Chien Hsiang Chang

Removal of copper ions and dissolved phenol from water using micellar-enhanced ultrafiltration with mixed surfactants ☆

A laboratory study was conducted to evaluate the effects of composition and concentration of mixed anionic/nonionic surfactants on the efficiency of a micellar-enhanced ultrafiltration (MEUF) operation in removing metal ions/organic solutes from aqueous solutions. Based on the analysis of surface tensions and micelle sizes, it was found that for mixed sodium dodecylsulfate (SDS)/Triton X-100 surfactants, the critical micelle concentration (cmc) was significantly lower than that of SDS and mixed micelles formed. The mixed surfactant system was then applied in a cross-flow mode of MEUF, in which the concentration polarization can be neglected, to remove Cu2+ from aqueous solutions. With a surfactant concentration of 10 mM, the Cu2+ rejection was negligible by using pure Triton X-100 and increased with increasing SDS mole fraction with a value as high as 85%, which suggests that the rejection of Cu2+ was due to the electrostatic attraction between Cu2+ and SDS. Furthermore, pronounced Cu2+ rejection was obtained for a 5 mM SDS solution, which was attributable to a decrease in the cmc of SDS by the existence of Cu2+. When the MEUF technique was applied to remove Cu2+ and phenol simultaneously from aqueous solutions, the Cu2+ rejection was slightly enhanced in the presence of phenol. However, the rejection of phenol was comparatively low, approximately 27%, which may be caused by its relatively hydrophilic characteristic.

Early intratracheal instillation of budesonide using surfactant as a vehicle to prevent chronic lung disease in preterm infants: A pilot study

OBJECTIVE. Budesonide is an inhaled steroid with a strong topical effect but with minimal systemic effects; it has been effectively delivered to animal lungs using surfactant as a vehicle. The purposes of this study were to determine whether early intratracheal instillation of budesonide using surfactant as a vehicle would improve pulmonary status, reduce mortality, and reduce chronic lung disease morbidity. PATIENTS AND METHODS. We conducted a prospective, randomized blind trial in 116 very low birth weight infants (<1500 g) who had severe radiographic respiratory distress syndrome and required mechanical ventilation with fraction of inspired oxygen ≥0.6 shortly after birth: 60 were in the treated group (intratracheal instillation of a mixture of 0.25 mg/kg of budesonide and 100.00 mg/kg of survanta, every 8 hours) and 56 were in the control group (100 mg/kg of survanta only, every 8 hours). The end point assessment was the number of infants who would die or develop chronic lung disease at 36 weeks’ postconceptional age. RESULTS. Infants in the treatment group required significantly lower mean airway pressure on day 1 and day 3 and had significantly lower oxygen index and Pco2 during the first 3 days than infants in the control group. More infants were extubated in the treatment group than controls at 1 and 2 weeks. The combined outcome of deaths or chronic lung disease was significantly lower in the treatment group than in the control group (19 of 60 vs 34 of 56). No clinically significant adverse effects were observed during the study. CONCLUSIONS. This pilot study indicated that early postnatal intratracheal instillation of budesonide using surfactant as vehicle significantly improved the combined outcome of death or chronic lung disease in small premature infants without causing immediate adverse effects. The results are encouraging, and a large sample multicenter trial is warranted.

Thermodynamic behavior and relaxation processes of mixed DPPC/cholesterol monolayers at the air/water interface

Abstract This study investigated the thermodynamic behavior and relaxation processes of mixed DPPC/cholesterol monolayers at the air/water interface at 37°C. Surface pressure–area isotherms and relaxation curves for the mixed monolayers were obtained by using a computer-controlled film balance. In the thermodynamic analysis of the mixed monolayers, the areas of monolayers exhibited negative deviations from the ideal values at all compositions for lower surface pressures. However, at higher surface pressures, distinctively positive deviations from ideality were observed at lower DPPC contents. Excess free energies of mixing had been calculated and the most stable state of the mixed monolayer with xDPPC=0.5 or 0.6 was found. Moreover, the relaxation kinetics of the mixed monolayers was investigated by measuring the surface area as a function of time at a constant surface pressure of 40 mN m−1. It was shown that the relaxation processes could be described by the models considering nucleation and growth mechanisms.

Techniques to measure dynamic surface tension

Recent developments of techniques used to measure dynamic surface tension aim at incorporating measurements during area changes, and improving speed of measurements, automation, and range of time scales (≤ 1 ms). New techniques incorporate better definition of surface age and of the flow field, before or during measurements. They point to truly dynamic measurements, where the transient interface shape is rigorously analyzed in terms of the flow, pressure, and concentration fields.

Influence of pH on the stability of oil-in-water emulsions stabilized by a splittable surfactant

Abstract A laboratory study was conducted to evaluate the effect of pH on the stability of oil-in-water emulsions stabilized by a commercial splittable surfactant Triton SP-190 by comparison with the results obtained by a common surfactant Triton X-100. The emulsion stability was explored by measuring the volume of oil phase separated and the size of the dispersed droplets. It was found that the addition of inorganic acids did not significantly affect the stability of emulsions stabilized by Triton X-100, but had a profound influence on the stability of emulsions stabilized by Triton SP-190. Moreover, the droplet size of a Triton X-100-stabilized emulsion and its dynamic interfacial activity were insensitive to acids. However, at lower pH the droplet size of the emulsions stabilized by Triton SP-190 was considerably increased. From the dynamic interfacial tension measurements the dynamic interfacial activity of Triton SP-190 at the oil/water interface was found to be strongly inhibited by the addition of acids, resulting in a slower decreasing rate of dynamic interfacial tension. The results demonstrate that the dramatic destabilization of Triton SP-190-stabilized emulsions could be realized by the use of acids, which evidently changed the interfacial properties of the surfactant and resulted in a higher coalescence rate of oil droplets.

Langmuir monolayer of artificial pulmonary surfactant mixtures with an amphiphilic peptide at the air/water interface: Comparison of new preparations with surfacten (Surfactant TA)

Interfacial behavior was studied on the pulmonary lipid mixture containing a newly designed amphiphilic alpha-helical peptide (Hel 13-5) that consists of 13 hydrophobic and 5 hydrophilic amino acid residues. Moreover, the data obtained were compared with those of commercially available Surfacten (Surfactant TA) which has been clinically used for neonatal respiratory distress syndrome (NRDS) in Japan. Surface pressure (pi)-A and surface potential (DeltaV)-area (A) isotherms were measured for our synthetic preparations and Surfacten. Herein, a mixture of dipalmitoylphosphatidylcholine (DPPC)/egg-phosphatidylglycerol (PG)/palmitic acid (PA) (68:22:9 by weight) was used as the constituent of basic preparations. Monolayers were spread on 0.02 M Tris buffer (pH 7.4) with 0.13 M NaCl at the air/liquid interface, and the surface behavior was investigated by employing the Wilhelmy method, an ionizing electrode method, and fluorescence microscopy (FM). Cyclic compression and expansion isotherms of the prepared materials (or products) (DPPC/PG/PA/Hel 13-5) were examined to confirm the spreading and respreading ability. For the prepared products, a plateau region exists on pi-A and DeltaV-A isotherms at approximately 42 mN m(-1), indicating that Hel 13-5 is squeezed out of surface monolayers together with fluid components (PG) upon lateral compression. That is, the squeeze-out phenomenon induces a 2D-3D phase transformation. In particular, the inclination of the pi-A isotherms at X(Hel 13-5) = 0.1 in the plateau region was almost zero irrespective of the molecular area. As proposed in the earlier report (Nakahara, H.; Lee, S.; Sugihara, G.; Shibata, O. Langmuir 2006, 22, 5792-5803), an observed refluorescence phenomenon was discussed for FM measurements. This phenomenon provides evidence of the squeeze-out motion with fluid molecules. Furthermore, the cyclic pi-A and DeltaV-A isotherms show larger hysteresis areas and better respreading abilities in comparison with the previous ternary systems (DPPC/PG/Hel 13-5 and DPPC/PA/Hel 13-5) that are very important properties in pulmonary functions. FM photographs and the temperature dependence of pi-A and DeltaV-A isotherms suggest that the phase behavior of the present preparation product is very similar to that of Surfacten in terms of the domain size and in parameters such as collapse pressures, maximum DeltaV values, and so on. These results demonstrate that PG and PA even in the present preparations work well for compression-expansion cycling as is the case in the previous ternary systems, and the present preparations show comparable properties to Surfacten in vitro.

Effects of sensing temperature on the gas sensing properties of copper phthalocyanine and copper tetra-tert-butyl phthalocyanine films

Abstract Copper phthalocyanine (CuPc) and copper tetra-tert-butyl phthalocyanine (CuTTBPc) were vacuum deposited onto alumina substrates. The surface morphology and crystalline structures of the films prepared by the two compounds were studied first. These films were then used for the experiments of NO2 sensing. The effects of gas sensing temperature, as well as the NO2 concentration, on the sensing properties were studied for both films. The experimental results show that both CuPc and CuTTBPc films exhibit fine-grain morphology and low crystallinity. Due to the tetra-tert-butyl (ttb) substitution on the periphery of phthalocyanine, CuTTBPc film has a larger lattice spacing, higher film resistance, and a higher recovery ratio in the NO2 sensing experiments. On the contrary, the response rate and sensitivity of a CuPc film are superior to that of a CuTTBPc film. By varying the sensing temperature, it was found that the elevation of sensing temperature can improve the sensing response, recovery ratio, and sensitivity of the sensing films. At high concentrations of NO2, a longer response time is required and the recovery ratio becomes smaller. In addition, the disadvantage caused by the elevation of NO2 concentration can also be improved by using an elevated sensing temperature.

Flow cytometric characterization of interactions between U-937 human macrophages and positively charged catanionic vesicles

Catanionic vesicles are considered a potential alternative to liposomes for drug delivery systems because of their greater stability and lower cost. Before using catanionic vesicles in vivo, their interactions with macrophages must be fully understood because they are primarily removed from circulation by the macrophages of the mononuclear phagocyte system. Using flow cytometry, we examined the intracellular responses-reactive oxygen species (ROS) content, mitochondrial membrane potential, cell size and complexity, and cell cycle profiles-in U-937 human macrophages treated with positively charged catanionic vesicles. Kinetic hydrogen peroxide production initially increased at lower concentrations (4-10nM) but declined at higher concentrations (40 nM and 80 nM) over the entire incubation period. Superoxide content generation, however, increased over the entire concentration range and incubation period. Catanionic vesicles decreased mitochondrial membrane potential for every concentration after 4h of incubation but caused a significant fluctuation in mitochondrial membrane potential at 6h. After 6h of incubation, catanionic vesicles produced more changes in cell size and complexity than after 4h. The increase in the subG1 population of cells treated with catanionic vesicles at higher doses indicated that apoptosis progressed. Positively charged catanionic vesicles induced different activated patterns of ROS generation and changes in mitochondrial membrane potential than did cationic liposomes. The nature of the interactions between macrophages and catanionic vesicles is of great importance for the design of safer and more effective delivery systems for macrophages. Our findings contribute to a better understanding of the molecular action of catanionic vesicles in the cellular system.

On the interaction of dipalmitoyl phosphatidylcholine with normal long-chain alcohols in a mixed monolayer: a thermodynamic study

Abstract This study investigated the mixed monolayer behavior of dipalmitoyl phosphatidylcholine (DPPC) with normal long-chain alcohols at the air/water interface. Surface pressure–area isotherms of mixed DPPC/C18OH and DPPC/C20OH monolayers at 37°C were obtained and compared with previous results for the mixed DPPC/C16OH system. The negative deviations from additivity of the areas and the variation of the collapse pressure with composition imply that DPPC and long-chain alcohols were miscible and formed non-ideal monolayers at the interface. At lower surface pressures, it seems that the attractive intermolecular force was dominant in molecular packing in the mixed monolayers. At higher surface pressures, the data suggest that the molecular packing in mixed DPPC/C16OH monolayers may be favored by the packing efficiency or geometric accommodation. Furthermore, negative values of excess free energy of mixing were obtained and became significant as the hydrocarbon chain length of alcohols increased, which indicates there were attractive interactions between DPPC and long-chain alcohols. In each free energy of mixing–composition curve, there was only one minimum and thus a phase separation did not exist for mixed DPPC/long-chain alcohol monolayers.

Surface characterization of the monolayer and Langmuir–Blodgett films of tetra-tert-butyl-copper phthalocyanine

Abstract The relaxation and hysteresis phenomena of the tetra-tert-butyl-copper phthalocyanine (ttb-CuPc) monolayer were investigated. The monolayer was then transferred to a hydrophilic glass surface to prepare one monolayer of Langmuir–Blodgett (LB) films. The uniformity, stability and molecular arrangement of the LB films were studied by measurements of dynamic contact angle (DCA), and were compared with the information obtained by transmission electron microscopy (TEM) and atomic force microscopy (AFM). The results show that the monolayer of ttb-CuPc is generally stable. The limiting area of a molecule is smaller than those reported in the literature, which is attributed to the aggregation of ttb-CuPc molecules into multilayer domains. The advancing and receding contact angles of water on these LB films are much smaller than those on a homogeneous film prepared by vacuum deposition. The wettability analysis on the LB films suggests that ttb-CuPc molecules are not arranged uniformly and continuously, and the LB film of ttb-CuPc contains a high ratio of exposed glass substrate. The surface morphology inspected by TEM and AFM shows the formation of separated domains of ttb-CuPc molecules, which is consistent with the surface condition evaluated from the surface wettability.