Claudia Kolbeck

Influence of Different Anions on the Surface Composition of Ionic Liquids Studied Using ARXPS

Angle-resolved X-ray photoelectron spectroscopy has been used to study the influence of different types of anions on the surface composition of ionic liquids (ILs). We have investigated nine ILs with the same cation, 1-octyl-3-methylimidazolium [C(8)C(1)Im](+), but very different anions. In all cases, an enrichment of the cation alkyl chains is found at the expense of the polar cation head groups and the anions in the first molecular layer. This enhancement effect decreases with increasing size of the anion, which means it is most pronounced for the smallest anions and least pronounced for the largest anions. A simple model is proposed to explain the experimental observations.

Density and Surface Tension of Ionic Liquids

We measured the density and surface tension of 9 bis[(trifluoromethyl)sulfonyl]imide ([Tf(2)N](-))-based and 12 1-methyl-3-octylimidazolium ([C(8)C(1)Im](+))-based ionic liquids (ILs) with the vibrating tube and the pendant drop method, respectively. This comprehensive set of ILs was chosen to probe the influence of the cations and anions on density and surface tension. When the alkyl chain length in the [C(n)C(1)Im][Tf(2)N] series (n = 1, 2, 4, 6, 8, 10, 12) is increased, a decrease in density is observed. The surface tension initially also decreases but reaches a plateau for alkyl chain lengths greater than n = 8. Functionalizing the alkyl chains with ethylene glycol groups results in a higher density as well as a higher surface tension. For the dependence of density and surface tension on the chemical nature of the anion, relations are only found for subgroups of the studied ILs. Density and surface tension values are discussed with respect to intermolecular interactions and surface composition as determined by angle-resolved X-ray photoelectron spectroscopy (ARXPS). The absence of nonvolatile surface-active contaminants was proven by ARXPS.

Surface Characterization of Functionalized Imidazolium-Based Ionic Liquids

The surface composition of oligo(ethylene glycol) ether functionalized bis(trifluoromethylsulfonyl)imide ionic liquids has been studied by means of X-ray photoelectron spectroscopy (XPS). For [Me(EG)MIM][Tf 2N], [Et(EG) 2MIM][Tf 2N], and [Me(EG) 3MIM][Tf 2N], which vary by the number of ethylene glycol (EG) units (from 1 to 3), we have shown that the stoichiometry of the surface near region is in excellent agreement with the bulk stoichiometry, which confirms the high purity of the ionic liquid samples investigated and rules out pronounced surface orientation effects. This has been deduced from the experimental observation that the angle-resolved XP spectra of all elements present in the IL anions and cations (C, N, O, F, S) show identical signals in the bulk and surfaces sensitive geometry, i.e., at 0 degrees and 70 degrees emission angle, respectively. The relative intensity ratios of all elements were found to be in nearly perfect agreement with the nominal values for the individual ILs. In contrast to these findings, we identified surface-active impurities in [Me(EG)MIM]I, which is the starting material for the final anion exchange step to synthesize [Me(EG)MIM][Tf 2N]. Sputtering of the surface led to a depletion of this layer, which however recovered with time. The buildup of this contamination is attributed to a surface enrichment of a minor bulk contamination that shows surface activity in the iodide melt.

Visible-light photocurrent response of TiO2–polyheptazine hybrids: evidence for interfacial charge-transfer absorption

We investigated photoelectrodes based on TiO(2)-polyheptazine hybrid materials. Since both TiO(2) and polyheptazine are extremely chemically stable, these materials are highly promising candidates for fabrication of photoanodes for water photooxidation. The properties of the hybrids were experimentally determined by a careful analysis of optical absorption spectra, luminescence properties and photoelectrochemical measurements, and corroborated by quantum chemical calculations. We provide for the first time clear experimental evidence for the formation of an interfacial charge-transfer complex between polyheptazine (donor) and TiO(2) (acceptor), which is responsible for a significant red shift of absorption and photocurrent response of the hybrid as compared to both of the single components. The direct optical charge transfer from the HOMO of polyheptazine to the conduction band edge of TiO(2) gives rise to an absorption band centered at 2.3 eV (540 nm). The estimated potential of photogenerated holes (+1.7 V vs. NHE, pH 7) allows for photooxidation of water (+0.82 V vs. NHE, pH 7) as evidenced by visible light-driven (λ > 420 nm) evolution of dioxygen on hybrid electrodes modified with IrO(2) nanoparticles as a co-catalyst. The quantum-chemical simulations demonstrate that the TiO(2)-polyheptazine interface is a complex and flexible system energetically favorable for proton-transfer processes required for water oxidation. Apart from water splitting, this type of hybrid materials may also find further applications in a broader research area of solar energy conversion and photo-responsive devices.

Carbon Dioxide Capture by an Amine Functionalized Ionic Liquid: Fundamental Differences of Surface and Bulk Behavior

Carbon dioxide (CO2) absorption by the amine-functionalized ionic liquid (IL) dihydroxyethyldimethylammonium taurinate at 310 K was studied using surface- and bulk-sensitive experimental techniques. From near-ambient pressure X-ray photoelectron spectroscopy at 0.9 mbar CO2, the amount of captured CO2 per mole of IL in the near-surface region is quantified to ~0.58 mol, with ~0.15 mol in form of carbamate dianions and ~0.43 mol in form of carbamic acid. From isothermal uptake experiments combined with infrared spectroscopy, CO2 is found to be bound in the bulk as carbamate (with nominally 0.5 mol of CO2 bound per 1 mol of IL) up to ~2.5 bar CO2, and as carbamic acid (with nominally 1 mol CO2 bound per 1 mol IL) at higher pressures. We attribute the fact that at low pressures carbamic acid is the dominating species in the near-surface region, while only carbamate is formed in the bulk, to differences in solvation in the outermost IL layers as compared to the bulk situation.

Organic Reactions in Ionic Liquids Studied by in Situ XPS

We demonstrate the application of in situ X-ray photoelectron spectroscopy (XPS) to monitor organic, liquid-phase reactions. By covalently attaching ionic head groups to the reacting organic molecules, their volatility can be reduced such that they withstand ultra high vacuum conditions. The applied method, which is new for the investigation of organic reactions, allows for following the fate of all elements present in the reaction mixture--except for hydrogen--in a quantitative and oxidation-state-sensitive manner in one experiment. This concept is demonstrated for the alkylation of a tertiary amine attached to an imidazolium or phosphonium moiety by the anion 4-chlorobutylsulfonate ([ClC(4)H(8)SO(3)](-)). In the course of the reaction, the covalently bound chlorine is converted to chloride and the amine to ammonium as reflected by the distinct shifts in the N 1s and Cl 2p binding energies.

Ligand effects on the surface composition of Rh-containing ionic liquid solutions used in hydroformylation catalysis.

In hydroformylation, multiphase catalysis is a well-established and industrially realized method for effective catalyst separation and recycling. Aqueous phase liquid–liquid biphasic catalysis was developed through the pioneering discovery of the highly water-soluble ligand tris(3-sodium sulfonatophenyl)phosphine (tppts, 1) by Kuntz in 1976. This ligand concept enabled the industrial realization of aqueous hydroformylation for propene hydroformylation in the Ruhrchemie–Rh ne–Poulenc process. The process went on stream in 1984, and is still operating today (550000 tons per year). However, the limited solubility of higher olefins (>C4) in water has prompted much research activity into alternative polar catalyst media for liquid–liquid multiphase hydroformylation. Among these endeavors, the use of lowmelting salts, so-called ionic liquids (ILs), has attracted particular interest as many ionic liquids show sufficiently high solubilities for higher olefins to allow reasonable reaction rates. First reports on the application of ionic liquids in Rh-catalyzed hydroformylation were published by Chauvin s group in 1995. Already in this first paper, the use of sulfonated triphenylphosphine ligands was highlighted as a crucial precondition to avoid Rh-leaching into the organic product phase. Later, sulfonated triphenylphosphine ligands were also combined with imidazolium counter ions. ColeHamilton and co-workers suggested, for example, [C3mim]2ACHTUNGTRENNUNG[PhP ACHTUNGTRENNUNG(C6H4SO3)2] as a suitable ligand for hydroformylation reactions in the biphasic system ionic liquid/scCO2. [7] The same ligand system was applied recently to an even more efficient catalytic system using the ionic catalyst solution in the form of a supported ionic liquid phase (SILP). Such SILP catalytic systems have also been very successfully applied in continuous gas-phase reactions where the ionic liquid film supported on a highly porous inorganic support is contacted directly with the gas-phase of the reactants to perform continuous hydroformylation using a continuous fixed-bed reactor. In general, hydroformylation in ionic liquids has produced a huge amount of scientific activity over the last 15 years and particular progress was made by the use of regioselective ionic ligand systems and by the application of ionic liquids carrying halide-free, cheap and hydrolytic stable anions. The field has been recently summarized comprehensively in an excellent review by Haumann and Riisager. In multiphase catalysis, interface processes such as substrate diffusion into the catalyst phase, the reaction rate at the phase boundary (in comparison to reaction rate in the bulk), and product diffusion back into the organic phase play a crucial role for the overall performance of the system. Despite this obvious fact, experimental investigations into the chemical nature of the liquid surface of catalytic systems are lacking so far. This is even more surprising in the light of recent theoretical findings by the group of Wipff, which demonstrated that the composition of the catalytic interface may well be very different from the average chemical composition of two adjacent bulk liquid phases. This fact is of high relevance for the detailed understanding of all above-mentioned interface transport and reaction processes. Moreover, the authors demonstrated that the surface-active character of a given type of an IL soluble complex was similar at the IL–vacuum interface and at the IL interface with weakly polar organic solvents. The [a] Dipl.-Chem. C. Kolbeck, Dipl.-Chem. T. Cremer, Dr. F. Maier, Prof. Dr. H.-P. Steinr ck Chair of Physical Chemistry II Friedrich-Alexander-Universit t Erlangen-N rnberg Egerlandstrasse 3, 91054 Erlangen (Germany) Fax: (+49)9131-852-8867 E-mail : steinrueck@chemie.uni-erlangen.de [b] Dipl.-Chem. N. Paape, Dr. P. S. Schulz, Prof. Dr. P. Wasserscheid Lehrstuhl f r Chemische Reaktionstechnik Friedrich-Alexander-Universit t Erlangen-N rnberg Egerlandstrasse 3, 91058 Erlangen (Germany) [] These authors contributed equally to this work.

Influence of Substituents and Functional Groups on the Surface Composition of Ionic Liquids

We have performed a systematic study addressing the surface behavior of a variety of functionalized and non-functionalized ionic liquids (ILs). From angle-resolved X-ray photoelectron spectroscopy, detailed conclusions on the surface enrichment of the functional groups and the molecular orientation of the cations and anions is derived. The systems include imidazolium-based ILs methylated at the C2 position, a phenyl-functionalized IL, an alkoxysilane-functionalized IL, halo-functionalized ILs, thioether-functionalized ILs, and amine-functionalized ILs. The results are compared with the results for corresponding non-functionalized ILs where available. Generally, enrichment of the functional group at the surface is only observed for systems that have very weak interaction between the functional group and the ionic head groups.

Monitoring of Liquid‐Phase Organic Reactions by Photoelectron Spectroscopy

There are strings attached: after linking the reacting groups to head groups of ionic liquids to drastically lower the vapour pressures of the reactants, ordinary liquid-phase organic reactions can be monitored by in situ X-ray photoelectron spectroscopy. This approach is demonstrated for the nucleophilic substitution of an alkyl amine and an alkyl chloride moiety, which are attached to the cation and anion of ionic liquids, respectively.

Industrially scalable and cost-effective Mn2+ doped ZnxCd1−xS/ZnS nanocrystals with 70% photoluminescence quantum yield, as efficient down-shifting materials in photovoltaics

We present colloidally stable and highly luminescent ZnxCd1−xS:Mn/ZnS core–shell nanocrystals (NCs) synthesized via a simple non-injection one-pot, two-step synthetic route, which can be easily upscaled. A systematic variation of the reaction component, parameters and thickness of the ZnS shell yielded doped nanocrystals with a very high photoluminescence quantum yield (Φpl) of 70%, which is the highest value yet reported for these Mn-doped sulfide-semiconductor NCs. These materials can be synthesized with high reproducibility in large quantities of the same high quality, i.e., the same Φpl using accordingly optimized reaction conditions. The application of these zero-reabsorption high quality NCs in the light conversion layers, deposited on top of a commercial monocrystalline silicon (mono-Si) solar cell, led to a significant enhancement of the external quantum efficiency (EQE) of this device in the ultraviolet spectral region between 300 and 400 nm up to ca. 12%. EQE enhancement is reflected by an increase in the power conversion efficiency (PCE) by nearly 0.5 percentage points and approached the theoretical limit (0.6%) expected from down-shifting for this Si solar cell. The resulting PCE may result in a BoM (bill of materials) cost reduction of app. 3% for mono-Si photovoltaic modules. Such small but distinct improvements are expected to pave the road for an industrial application of doped semiconductor NCs as cost-effective light converters for silicon photovoltaic (PV) and other optoelectronic applications.