D J Beard

The effect of hip resurfacing on oxygen concentration in the femoral head.

We inserted an electrode up the femoral neck into the femoral head of ten patients undergoing a metal-on-metal hip resurfacing arthroplasty through a posterior surgical approach and measured the oxygen concentration during the operation. In every patient the blood flow was compromised during surgery, but the extent varied. In three patients, the oxygen concentration was zero at the end of the procedure. The surgical approach caused a mean 60% drop (p < 0.005) in oxygen concentration while component insertion led to a further 20% drop (p < 0.04). The oxygen concentration did not improve significantly on wound closure. This study demonstrates that during hip resurfacing arthroplasty, patients experience some compromise to their femoral head blood supply and some have complete disruption.

Ten-year in vivo wear measurement of a fully congruent mobile bearing unicompartmental knee arthroplasty

Polyethylene particulate wear debris continues to be implicated in the aetiology of aseptic loosening following knee arthroplasty. The Oxford unicompartmental knee arthroplasty employs a spherical femoral component and a fully congruous meniscal bearing to increase contact area and theoretically reduce the potential for polyethylene wear. This study measures the in vivo ten-year linear wear of the device, using a roentgenstereophotogrammetric technique. In this in vivo study, seven medial Oxford unicompartmental prostheses, which had been implanted ten years previously were studied. Stereo pairs of radiographs were acquired for each patient and the films were analysed using a roentgen stereophotogrammetric analysis calibration and a computer-aided design model silhouette-fitting technique. Penetration of the femoral component into the original volume of the bearing was our estimate of linear wear. In addition, eight control patients were examined less than three weeks post-insertion of an Oxford prosthesis, where no wear would be expected. The control group showed no measured wear and suggested a system accuracy of 0.1 mm. At ten years, the mean linear wear rate was 0.02 mm/year. The results from this in vivo study confirm that the device has low ten-year linear wear in clinical practice. This may offer the device a survival advantage in the long term.

Combined anterior cruciate reconstruction and Oxford unicompartmental knee arthroplasty

The options for treatment of the young active patient with isolated symptomatic osteoarthritis of the medial compartment and pre-existing deficiency of the anterior cruciate ligament are limited. The potential longevity of the implant and levels of activity of the patient may preclude total knee replacement, and tibial osteotomy and unicompartmental knee arthroplasty are unreliable because of the ligamentous instability. Unicompartmental knee arthroplasties tend to fail because of wear or tibial loosening resulting from eccentric loading. Therefore, we combined reconstruction of the anterior cruciate ligament with unicompartmental arthroplasty of the knee in 15 patients (ACLR group), and matched them with 15 patients who had undergone Oxford unicompartmental knee arthroplasty with an intact anterior cruciate ligament (ACLI group). The clinical and radiological data at a minimum of 2.5 years were compared for both groups. The groups were well matched for age, gender and length of follow-up and had no significant differences in their pre-operative scores. At the last follow-up, the mean outcome scores for both the ACLR and ACLI groups were high (Oxford knee scores of 46 (37 to 48) and 43 (38 to 46), respectively, objective Knee Society scores of 99 (95 to 100) and 94 (82 to 100), and functional Knee Society scores of 96 and 96 (both 85 to 100). One patient in the ACLR group needed revision to a total knee replacement because of infection. No patient in either group had radiological evidence of component loosening. The radiological study showed no difference in the pattern of tibial loading between the groups. The short-term clinical results of combined anterior cruciate ligament reconstruction and unicompartmental knee arthroplasty are excellent. The previous shortcomings of unicompartmental knee arthroplasty in the presence of deficiency of the anterior cruciate ligament appear to have been addressed with the combined procedure. This operation seems to be a viable treatment option for young active patients with symptomatic arthritis of the medial compartment, in whom the anterior cruciate ligament has been ruptured.

The premature failure of the Charnley Elite-Plus stem: a confirmation of RSA predictions.

We performed a clinical and radiological study to determine the rate of failure of the Charnley Elite-Plus femoral component. Our aim was to confirm or refute the predictions of a previous roentgen stereophotogrammetric analysis study in which 20% of the Charnley Elite-Plus stems had shown rapid posterior head migration. It was predicted that this device would have a high early rate of failure.We examined 118 patients at a mean of nine years after hip replacement, including the 19 patients from the original roentgen stereophotogrammetric study. The number of revision procedures was recorded and clinical and radiological examinations were performed. The rate of survival of the femoral stems at ten years was 83% when revision alone was considered to be a failure. It decreased to 59% when a radiologically loose stem was also considered to be a failure. All the patients previously shown in the roentgen stereophotogrammetric study to have high posterior head migration went on to failure. There was a highly significant difference (p = 0.002) in posterior head migration measured at two years after operation between failed and non-failed femoral stems, but there was no significant difference in subsidence between these two groups. Our study has shown that the Charnley Elite-Plus femoral component has an unacceptably high rate of failure. It confirms that early evaluation of new components is important and that roentgen stereophotogrammetric is a good tool for this. Our findings have also shown that rapid posterior head migration is predictive of premature loosening and a better predictor than subsidence.

Influence of surface geometry and the cam-post mechanism on the kinematics of total knee replacement

Abnormal sagittal kinematics after total knee replacement (TKR) can adversely affect functional outcome. Two important determinants of knee kinematics are component geometry and the presence or absence of a posterior-stabilising mechanism (cam-post). We investigated the influence of these variables by comparing the kinematics of a TKR with a polyradial femur with a single radius design, both with and without a cam-post mechanism. We assessed 55 patients, subdivided into four groups, who had undergone a TKR one year earlier by using an established fluoroscopy protocol in order to examine their kinematics in vivo. The kinematic profile was obtained by measuring the patellar tendon angle through the functional knee flexion range (0 degrees to 90 degrees ) and the results compared with 14 normal knees. All designs of TKR had abnormal sagittal kinematics compared with the normal knee. There was a significant (p < 0.05) difference between those of the two TKRs near to full extension. The presence of the cam-post mechanism did not influence the kinematics for either TKR design. These differences suggest that surface geometry is a stronger determinant of kinematics than the presence or absence of a cam-post mechanism for these two designs. This may be because the cam-post mechanism is ineffective.

Real in vivo kinematic differences between mobile-bearing and fixed-bearing total knee arthroplasties.

We did an in vivo fluoroscopic study comparing the sagittal plane kinematics of mobile-bearing and fixed-bearing total knee arthroplasties in a unique group of patients. These patients were part of a larger bilateral randomized controlled outcome trial with each patient having received both types of total knee arthroplasties. Invited patients did three exercises with each of their different knee replacements; extension against gravity, flexion against gravity, and a step-up. These exercises were recorded using video fluoroscopy, and a series of still digital images over the flexion range were retrieved. The relationship of patella tendon angle to knee flexion angle for each patient was derived. The patella tendon angle to knee flexion angle of the mobile-bearing knee behaved in a linear manner more closely replicating the normal knee, whereas the fixed-bearing knee behaved in a nonlinear, more variable manner. This pattern of results was similar for all three exercises with each patient having one knee replacement that behaved differently in the sagittal plane when compared with their other knee replacement. These kinematic differences may explain the clinical differences observed in the randomized controlled trials that compared these two total knee arthroplasties.

In vivo kinematics of the ACL-deficient limb during running and cutting

Anterior cruciate ligament-deficient (ACLD) knee kinematics during high-demand activities are poorly understood. We have devised a new method, using gait analysis, to more accurately assess 3-D in vivo kinematics of the knee. This has enabled us to report on how knee kinematics are altered after ACL rupture, during running and cutting. Fifteen unilaterally ACLD subjects were assessed using a 12-camera 100xa0Hz VICON motion analysis system. Simultaneous electromyographical (EMG) recordings were used to assess the role of the sensorimotor system in knee joint stability. All subjects were able to perform demanding cutting activities without experiencing symptoms of instability. We found that running produces fundamentally different kinematic patterns to those seen during walking. Tibiofemoral translation in the anteroposterior plane is controlled to within normal limits. Conversely, coronal translation and rotation are poorly controlled. We found that the injured leg was maintained in greater extension during the stance phase of all running activities studied and that the quadriceps muscle was active for longer during this period. We believe that low-demand activities, such as walking, do not reproduce kinematics relevant to ACLD instability and that future investigations into functional instability in the ACLD knee should focus on coronal and rotational displacements.

Influence of stem geometry on the stability of polished tapered cemented femoral stems

Polished, tapered stems are now widely used for cemented total hip replacement and many such designs have been introduced. However, a change in stem geometry may have a profound influence on stability. Stems with a wide, rectangular proximal section may be more stable than those which are narrower proximally. We examined the influence of proximal geometry on stability by comparing the two-year migration of the Exeter stem with a more recent design, the CPS-Plus, which has a wider shoulder and a more rectangular cross-section. The hypothesis was that these design features would increase rotational stability. Both stems subsided approximately 1 mm relative to the femur during the first two years after implantation. The Exeter stem was found to rotate into valgus (mean 0.2 degrees , sd 0.42 degrees ) and internally rotate (mean 1.28 degrees , sd 0.99 degrees ). The CPS-Plus showed no significant valgus rotation (mean 0.07 [correction] degrees, sd 0.29 [correction] degrees ) or internal rotation (mean -0.03 degrees , sd 0.75 degrees ). A wider, more rectangular cross-section improves rotational stability and may have a better long-term outcome.

Symmetrical vs. asymmetrical total knee replacement—a medium term comparative analysis

Modifications of established implants can result in deleterious effects, as with the Capitol and the matt coated Exeter hips. In 1991 the Kinemax plus modification of the Kinematic knee was introduced in Bristol, the design changes having been made to reduce patello-femoral complications. We carried out a comparative analysis of the prospective recorded data on a consecutive series of 182 total knee replacements (95 Kinematic and 87 Kinemax plus knees) performed between 1991 and 1993. The same instrumentation and surgical technique was used. Since the design had introduced a broader trochlear, offset patella and had changed from an asymmetrical to a symmetrical femoral component, particular attention was paid to tracking and range of movement. All patients were reviewed at 5 years using the Bristol knee score and radiographs. There was no difference in the overall score (both prosthesis scoring 85-86) but the Kinemax plus group with a symmetrical trochlear had a significantly greater improvement in the range of movement (14 degrees as opposed to 4 degrees; P<0.05). In addition, secondary intervention for mal-tracking was significantly less in the Kinemax group. No deleterious effect of the changed geometry was observed. It is concluded that the introduction of a symmetrical femoral component with an offset patella reduced patello-femoral complications without detectable disadvantages.