Chunxing She

Ni(III)/(IV) Bis(dicarbollide) as a fast, noncorrosive redox shuttle for dye-sensitized solar cells

Nickel bis(dicarbollide) is used as a fast, one-electron outer sphere redox couple in dye-sensitized solar cells. Device performances with this anionic shuttle are investigated with different electrolyte concentrations and additives, using only 0.030 M of the Ni(III) bis(dicarbollide) to efficiently regenerate the ruthenium dye. Atomic layer deposition of Al(2)O(3) on the nanoparticulate TiO(2) photoanodes is further used to improve device performances, increasing current densities almost 2-fold and attaining power conversion efficiencies approximately 10x greater than its metallocene analogue, ferrocene/ferrocenium. Open-circuit voltage decay is used to probe the kinetics of the Ni(III)/(IV) bis(dicarbollide) redox couple, and electron interception is found to be approximately 10(3)x slower than ferrocene/ferrocenium, explaining the large discrepancy in open-circuit voltage potentials between these two redox shuttles.

Porphyrin sensitized solar cells: TiO2 sensitization with a π-extended porphyrin possessing two anchoring groups

A pi-extended porphyrin possessing two anchoring groups has been synthesized and successfully applied to dye-sensitized solar cells with a power conversion efficiency of 5.5%, rendering it comparable to the performance of N719-sensitized solar cells under the conditions employed here.

Electronic tuning of nickel-based bis(dicarbollide) redox shuttles in dye-sensitized solar cells

Rational design of a new series of boron-functionalized Ni{sup III}/Ni{sup IV}–bis(dicarbollide) clusters results in a family of robust and tunable redox shuttles (see diagram; EDG and EWG denote electron-donating and -withdrawing groups, respectively). This offers a means to rationally control the redox properties in dye-sensitized solar cells (DSCs), leading to exceptionally high open-circuit voltages.

Dye-Sensitized solar cells: Sensitizer-Dependent injection into ZnO nanotube electrodes

Two porphyrin-based dyes with carboxylic acid tethers of differing acidity in both protonated and deprotonated forms were examined on ZnO nanotube electrodes. All of the dyes have similar surface coverage, but only the more acidic dye in the acid form injects electrons well; this dye is the only one that corrodes the ZnO. In control experiments on TiO(2) nanoparticle electrodes, both dyes load and inject in protonated and deprotonated forms. These results are consistent with a requirement that the dye must partially corrode the ZnO surface in order for efficient injection to occur. Alternatively, it may possibly point to a coupling of electron injection to proton uptake.

Surface Raman spectroscopic investigation of pyridine adsorption at platinum electrodes—effects of potential and electrolyte

Surface enhanced Raman spectra of pyridine (Py) at Pt electrodes have been investigated as a function of potential and supporting electrolyte. The results show a large difference from those reported for coinage metal electrodes of Ag, Au and Cu, emphasising the effective involvement of chemical enhancement on Pt surfaces. At very negative (or positive) potentials, Raman spectra show the competitive coadsorption of hydrogen (oroxygen-containing species) with Py, and in acidic solutions, PyH+ ions prefer to dissociate into Py adsorbed on Pt surfaces even in the presence of chloride ions. The differences in the surface bonding strength for Py on Pt and coinage metal electrodes are explained in terms of the different electronic configurations of the metals.

Photoinduced electron transfer from rail to rung within a self-assembled oligomeric porphyrin ladder

Photoinduced electron transfer in a self-assembled supramolecular ladder structure comprising oligomeric porphyrin rails and ligated dipyridyltetrazine rungs was characterized by transient absorption spectroscopy and transient direct current photoconductivity to be mainly from an oligomer (rail) to the center of a terminal tetrazine (rung), with the remaining hole being delocalized on the oligomer and subsequent charge recombination in 0.19 ns.

Excess polarizability reveals exciton localization/delocalization controlled by linking positions on porphyrin rings in butadiyne-bridged porphyrin dimers.

We report direct measurements of the excess polarizability volumes of butadiyne-bridged zinc porphyrin dimers at singly beta-to-beta (1Zn) and doubly beta-to-beta (2Zn) positions using the transient dc photoconductivity (TDCP) technique. The excess polarizability volumes of the singlet exciton for 1Zn and 2Zn are 110 and 270 A(3), respectively, while those of the triplet exciton are approximately 100 A(3) for both dimers. Our measurements suggest that the singlet exciton is mainly localized on one porphyrin subunit for 1Zn, similar to the case for the porphyrin monomer. While the exciton is fully delocalized on two porphyrin subunits in the case of meso-to-meso linked dimer (3Zn), the extent of exciton localization/delocalization for doubly beta-to-beta linked dimer lies between those of singly beta-to-beta and meso-to-meso linked dimers. Electronic structure calculations show that the dramatically different extents of exciton localization/delocalization are the results of frontier orbital coefficients being small at beta positions but large at meso positions. Two butadiyne linkages between the porphyrins at beta positions (2Zn) clearly facilitate electronic communication between the two porphyrin subunits by virtue of stabilization of cumulenic charge resonance structures through enforced planarity.

Solvent-induced configuration mixing and triplet excited-state inversion: insights from transient absorption and transient dc photoconductivity measurements

Solvent-induced excited-state configuration mixing in a Pt(II) diimine chromophore with phenylene ethynylene containing acetylide ligands, [Pt((t)Bu2bpy)(PE3)2] (1), was characterized by nanosecond transient absorption spectroscopy and transient dc photoconductivity (TDCP). The mixing is a result of closely spaced triplet charge transfer (3CT) and intraligand-localized (3IL) triplet energy levels that are finely tuned with solvent polarity as ascertained by their parent model chromophores [Pt((t)Bu2bpy)(PE1)2] (2) and [Pt(P2)(PE3)2] (3), respectively. The absorption difference spectrum of the mixed triplet state is dramatically different from those of the 3CT and 3IL state model chromophores. The 3CT, 3IL and configuration-mixed triplet states led to distinct TDCP signals. The TDCP response is of negative polarity for 3CT excited states but of positive polarity for 3IL excited states. TDCP transients for 1 in mixed solvents are a combination of signals from the 3IL and 3CT states, with the signal magnitude depending on the polarity of solvent composition. The fraction of 3CT state character in the configurationally mixed excited state was quantified by TDCP to be approximately 0.24 in pure benzene, while it decreased to approximately 0.05 in 20 : 80 (v : v) benzene-CH2Cl2. The charge transfer fraction appears to increase slightly to approximately 0.11 in the lower polarity 20 : 80 n-hexane-CH2Cl2 medium. TDCP is shown to be a useful tool for the identification of the lowest excited state in electrically neutral metal-organic chromophores.

Probing Exciton Localization/Delocalization: Transient dc Photoconductivity Studies of Excited States of Symmetrical Porphyrin Monomers, Oligomers, and Supramolecular Assemblies

Solution-phase transient dc photoconductivity (TDCP) measurements are used to address the question of exciton localization/delocalization in strongly coupled oligomeric porphyrins and in well-defined, higher-order assemblies of oligomers (ladder and prism assemblies). The approach used is determination of the excited-state excess polarizability volume, Delta alpha(V)--a quantity known to report on exciton delocalization. The measurements reveal for the oligomers that singlet excitons are substantially delocalized but that triplet excitons are much more localized. For each of the two higher-order assemblies, the measurements reveal that excitons are transiently confined to individual oligomeric subunits rather than being delocalized over the entire assembly.

The Investigation of Electro-Oxidation of Methanol on Pt-Ru Electrode Surfaces by in-situ Raman Spectroscopy

Assisted by the highly sensitive confocal microprobe Raman spectrometer and proper surface roughening procedure, the Raman investigation on the adsorption and reaction of methanol was performed on Pt-Ru electrodes with different coverages. A detailed description of the roughening process of the Pt electrodes and the underpotential deposition of the Ru was given. Reasonably good Raman signal reflecting the metal-carbon vibration and CO vibration was detected. The appearance of vibrations of the Ru oxides, together with the existence of Ru-C, Pt-C and CO bands, clearly demonstrates the participation of the bi-functional mechanism during the oxidation process of methanol on Pt-Ru electrodes. The Pt-Ru electrode was found to have a higher catalytic activity over Pt electrodes. This preliminary study shows that electrochemical Raman spectroscopy can be applied to the study of rough electrode surface.