Cezary Polakowski

Influence of the Sand Particle Shape on Particle Size Distribution Measured by Laser Diffraction Method

Abstract The aim of this paper was to show how the shape of sand particles affects the results of particle size distribution obtained by the laser diffraction method. On the basis of the results obtained one can conclude: the shape of the investigated particles influences particle size distribution obtained by the laser diffraction method. This phenomenon occurs in the sand fraction, as shown in our investigation. The importance of this effect depends on the type of the measured material and on the aim of the investigations. For most researchers in soil science and sedimentology who investigate sand fractions, this impact can be negligible. Further investigations with other soil and sediment fractions are needed.

Kinetics of methane oxidation in selected mineral soils

Abstract The kinetic parameters of methane oxidation in three mineral soils were measured under laboratory conditions. Incubationswere preceded by a 24-day preincubationwith 10%vol. of methane. All soils showed potential to the consumption of added methane. None of the soils, however, consumed atmospheric CH4. Methane oxidation followed the Michaelis-Menten kinetics, with relatively low values of parameters for Eutric Cambisol, while high values for Haplic Podzol, and especially for Mollic Gleysol which showed the highest methanotrophic activity and much lower affinity to methane. The high values of parameters for methane oxidation are typical for organic soils and mineral soils from landfill cover. The possibility of the involvement of nitrifying microorganisms, which inhabit the ammonia-fertilized agricultural soils should be verified.

The first report of the physicochemical structure of chitin isolated from Hermetia illucens.

This is the first report on the physicochemical properties of chitin obtained from larvae and imagoes of black soldier flies (Hermetia illucens). Scanning electron microscopy revealed differences in surface morphologies of the two types of chitin. The crystalline index values of chitins from adult flies and larvae were 24.9% and 35%, respectively. This is a trait that differentiates these biopolymers from chitins extracted from other sources described so far. X-ray diffraction patterns and IR spectroscopy revealed that both types of samples of chitin were in an α crystalline form. Also, the results of elemental analysis, thermal stabilities and FTIR spectroscopy of the chitins from larvae and adults of H. illucens were similar, which points to a general similarity in their physicochemical structure.

Effect of Soil Moisture Content on the Splash Phenomenon Reproducibility

One of the methods for testing splash (the first phase of water erosion) may be an analysis of photos taken using so-called high-speed cameras. The aim of this study was to determine the reproducibility of measurements using a single drop splash of simulated precipitation. The height from which the drops fell resulted in a splash of 1.5 m. Tests were carried out using two types of soil: Eutric Cambisol (loamy silt) and Orthic Luvisol (sandy loam); three initial pressure heads were applied equal to 16 kPa, 3.1 kPa, and 0.1 kPa. Images for one, five, and 10 drops were recorded at a rate of 2000 frames per second. It was found that (i) the dispersion of soil caused by the striking of the 1st drop was significantly different from the splash impact caused by subsequent drops; (ii) with every drop, the splash phenomenon proceeded more reproducibly, that is, the number of particles of soil and/or water that splashed were increasingly close to each other; (iii) the number of particles that were detached during the splash were strongly correlated with its surface area; and (iv) the higher the water film was on the surface the smaller the width of the crown was.

Impact of optical indices on particle size distribution of activated sludge measured by laser diffraction method

Abstract The important factors that strongly influence the particle size distributions measured by the laser diffraction method are the optical parameters of the suspension (refractive index and absorption coefficient). Knowledge of the values of these parameters is necessary for Mie theory. Mie theory is applied for conversion of the intensity of light recorded on detectors into particle size distribution (PSD) of tested material. Both wastewater and activated sludge are mixtures of a variety of elements (mineral or organic, including living organisms). In practice, it is not possible to define clearly the values of the optical parameters, as the composition of the suspension changes over time. The aim of the study was to estimate the impact of assumed values of the optical parameters on particle size distributions obtained. The PSDs of suspensions sampled in different stages of wastewater treatment are the most reproducible when the following optical parameters are defined: absorption coefficients - 1.0 and the refractive index - 1.52. Abstrakt Czynnikami, które w istotny sposób wpływają na rozkłady granulometryczne wyznaczane za pomocą dyfrakcji laserowej, są parametry optyczne mierzonej zawiesiny (współczynnik załamania światła oraz współczynnik absorpcji). Znajomość wartości tych parametrów jest niezbędna przy zastosowaniu teorii Mie. Teoria Mie jest wykorzystywana do przeliczenia intensywności światła zmierzonego na detektorach na rozkład granulometryczny (PSD) badanego materiału. Zarówno ścieki, jak i osad czynny są mieszaninami bardzo różnych składników (mineralnych i organicznych, w tym żywych organizmów). W praktyce nie ma możliwości określenia rzeczywistych wartości parametrów optycznych mieszanin, tym bardziej, że ich skład zmienia się w czasie. Celem niniejszej pracy było określenie wpływu założonych wartości parametrów optycznych na uzyskiwane rozkłady granulometryczne. Rozkłady granulometryczne zawiesin pobranych na różnych etapach oczyszczania ścieków są najbardziej powtarzalne dla następujących wartości współczynników optycznych: współczynnika absorpcji - 1,0 i współczynnika załamania światła - 1,52.

The differences in crown formation during the splash on the thin water layers formed on the saturated soil surface and model surface

Splash is the first stage of a negative phenomenon–soil erosion. The aim of this work was to describe the crown formation quantitatively (as part of the splash erosion) and compare the course of this phenomenon on the thin water film formed on a smooth glass surface and on the surface of saturated soil. The height of the falling water drop was 1.5 m. The observation of the crowns was carried out by high-speed cameras. The static and dynamic parameters of crown formation were analysed. It was found that the crowns formed on the water film covering the saturated soil surface were smaller and the time intervals of their existence were shorter. In addition, the shapes of the crowns were different from those created on the water layer covering the glass surface. These differences can be explained by the slightly different values of surface tension and viscosity of the soil solution, the greater roughness of the soil surface and the lower thickness of the water film on the soil surface.

Hermetia illucens as a new and promising species for use in entomoremediation

This study investigated the use of Hermetia illucens (black soldier fly - BSF) larvae as a new species for use in entomoremediation. The H. illucens larvae effectively reduced the dry mass of polluted corn leaves by an average of 49% after 36days for both Cd and Zn (50mg·kg-1), which is a better result than that, which can be obtained by one of the standard proposed pretreatments for biomass polluted after phytoextraction: composting. The presence of heavy metals did not significantly affect the dry mass utilization efficiency. Based on this, we proposed the use of H. illucens as a new post-harvest management method of phytoextraction-polluted biomass. Cadmium mostly accumulates in the puparium, while Zn accumulates in the adults. The high Cd content in the puparium further creates possibility of its application in the metal recovery process. It is also proposed that the general definition of entomoremediation be expanded.