César A. Almeida

Water quality assessment, by statistical analysis, on rural and urban areas of Chocancharava River (Río Cuarto), Córdoba, Argentina

Water quality has degraded dramatically in the Chocancharava River (Río Cuarto, Córdoba, Argentina) due to point and non-point sources. This paper aims to assess spatial and temporal variations of physical and chemical parameters of the river. Six sampling sites and six sampling campaigns were developed. During the period 2007–2008, wet and dry seasons were included. A statistical analysis was carried out with 23 physical and chemical variables. Then, a new statistical analysis was carried out including the Riparian Corridors Quality Index and the physical and chemical variables (24 variables). Considering a multivariate system, analysis of variance, principal component analysis and cluster analysis were used. From the statistical analysis, the river was divided into two zones with different degrees of contamination. The most polluted zone is due to pollution inputs of urban, industrial and agricultural sources. This area showed a remarkable deterioration in water quality, mainly due to wastewater discharges. According to Riparian Quality, better results were found in sections of poor water quality, due to the fact that the river bank forest was less degraded downstream of the sewage discharge.

Determination of chemical oxygen demand by a flow injection method based on microwave digestion and chromium speciation coupled to inductively coupled plasma optical emission spectrometry

The present paper evaluates the applicability of a new FIA system for COD determination. The new system, flow injection microwave solid phase extraction by means of activated carbon (FI-MW-SPE), consists of a digestion circuit, placed in a home MW oven, coupled to an ICP-OES spectrophotometer. Doehlert experimental design was used to speed up the optimization of different experimental variables studied for assisted digestion methods. The method provided a high throughput of about 18 samples h(-1). To assess the accuracy of analytical methods linear regression, elliptic joint confidence region (EJCR) was used. A large linear range of 2.78-850 mg O(2) L(-1) with an excellent detection limit of 0.94 mg O(2) L(-1) was obtained. The interference by high chloride concentration was studied, and values below 3000 mg Cl(-) ions L(-1), allowed the estimation of COD load without any masking agents. COD values for various types of wastewater samples were correlated with those obtained by standard manual methods. Moreover, interferences due to matrix nature are absent; since matrix is washed out of the column before Cr (III) is eluted. This method reduces the time, reagent volume, hazardous emission, external contamination, with a good reproducibility and accuracy.

A recreational water quality index using chemical, physical and microbiological parameters

PurposeThe aim of this paper was to develop a new recreational water quality index (RWQI) as a tool to ensure the health of swimmers and to take practical decisions.MethodsRWQI was elaborated with epidemiological data, and we carried out an exhaustive study of the different guidelines for recreational waters proposed by different organisations around the world. Different parameters were chosen, considering, as a priority, the swimmer’s contact and the possibility of ingestion of water during the recreational activity. Furthermore, rating curves were established for pH, chemical oxygen demand, nitrate, phosphate, detergents, enterococci, total coliforms, faecal coliforms and Escherichia coli.Results and conclusionsThe index was applied to the data set on water quality of the Potrero de los Funes River (San Luis, Argentina), generated during 2 years (2009–2010). Following the RWQI values classification, most of the Potrero de los Funes water samples fell in the good quality range during the study period.

Multielemental analysis in vegetable edible oils by inductively coupled plasma mass spectrometry after solubilisation with tetramethylammonium hydroxide.

Trace metals have negative effects on the oxidative stability of edible oils and they are important because of possibility for oils characterisation. A single-step procedure for trace elemental analysis of edible oils is presented. To this aim, a solubilisation with tetramethylammonium hydroxide (TMAH) was assayed prior to inductively coupled plasma mass spectrometry detection. Small amounts of TMAH were used, resulting in high elemental concentrations. This method was applied to edible oils commercially available in Argentine. Elements present in small amounts (Cu, Ge, Mn, Mo, Ni, Sb, Sr, Ti, and V) were determined in olive, corn, almond and sunflower oils. The limits of detection were between 0.004 μg g(-1) for Mn and Sr, and 0.32 μg g(-1) for Sb. Principal components analysis was used to correlate the content of trace metals with the type of oils. The two first principal components retained 91.6% of the variability of the system. This is a relatively simple and safe procedure, and could be an attractive alternative for quality control, traceability and routine analysis of edible oils.

Development of nitrocellulose membrane filters impregnated with different biosynthesized silver nanoparticles applied to water purification

Bactericidal water filters were developed. For this purpose, nitrocellulose membrane filters were impregnated with different biosynthesized silver nanoparticles. Silver nanoparticles (AgNPs) from Aspergillus niger (AgNPs-Asp), Cryptococcus laurentii (AgNPs-Cry) and Rhodotorula glutinis (AgNPs-Rho) were used for impregnating nitrocellulose filters. The bactericidal properties of these nanoparticles against Escherichia coli, Enterococcus faecalis and Pseudomona aeruginosa were successfully demonstrated. The higher antimicrobial effect was observed for AgNPs-Rho. This fact would be related not only to the smallest particles, but also to polysaccharides groups that surrounding these particles. Moreover, in this study, complete inhibition of bacterial growth was observed on nitrocellulose membrane filters impregnated with 1 mg L(-1) of biosynthesized AgNPs. This concentration was able to reduce the bacteria colony count by over 5 orders of magnitude, doing suitable for a water purification device.

Batch leaching tests of motherboards to assess environmental contamination by bromine, platinum group elements and other selected heavy metals

In this study, a batch leaching test was executed to evaluate the toxicity associated with chemicals contained in motherboards. The leaching solutions used were distilled water, nitric acid, acetic acid and synthetic acid rain solution. A total of 21 elements including Ag, As, Au, Br, Cd, Co, Cr, Cu, Hf, Ir, Mn, Ni, Os, Pb, Pd, Pt, Rd, Rh, Se, U and Zn were analyzed. In this study, the pH values of all the leachates fell within the range of 2.33-4.88. The highest concentrations of metals were obtained from the acid rain solution, whilst the maximum value of bromine was achieved with solution of acetic acid. Appreciable concentrations of platinum group elements were detected with concentrations around 3.45, 1.43, 1.21 and 22.19 µg L(-1) for Ir, Pd, Pt and Rh, respectively. The different leaching of the motherboards revealed the predominant presence of the toxic substances in the leached from the e-waste.

Immune and biochemical responses in hemolymph and gills of the Patagonian freshwater mussel Diplodon chilensis, against two microbiological challenges: Saccharomyces cerevisiae and Escherichia coli

Immune cell characterization, immunological response and the associated gill oxidative balance were studied in the Patagonian freshwater mussel, Diplodon chilensis, using two microbiological immunostimulant models: Saccharomyces cerevisiae and Escherichia coli. Mussels were collected out of the breeding season in Paimún Lake and acclimated in the laboratory. Two exposure experiments were performed during two consecutive weeks: (1) mussels challenged with 500 yeast cells mL-1; and (2) mussels challenged with 1000 bacteria cells mL-1. Microorganisms were added in the water every two days, alternating with 6000 lyophilized cells of the green algae Scenedesmus vacuolatus mL-1. A control group, fed with S. vacuolatus, was set for each treatment. Morphological cell characterization was carried out in adherent hemocytes of D. chilensis hemolymph under control conditions. The most important cell type observed were the hyalinocytes (representing ca. 98% of the circulating cells), agranular cells with non-central polymorphic nucleus surrounded by cytoplasm; granulocytes (cells with cytoplasmic granules and non-central rounded nucleus) represented ca. 2%. Another two cell types were occasionally detected, binucleated hyalinocytes and hemoblast-like cells but were not considered for the analyses. Both adherent hyalinocytes and granulocytes exhibit phagocytic activity towards Congo red stained yeast, which was two-fold higher in granulocytes than in hyalinocytes, regardless of the applied challenge. Total hemocyte counts were diminished in mussels challenged with S. cerevisiae or E. coli. Hydrolytic and defense cellular enzyme activities were analyzed only for hyalinocytes. Both, S. cerevisiae and E. coli increased acid phosphatase activity. E. coli challenge diminished hemocyte lysosomal membrane stability and increased humoral phenoloxidase activity, while S. cerevisiae challenge did not affect any of these variables. Mussels challenged with E. coli showed increased gill antioxidant response without oxidative damage, while those challenged with S. cerevisiae showed no change in these variables.

Cadmium-induced oxidative damage and antioxidant defense mechanisms in Glycine max L.

Fil: Felici, Emiliano. Consejo Nacional de Investigaciones Cientificas y Tecnicas. Centro Cientifico Tecnologico San Luis. Instituto de Quimica de San Luis; Argentina. Universidad Nacional de San Luis; Argentina