluated for interferences and it could be concluded that in no case did the four selected ions appear simultaneously at the correct retention time. The practicability of the criteria for low resolution mass spectrometry set in Decision 93/256 in the low micrograms kg-1 range is also briefly discussed.

Comparison of ochratoxin A and deoxynivalenol in organically and conventionally produced beers sold on the Belgian market

Abstract Beer was chosen as a cereal-derived and homogeneous product for a comparison of organic and conventional production methods in terms of mycotoxin contamination levels. Ochratoxin A (OTA, a storage mycotoxin) and deoxynivalenol (DON, a field mycotoxin) were assessed by HPLC in organically and conventionally produced beers sold in Belgium. Immunoaffinity column (OchraTest® and DONPrep®) purification was used prior to HPLC analysis. For in-house validation, recovery experiments, carried out with the spiked beers in the ranges of 50–200 ng OTA l−1 and 20–100 µg DON l−1, led to the overall averages of 91% (RSD = 10%, n = 9) and 93% (RSD = 5%, n = 27), respectively. Organic beers collected during 2003–2004 were more frequently OTA-contaminated (95%, n = 40) than their conventional counterparts (50%, n = 40). Conventional beers were OTA-contaminated at a mean concentration of 25 ng l−1 (range: 19–198 ng l−1), while organic beers contained a mean level of 182 ng l−1 (range: 18–1134 ng l−1). High OTA contamination above the limit of 200 ng l−1 (up to 1134 ng l−1) occasionally occurred in organically produced beers. A complementary survey performed with the same brands in 2005 did not confirm this accidental presence of excessive OTA loads (range: 3–67 ng l−1 for 10 conventional beers and 19–158 ng l−1 for 10 organic beers). Establishing a maximum of 3 µg OTA kg−1 in malt, the application of the regulation EC No. 466/2001 (entered in force before the last sampling) may be related to the observed improvement. The overall incidence of DON was 67 and 80% in conventional and organic beers, respectively. DON concentrations ranged from 2 to 22 µg DON l−1 (mean = 6 µg DON l−1) in conventional beers, while organic beers ranged from 2 to 14 µg DON l−1 (mean=4 µg DON l−1). Thus, DON in beers does not appear to be a major matter of concern. From the statistical tests, it was concluded that the variation between different batches was significant (P < 0.0001), in contrast to that observed between different brands, showing a lack of homogeneity in the raw materials. This occurs either in organically or in conventionally produced materials. Considering these results, an optimized frequency of controls according to European Regulations EC No 466/2001 and EC No 856/2005 should be recommended to reject the irregular batches.

Sensitive gas chromatographic--mass spectrometric screening of acetylated benzodiazepines.

GC-MS screening conditions were developed for 15 low-dosed benzodiazepines, covering alprazolam, flunitrazepam, flurazepam, ketazolam, lorazepam and triazolam, and the corresponding metabolites alpha-hydroxyalprazolam, 4-hydroxyalprazolam; 7-aminoflunitrazepam, desmethylflunitrazepam, 7-aminodesmethylflunitrazepam; hydroxyethylflurazepam, N-desalkylflurazepam; oxazepam and alpha-hydroxytriazolam, respectively. Benzodiazepines are analyzed on a polydimethylsiloxane column in both the scan and the multiple ion monitoring modes using on-column injection to attain maximal sensitivity. The reactive compounds are acetylated with pyridine and acetic anhydride for 20 min. The derivatives are stable for at least 4 days. The relative standard deviation observed with standard compounds at the low nanogram-level ranged from 1.13 to 4.87% within-day and from 1.12 to 4.94% between-day. Unequivocal identification potential, high chromatographic resolution and sensitivity are combined with minimal thermal degradation. The presented screening conditions provide the basis for a unique routine screening method for low-dosed benzodiazepines with a broad polarity range.

Analytical possibilities for the detection of stanozolol and its metabolites

In sports doping, as well in man as in horseracing, stanozolol (Stan) was abused and became the subject of metabolism research. Also in veterinary practice, stanozolol became an important misused anabolic steroid. Like most other anabolic steroids, stanozolol has poor gas chromatographic behavior. It is difficult to detect in urine, because of low urinary excretion and renal clearance. This is due to the rapid metabolization, leading to low concentration levels of the parent compound found in urine. Therefore, most research studies have focused on the detection of its urinary metabolites. For the identification of the metabolites, different methods of extraction and detection are described in the literature. These are reviewed in this article. Most authors use a hydrolysis to free the phase II metabolites. Extraction procedures vary from solid-phase extraction (SPE), liquid-liquid (L-L) extraction to immunoaffinity chromatography (IAC). For the final detection, the use of gas chromatography (GC)-mass spectrometry (MS) can be compared with liquid chromatography (LC)-MSn. Different metabolites are identified depending on the administration of stanozolol in the animal experiment (oral or intramuscular). Analyses for these analytes in other matrices are also briefly discussed.

Simultaneous determination of fifteen low-dosed benzodiazepines in human urine by solid-phase extraction and gas chromatography–mass spectrometry

A gas chromatographic-mass spectrometric method was developed for the simultaneous analysis of 15 low-dosed benzodiazepines, both parent compounds and their corresponding metabolites, in human urine. The target compounds are alprazolam, alpha-hydroxyalprazolam, 4-hydroxyalprazolam, flunitrazepam, 7-aminoflunitrazepam, desmethylflunitrazepam, flurazepam, hydroxyethylflurazepam, nitrogen-desalkylflurazepam, ketazolam, oxazepam, lormetazepam, lorazepam, triazolam and alpha-hydroxytriazolam. Nitrogen-methylclonazepam is used as the internal standard. The urine sample preparation involves enzymatic hydrolysis of the conjugated metabolites with Helix pomatia beta-glucuronidase for 1 h at 56 degrees C followed by solid-phase extraction on a phenyl-type column. The extracted benzodiazepines are subsequently analyzed on a polydimethylsiloxane column using on-column injection to enhance sensitivity. The extraction efficiency exceeded 80% for all compounds except for oxazepam, lorazepam and 4-hydroxyalprazolam which had recoveries of about 60%. The LODs ranged from 13 to 30 ng/ml in the scan mode and from 1.0 to 1.7 ng/ml in the selected ion monitoring (SIM) mode. Linear calibration curves were obtained in the concentration ranges from 50 to 1000 ng/ml in the scan mode and from 5 to 100 ng/ml in the SIM mode. The within-day and day-to-day relative standard deviations at three different concentrations never exceeded 15%.

Capillary electrophoresis of some tetracycline antibiotics

Abstract Data on the separation of tetracycline antibiotics by capillary electrophoresis are rather limited and have not been reported for micellar electrokinetic capillary chromatographic separation (MECC). In the present study, the separation of tetracycline, oxytetracycline and chlortetracycline by capillary zone electrophoresis and MECC was investigated. Adding non-ionic surfactants such as Triton X-100 to a 0.2 M phosphate migration buffer of pH 2.2 greatly improved separation. The use of mixed micelles enlarged the variety of the micellar phases, e.g. a combination of Tween 20 and Tween 80 provided a similar separation pattern. The addition of β-cyclodextrin to a Triton X-100 and Brij-35 surfactant combination did not result in an improved separation. A Triton X-100 and Brij-35 combination could separate tetracycline and its degradation products 4-epitetracycline (ETC), anhydrotetracycline and 4-epianhydrotetracycline. This enabled us to identify ETC in a commercial tetracycline sample.

Non-instrumental immunochemical tests for rapid ochratoxin A detection in red wine

Gel-based and membrane-based flow-through immunoassay formats were investigated for rapid ochratoxin A (OTA) detection in red wine. The flow-through set-up consisted of an antibody containing gel or membrane placed at the bottom of a standard solid-phase extraction column (i.e. the flow-through column), combined with a clean-up column. Different clean-up methods were studied for red wine clarification and purification. The optimal method consisted of passing wine, diluted with an aqueous solution containing 1% polyethylene glycol (PEG 6000) and 5% sodium hydrogencarbonate, through strong anion exchange (SAX) silica. An immunoassay for OTA detection in red wine was optimized and a cut-off level at 2 microg L(-1) according to EU legislation was achieved with both formats. A more significant colour difference between blank and spiked samples was observed for the gel-based assay making this superior to the membrane-based assay. The proposed rapid gel-based test was compared with a standard immunoaffinity column-high-performance liquid chromatography-fluorescent detection (IAC-HPLC-FLD) method and a good correlation of the results was obtained for naturally contaminated wine samples.

Incidence of residues of nine anticoccidials in eggs

A survey of the presence of residues of anticoccidials was performed. Three hundred and twenty egg samples, purchased in eight different European countries, were analysed for the presence of nine different compounds: dimetridazole, diclazuril, halofuginone, robenidine, nicarbazin, narasin, salinomycin, lasalocid and monensin. Analyses were performed by LC-MS/MS. Of the samples analysed, 114 (35.6%) contained one or more of the nine anticoccidials in concentrations ranging from 0.1 to 63 µg kg−1. Salinomycin and lasalocid account for more than 60% of all positive samples. Almost 90% of all positive samples contained less than 2 µg kg−1. Results were put into perspective of the farming method and country of origin.