D. Neely

Enhanced proton beams from ultrathin targets driven by high contrast laser pulses

The generation of proton beams from ultrathin targets, down to 20 nm in thickness, driven with ultrahigh contrast laser pulses is explored. the conversion efficiency from laser energy into protons increases as the foil thickness is decreased, with good beam quality and high efficiencies of 1% being achieved, for protons with kinetic energy exceeding 0.9 MeV, for 100 nm thick aluminum foils at intensities of 10(19) W/cm(2) with 33 fs, 0.3 J pulses. To minimize amplified spontaneous emission (ASE) induced effects disrupting the acceleration mechanism, exceptional laser to ASE intensity contrasts of up to 1010 are achieved by introducing a plasma mirror to the high contrast 10 Hz multiterawatt laser at the Lund Laser Centre. It is shown that for a given laser energy on target, regimes of higher laser-to-proton energy conversion efficiency. can be accessed with increasing contrast. The increasing efficiency as the target thickness decreases is closely correlated to an increasing proton temperature. (c) 2006 American Institute of Physics.

Ion acceleration in multispecies targets driven by intense laser radiation pressure

The acceleration of ions from ultrathin foils has been investigated by using 250 TW, subpicosecond laser pulses, focused to intensities of up to 3 × 10(20) W cm(-2). The ion spectra show the appearance of narrow-band features for protons and carbon ions peaked at higher energies (in the 5-10 MeV/nucleon range) and with significantly higher flux than previously reported. The spectral features and their scaling with laser and target parameters provide evidence of a multispecies scenario of radiation pressure acceleration in the light sail mode, as confirmed by analytical estimates and 2D particle-in-cell simulations. The scaling indicates that monoenergetic peaks with more than 100 MeV/nucleon are obtainable with moderate improvements of the target and laser characteristics, which are within reach of ongoing technical developments.

Vulcan Petawatt—an ultra-high-intensity interaction facility

The Vulcan Nd : glass laser at the Central Laser Facility is a Petawatt (1015 W) interaction facility available to the UK and international user community. The facility came online to users in 2002 and considerable experience has been gained operating the Vulcan facility in this mode. The facility is designed to deliver irradiance on target of 1021 W cm−2 for a wide-ranging experimental programme in fundamental physics and advanced applications. This includes the interaction of super-high-intensity light with matter, fast ignition fusion research, photon induced nuclear reactions, electron and ion acceleration by light waves and the exploration of the exotic world of plasma physics dominated by relativity.

Generation of terawatt pulses by use of optical parametric chirped pulse amplification

Optical parametric chirped pulse amplifiers offer exciting prospects for generating new extremes in power, intensity, and pulse duration. An experiment is described that was used to investigate the operation of this scheme up to energies approaching a joule, as a step toward its implementation at the petawatt level. The results demonstrate an energy gain of 10(10) with an energy extraction efficiency of 20% and close to diffraction-limited performance. Some spectral narrowing during amplification was shown to be compatible with the time-varying profile of the pump beam and consistent with the measured recompressed pulse durations of 260 and 300 fs before and after amplification, respectively.

Observation of a highly directional γ-ray beam from ultrashort, ultraintense laser pulse interactions with solids

Novel measurements of electromagnetic radiation above 10 MeV are presented for ultra intense laser pulse interactions with solids. A bright, highly directional source of γ rays was observed directly behind the target. The γ rays were produced by bremsstrahlung radiation from energetic electrons generated during the interaction. They were measured using the photoneutron reaction [63Cu(γ,n)62Cu] in copper. The resulting activity was measured by coincidence counting the positron annihilation γ rays which were produced from the decay of 62Cu. New measurements of the bremsstrahlung radiation at 1019 W cm−2 are also presented.

Radiochromic film imaging spectroscopy of laser-accelerated proton beams

This article reports on an experimental method to fully reconstruct laser-accelerated proton beam parameters called radiochromic film imaging spectroscopy (RIS). RIS allows for the characterization of proton beams concerning real and virtual source size, envelope- and microdivergence, normalized transverse emittance, phase space, and proton spectrum. This technique requires particular targets and a high resolution proton detector. Therefore thin gold foils with a microgrooved rear side were manufactured and characterized. Calibrated GafChromic radiochromic film (RCF) types MD-55, HS, and HD-810 in stack configuration were used as spatial and energy resolved film detectors. The principle of the RCF imaging spectroscopy was demonstrated at four different laser systems. This can be a method to characterize a laser system with respect to its proton-acceleration capability. In addition, an algorithm to calculate the spatial and energy resolved proton distribution has been developed and tested to get a better idea of laser-accelerated proton beams and their energy deposition with respect to further applications.

35 J broadband femtosecond optical parametric chirped pulse amplification system

We report on what is believed to be the first large-aperture and high-energy optical parametric chirped pulse amplification system. The system, based on a three-stage amplifier, shows 25% pump-to-signal conversion efficiency and amplification of the full 70 nm width of the seed spectrum. Pulse compression to 84 fs achieved after amplification indicates a potential of 300 TW pulse power for 35 J amplified pulse energy.

High power laser production of short-lived isotopes for positron emission tomography

Positron emission tomography (PET) is a powerful diagnostic/imaging technique requiring the production of the short-lived positron emitting isotopes 11C, 13N, 15O and 18F by proton irradiation of natural/enriched targets using cyclotrons. The development of PET has been hampered due to the size and shielding requirements of nuclear installations. Recent results show that when an intense laser beam interacts with solid targets, megaelectronvolt (MeV) protons capable of producing PET isotopes are generated. This report describes how to generate intense PET sources of 11C and 18F using a petawatt laser beam. The work describing the laser production of 18F through a (p,n) 18O reaction, and the subsequent synthesis of 2-[18F] is reported for the first time. The potential for developing compact laser technology for this purpose is discussed.

Ultrahigh-intensity laser-produced plasmas as a compact heavy ion injection source

The possibility of using high-intensity laser-produced plasmas as a source of energetic ions for heavy ion accelerators is addressed. Experiments have shown that neon ions greater than 6 MeV can be produced from gas jet plasmas, and well-collimated proton beams greater than 20 MeV have been produced from high intensity laser solid interactions. The proton beams from the back of thin targets appear to be more collimated and reproducible than are high-energy ions generated in the ablated plasma at the front of the target and may be more suitable for ion injection applications. Lead ions have been produced at energies up to 430 MeV.

Experimental studies of the advanced fast ignitor scheme

Guided compression offers an attractive route to explore some of the physics issues of hot electron heating and transport in the fast ignition route to inertial confinement fusion, whilst avoiding the difficulties associated with establishing the stability of the channel formation pulse. X-ray images are presented that show that the guided foil remains hydrodynamically stable during the acceleration phase, which is confirmed by two-dimensional simulations. An integrated conical compression/fast electron heating experiment is presented that confirms that this approach deserves detailed study.