Carlos A. Valdez

Encapsulated liquid sorbents for carbon dioxide capture

Drawbacks of current carbon dioxide capture methods include corrosivity, evaporative losses and fouling. Separating the capture solvent from infrastructure and effluent gases via microencapsulation provides possible solutions to these issues. Here we report carbon capture materials that may enable low-cost and energy-efficient capture of carbon dioxide from flue gas. Polymer microcapsules composed of liquid carbonate cores and highly permeable silicone shells are produced by microfluidic assembly. This motif couples the capacity and selectivity of liquid sorbents with high surface area to facilitate rapid and controlled carbon dioxide uptake and release over repeated cycles. While mass transport across the capsule shell is slightly lower relative to neat liquid sorbents, the surface area enhancement gained via encapsulation provides an order-of-magnitude increase in carbon dioxide absorption rates for a given sorbent mass. The microcapsules are stable under typical industrial operating conditions and may be used in supported packing and fluidized beds for large-scale carbon capture.

Toward a small molecule, biomimetic carbonic anhydrase model: theoretical and experimental investigations of a panel of zinc(II) aza-macrocyclic catalysts.

A panel of five zinc-chelated aza-macrocycle ligands and their ability to catalyze the hydration of carbon dioxide to bicarbonate, H(2)O + CO(2) → H(+) + HCO(3)(–), was investigated using quantum-mechanical methods and stopped-flow experiments. The key intermediates in the reaction coordinate were optimized using the M06-2X density functional with aug-cc-pVTZ basis set. Activation energies for the first step in the catalytic cycle, nucleophilic CO(2) addition, were calculated from gas-phase optimized transition-state geometries. The computationally derived trend in activation energies was found to not correspond with the experimentally observed rates. However, activation energies for the second, bicarbonate release step, which were estimated using calculated bond dissociation energies, provided good agreement with the observed trend in rate constants. Thus, the joint theoretical and experimental results provide evidence that bicarbonate release, not CO(2) addition, may be the rate-limiting step in CO(2) hydration by zinc complexes of aza-macrocyclic ligands. pH-independent rate constants were found to increase with decreasing Lewis acidity of the ligand-Zn complex, and the trend in rate constants was correlated with molecular properties of the ligands. It is suggested that tuning catalytic efficiency through the first coordination shell of Zn(2+) ligands is predominantly a balance between increasing charge-donating character of the ligand and maintaining the catalytically relevant pK(a) below the operating pH.

Evaluation of a carbonic anhydrase mimic for industrial carbon capture.

Zinc(II) cyclen, a small molecule mimic of the enzyme carbonic anhydrase, was evaluated under rigorous conditions resembling those in an industrial carbon capture process: high pH (>12), nearly saturated salt concentrations (45% K2CO3) and elevated temperatures (100-130 °C). We found that the catalytic activity of zinc cyclen increased with increasing temperature and pH and was retained after exposure to a 45% w/w K2CO3 solution at 130 °C for 6 days. However, high bicarbonate concentrations markedly reduced the activity of the catalyst. Our results establish a benchmark level of stability and provide qualitative insights for the design of improved small-molecule carbon capture catalysts.

An Efficient, Optimized Synthesis of Fentanyl and Related Analogs

The alternate and optimized syntheses of the parent opioid fentanyl and its analogs are described. The routes presented exhibit high-yielding transformations leading to these powerful analgesics after optimization studies were carried out for each synthetic step. The general three-step strategy produced a panel of four fentanyls in excellent yields (73–78%) along with their more commonly encountered hydrochloride and citric acid salts. The following strategy offers the opportunity for the gram-scale, efficient production of this interesting class of opioid alkaloids.

Predicting a Drug’s Membrane Permeability: A Computational Model Validated With in Vitro Permeability Assay Data

Membrane permeability is a key property to consider during the drug design process, and particularly vital when dealing with small molecules that have intracellular targets as their efficacy highly depends on their ability to cross the membrane. In this work, we describe the use of umbrella sampling molecular dynamics (MD) computational modeling to comprehensively assess the passive permeability profile of a range of compounds through a lipid bilayer. The model was initially calibrated through in vitro validation studies employing a parallel artificial membrane permeability assay (PAMPA). The model was subsequently evaluated for its quantitative prediction of permeability profiles for a series of custom synthesized and closely related compounds. The results exhibited substantially improved agreement with the PAMPA data, relative to alternative existing methods. Our work introduces a computational model that underwent progressive molding and fine-tuning as a result of its synergistic collaboration with numerous in vitro PAMPA permeability assays. The presented computational model introduces itself as a useful, predictive tool for permeability prediction.

Derivatization of pinacolyl alcohol with phenyldimethylchlorosilane for enhanced detection by gas chromatography–mass spectrometry

AbstractA derivatization procedure for the qualitative gas chromatography–mass spectrometry (GC-MS) analysis of pinacolyl alcohol (PA) that employs phenyldimethylchlorosilane (PhDMClS) and the promoter N-methylimidazole is described. While PA, underivatized, can be detected using conventional gas chromatographic methods, its polarity and low boiling point make its detection in complex matrices challenging. The silylation procedure described herein generates a PA-derivative exhibiting an increased on-column retention time, thus shifting its GC-MS signal away from commonly encountered, volatile, interfering analytes. Derivatized PA could be distinguished from other PhDMClS-derivatized isomeric alcohols by its unique retention time and mass spectrum. The derivatization was demonstrated to perform well in the GC-MS analysis and identification of PA in samples from Proficiency Tests administered by the Organisation for the Prohibition of Chemical Weapons (OPCW). FigureNMI-Accelerated Silylation of Pinacolyl Alcohol for GC-MS Analysis

Developing an approach for first-principles catalyst design: application to carbon-capture catalysis

An approach to catalyst design is presented in which local potential energy surface models are first built to elucidate design principles and then used to identify larger scaffold motifs that match the target geometries. Carbon sequestration via hydration is used as the model reaction, and three- and four-coordinate sp(2) or sp(3) nitrogen-ligand motifs are considered for Zn(II) metals. The comparison of binding, activation and product release energies over a large range of interaction distances and angles suggests that four-coordinate short Zn(II)-Nsp(3) bond distances favor a rapid turnover for CO2 hydration. This design strategy is then confirmed by computationally characterizing the reactivity of a known mimic over a range of metal-nitrogen bond lengths. A search of existing catalysts in a chemical database reveals structures that match the target geometry from model calculations, and subsequent calculations have identified these structures as potentially effective for CO2 hydration and sequestration.

Comparison and analysis of zinc and cobalt-based systems as catalytic entities for the hydration of carbon dioxide.

In nature, the zinc metalloenzyme carbonic anhydrase II (CAII) efficiently catalyzes the conversion of carbon dioxide (CO2) to bicarbonate under physiological conditions. Many research efforts have been directed towards the development of small molecule mimetics that can facilitate this process and thus have a beneficial environmental impact, but these efforts have met very limited success. Herein, we undertook quantum mechanical calculations of four mimetics, 1,5,9-triazacyclododedacane, 1,4,7,10-tetraazacyclododedacane, tris(4,5-dimethyl-2-imidazolyl)phosphine, and tris(2-benzimidazolylmethyl)amine, in their complexed form either with the Zn2+ or the Co2+ ion and studied their reaction coordinate for CO2 hydration. These calculations demonstrated that the ability of the complex to maintain a tetrahedral geometry and bind bicarbonate in a unidentate manner were vital for the hydration reaction to proceed favorably. Furthermore, these calculations show that the catalytic activity of the examined zinc complexes was insensitive to coordination states for zinc, while coordination states above four were found to have an unfavorable effect on product release for the cobalt counterparts.

Rapid and mild silylation of β‐amino alcohols at room temperature mediated by N‐methylimidazole for enhanced detectability by gas chromatography/electron ionization mass spectrometry

RATIONALE In this work, we expand the use of in situ activation of chloro(dimethyl)phenylsilane using N-methylimidazole (NMI) for the effective derivatization of β-aminoethyl alcohols. Due to its enhanced nucleophilic character, NMI is expected to act as an efficient activator in these reactions. METHODS The derivatization of a panel of β-aminoethyl alcohols was accomplished by reacting the analyte with chloro(dimethyl)phenylsilane in the presence of either NMI or pyridine. After the addition of chloro(dimethyl)phenylsilane, the vials were gently tumbled for 1 h at ambient temperature. The phenyldimethylsilyl derivatives were identified using gas chromatography/electron ionization mass spectrometry (GC/EI-MS). RESULTS A total of ten β-aminoethyl alcohols were successfully derivatized via in situ activation of chloro(dimethyl)-phenylsilane with NMI. Derivatization with NMI was significantly more efficient than with pyridine by a factor of 3-6 for the studied alcohols. The derivatizations in the presence of NMI were found to occur in just 1 h and were conveniently executed at ambient temperature. CONCLUSIONS The use of the nitrogenous base NMI in order to activate chloro(dimethyl)phenylsilane for the efficient silylation of a panel of β-aminoethyl alcohols has been demonstrated. The present work shows that NMI is an efficient base for the smooth derivatization of these types of alcohols. Furthermore, the installation of the bulky PDMS group onto these alcohols adds to the certainty that this is a viable approach for the installation of the more commonly employed, trimethylsilyl group. Published in 2014. This article is a U.S. Government work and is in the public domain in the USA.

NMR spectroscopic investigation of inclusion complexes between cyclodextrins and the neurotoxin tetramethylenedisulfotetramine

The binding stoichiometry, strength and structure of inclusion complexes formed between the neurotoxin tetramethylenedisulfotetramine (TETS) and both native and modified cyclodextrins (CyDs) were investigated using nuclear magnetic resonance (NMR) spectroscopy. Of all six examined cases, native β‐cyclodextrin (β‐CyD) and its chemically modified counterpart heptakis‐(2,3,6‐tris‐(2‐hydroxypropyl))‐β‐cyclodextrin (2HP‐β‐CyD) were found to associate most strongly with TETS as reflected in the magnitude of their binding constants (K = 537 ± 26 M−1 for β‐CyD and K = 514 ± 49 M−1 for 2HP‐β‐CyD). Two‐dimensional rotating‐frame Overhauser effect spectroscopy NMR experiments confirm close proximity of the TETS molecule to both β‐CyD and 2HP‐β‐CyD as intermolecular, through‐space interactions between the H3 and H5 protons located in the interior of the CyD cavity and the methylene protons of TETS were identified. Copyright