Chang-Doo Park

Development and physical properties on the monofilament for gill nets and traps using biodegradable aliphatic polybutylene succinate resin

This study was aimed not only to develop the gill net and trap made of biodegradable monofilaments in order to prevent a ghost fishing and to protect marine ecosystem, but also to analyze their spinning process and physical properties. Results showed that the spinning speed of biodegradable polybutylene succinate(PBS) monofilament was estimated to be approximately 100m/min when spinning temperature and cooling water temperature were adjusted at and , respectively. The breaking loads of PBS monofilaments were estimated to be at , at , and at in the dry condition, respectively. However, its breaking loads in the wet condition were reduced by 2.4-5.5%, compared to those in the dry condition. The knotted strength of PBS monofilament at was estimated to be 98.6% of PE in the dry condition. The breaking load of PBS monofilament at was evaluated to be 81.8% of PA, and its softness showed 3 times less than that of PA in the wet condition. The breaking load of PBS monofilament at was 95.3% of PA, and its softness showed 1.6 times less than that of PA in the wet state. However, the load elastic elongations of two kinds of monofilaments were estimated to be 1% higher than that of PA.

Effect of tooth spacing on the contact selection and available selection of a dredge for the equilateral Venus clam Gomphina melanaegis

The effect of various tooth spacing on the contact selection and the net-mouth available selection of a dredge for the equilateral Venus clam Gomphina melanaegis is evaluated by applying a contact-probability model based on the SELECT method to the data of paired-gear tests with a control dredge of 12-mm tooth spacing and four test dredges of tooth spacing 16, 20, 24 and 35 mm. A master selection curve was estimated to be s(R)=exp(−11.23R+4.799)/(1+exp[−11.23R+4.799]) where, R is l/d, the ratio of the shell length, l, to the tooth spacing, d. The shell width of 50% retention was slightly smaller than the tooth spacing, which means that size selectivity of teeth was a type of contact selection which was dependent on the tooth spacing. Contact probability, δ, of the clams coming into contact with the teeth were 0.625, 0.467, 0.563, 0.670 and 0.976 for tooth spacing 12, 16, 20, 24 and 35 mm, respectively. This indicates that some clams entered the dredge bagnet without contacting the teeth as the sand clogging the tooth spacing carried them into the bagnet. Available selection curve of the dredge net-mouth with teeth was obtained as δ s(R)+1−δ, and examined in terms of the legal landing size of the Venus clam.

Fishing power estimation of biodegradable traps in the East Sea

For an effective management of fisheries resources, it is very important that to make clean inhabitation environment and to preserve fisheries resources. The material which is mainly used as fishing gear in modern times, is polyethylene, polypropylene, polyamide, etc., chemical fiber. And lost fishing gears which are make of these, occur ghost fishing and ocean pollution. To solve these problem, we development biodegradable fishing trap using the polybutylene succinate (PBS). Developed traps are for red snow crab (Chionoecetes japonicus) and shrimp, major traps in the East Sea, and we carried out fishing research using two kind traps in the coastal sea of Ayajin-port (Goseong) to analysis fishing efficiency of PE trap and PBS trap. As a result for fishing experiment (year 2005-2006) of red snow crab trap, two kind traps were almost the same in catches and length composition. During a experiment, parts of meshes, used for over 1 year, were cut by biodegradation. As a result for fishing experiment (year 2007) of shrimp trap, northern shrimp (Pandalus eous), coonstripe shrimp (Pandalus hypsinotus) and morotoge shrimp (Pandalopsis japonica) were catched, and the almost is northern shrimp. Two kind traps were almost the same in catches and length composition. In accordance with these result, it is recommended that the developed traps are have to commercialized because the fishing powers of PE traps and PBS traps were same. But biodegradation speed is have to controled in consideration of ocean microorganism volume and traps life.

Mesh Selectivity of Durm Net Fish Trap for Elkhorn sculpin(Alcichthys alcicornis) in the Eastern Sea of Korea

The mesh selectivity of the drum net fish trap for elkhorn sculpin(Alcichthys alcicornis) in the estern sea of Korea was described. The selection curve for the elkhorn sculpin caught from the experiments between June 2003 and December 2003 was by SELECT(Share Each Length Class`s Catch Total)model and by Kitahaa`s method to a polynomial equation and two parameter logistic selection curve. The selection curve by SELECT model showed to be equal probability of entrance of the elkhorn sculpin in the large(55mm) and small(20mm) mesh traps by minimum AIC (Akaike Information Criteria). The equation of selectivity curve obtained by Kitahara`s method using a logistic function with least square method was

Species composition and cluster analysis of the communities caught by dredge in relation to tooth spacing and mesh size in the coastal waters of Gangneung, Korea

s(R)\;

Relative efficiency of monofilament and multifilament nylon gill net forMarbled sole (Pleuronectes yokohamae) in the western sea of Korea

The dredge gear is dragged along the bottom of the sea to catch targeted edible bottom dwelling species. Species composition and ecological index of the catches of dredge were estimated around Gangneung coastal fishing ground by dredge with different mesh size and tooth space from July to December 2013. Eight different types of dredge including four different tooth space (24.7 mm, 29.9 mm, 34.9 mm, 40.1 mm) and four different mesh size(15.5 mm, 32.7 mm, 51.1 mm, 60.0 mm) were used in the experiment. During the experiment, total catches were collected 31 species as sipunculida 1 species, mollusca 13 species, annelida 3 species, arthropoda 8 species, echinodermata 4 species and others 2 species. The dominant genus were mollusca and echinodermata while the dominant species were Megangulus venulosus, Pseudocardium sachalinensis, Schaphechinus brevis. The richness index was ranged 1.29-1.72, evenness index was 0.6-0.65 and diversity index was 1.65-1.83 according to the tooth space and mesh size of dredge. Richness index, diversity index were high at tooth space 34.9 mm dredge and ecological index showed decreasing tendency with the increasing of mesh size of dredge. Cluster and MDS analysis, based on a Bray-Curtis and similarity matrix of fourth root transformed data of number of species and wet weight, showed division into four different groups as four different tooth space (Group A), four different mesh size Group B (51.1 mm, 60.0 mm), Group C (32.7 mm) and Group D (15.5 mm).

The characteristics of the flow field around canvas kite using the CFD

To estimate the mesh selectivity of monofilament and multifilament gill net for Marbled sole, Pleuronectes yokohamae, the field testes were carried out 12 times with five different mesh sizes (86.6, 101.0, 121.2, 137.7, 151.5mm) in the western sea of Korea, 2007-2009. The master curve of selectivity was estimated by the extended Kitahara`s method. In the field testes, the total number of species and catch were 26 and 987, respectively. The catch number of marbled sole was 728 and occupied 73.8% in total catch. The optimum values of l/m for 1.0 of retention probability in monofilament and multifilament gill net were estimated 0.288 and 0.307, respectively and l/m was estimated to be 0.189, 0.203, 0.213, 0.222 and 0.230 in case of monofilament gill net and 0.171, 0.191, 0.205, 0.216 and 0.227 in case of multifilament gill net when the retention probability were 0.1, 0.2, 0.3, 0.4 and 0.5, respectively. The 0.5 selection range of multifilament gill net was wider about 1.5 times than that of monofilament gill net according as multifilament gill net was 0.216 and monofilament gill net was 0.148. So the multifilament gill net has a low selectivity than that of the monofilament gill net. To estimate the optimum mesh size on first maturity length 19.5cm of marbled sole, the retention probability value of 0.1 was adopted in consideration of using the gill net for marbled sole at present. The optimum mesh size were estimated to be 103.2mm and 114.0mm in monofilament gill net and multifilament gill net, respectively, on first maturity length 19.5cm of marbled sole.

Size selectivity of the dome-shaped pot for whelk Buccinum opisthoplectum in the eastern coastal waters of Korea

This research aims at establishing the fundamental characteristics of the kite through the analysis of the flow field around various types of kites. The approach of this study were adopted for the analysis; visualization by CFD(computational fluid dynamics). Also, the lift/drag and PIV(particle image velocimetry) tests of kites had been performed in our previous finding. For this situation, models of canvas kite were designed by solidworks(design program) for the CFD test using the same conditions as in the lift/drag tests. And we utilized FloWorks as a CFD analysis program. The results obtained from the above approach are summarized as follows: According to comparison of the measured and analyzed results from mechanical tests, PIV and CFD test, the results of all test were similar. The numerical results of lift-coefficient and drag-coefficient were 5-20% less than those of the tests when attack angle is . In particular, it showed the 20% discrepancy at . The numerical results of the ratio of drag and lift were 8-13% less than those of the tests at and 10% less than those of the tests at . Pressure distribution gradually became stable at . In particular, the rectangular and triangular types had the centre of the high pressure field towards the leading edge and the inverted triangular type had it towards the trailing edge. The increase of the attack angle resulted in the eddy in order of the rectangular, triangular and inverted triangular type. The magnitude of the eddy followed the same order. The effect of edge-eddy was biggest in the triangular type followed by the rectangular and then the inverted triangular type. The action point of dynamic pressure as a function of the attack angle was close to the rear area of the model with the small attack angle, and with large attack angle, the action point was close to the front part of the model.

A Study on a Bycatch of the Gape Net in Jindo Area of Jeollanam-do

Fishing experiments were carried out in the adjacent sea of Yeongil Bay, the eastern cost of Korea from 2003 to 2004 using the dome-shaped pots with different five mesh sizes (17.1, 24.8, 35.3, 39.8, and 48.3mm) in order to determine the size selectivity of pots for the whelk, Buccinum opisthoplectum. The catch species were composed of Buccinum opisthoplectum (45.4%), Buccinum striatissimum (30.1%), Pandalopsis japonica (9.3%), Chionoecetes opilio (8.9%), and so on. The shell height (l) of Buccinum opisthoplectum caught in the experimental fishing pots was measured. The SELECT (Share Each Length`s Catch Total) analysis method was applied with fishing data to obtain master selection curve. The model with the estimated split parameter was found to fit the catch data best. The master selection curve was estimated to be s (R)〓exp (7.833R-10.871)/[1 + exp (7.833R-10.871], where R is the ratio of shell height to mesh size. The relative shell length for 50% retention was 1.388, and the selection range was 0.281. It means that the pots of larger mesh size allow more whelks of small size to escape.

The performance of a wedge type jellyfish excluder device inserted in a trawl net

In order to survey the conditions of bycatch and discards for a gape net, a series of filed surveys was carried out total 10 surveys on two gape nets operated in the coastal area of Jindo during July to November 2008. The all catches in each survey were measured the body length, weight after sorted species. The analysis of catch data was conducted to separate `first operation` and `general operation`. In this study, the first operation defined as hauling the fishing gears that soaked over 10 hours because of setting on the previous day. The general operation means the haul of fishing gears conducted at intervals of one of or two hours after first operation. The bycatch in this study is defined as the other species except for anchovy, and bycatch rate refers to the proportion of bycatch to total catch. From the survey results, the average bycatch rates on first operations were 50% and 51% for Masa-ri and Supum-ri areas in Jindo, respectively. Also, the average bycatch rates on general operation were 2% and 3% for Masa-ri and Supum-ri areas in Jindo, respectively. The proportion of anchovy to total catch caught represented 75.5%. It needs the research on the selective fishing technology to reduce the bycatch on the gape net fishery.