Darryl D. D’Lima

ISB recommendation on definitions of joint coordinate system of various joints for the reporting of human joint motion-part I: ankle, hip, and spine

The Standardization and Terminology Committee (STC) of the International Society of Biomechanics (ISB) proposes a general reporting standard for joint kinematics based on the Joint Coordinate System (JCS), first proposed by Grood and Suntay for the knee joint in 1983 (J. Biomech. Eng. 105 (1983) 136). There is currently a lack of standard for reporting joint motion in the field of biomechanics for human movement, and the JCS as proposed by Grood and Suntay has the advantage of reporting joint motions in clinically relevant terms. In this communication, the STC proposes definitions of JCS for the ankle, hip, and spine. Definitions for other joints (such as shoulder, elbow, hand and wrist, temporomandibular joint (TMJ), and whole body) will be reported in later parts of the series. The STC is publishing these recommendations so as to encourage their use, to stimulate feedback and discussion, and to facilitate further revisions. For each joint, a standard for the local axis system in each articulating bone is generated. These axes then standardize the JCS. Adopting these standards will lead to better communication among researchers and clinicians.

Macroscopic and histopathologic analysis of human knee menisci in aging and osteoarthritis

OBJECTIVE Meniscus lesions following trauma or associated with osteoarthritis (OA) have been described, yet meniscus aging has not been systematically analyzed. The objectives of this study were to (1) establish standardized protocols for representative macroscopic and microscopic analysis, (2) improve existing scoring systems, and (3) apply these techniques to a large number of human menisci. DESIGN Medial and lateral menisci from 107 human knees were obtained and cut in two different planes (triangle/cross section and transverse/horizontal section as well) in three separate locations (middle portion, anterior and posterior horns). All sections included vascular and avascular regions and were graded for (1) surface integrity, (2) cellularity, (3) matrix/fiber organization and collagen alignment, and (4) Safranin-O staining intensity. The cartilage in all knee compartments was also scored. RESULTS The new macroscopic and microscopic grading systems showed high inter-reader and intra-reader intraclass correlation coefficients. The major age-related changes in menisci in joints with no or minimal OA included increased Safranin-O staining intensity, decreased cell density, the appearance of acellular zones, and evidence of mucoid degeneration with some loss of collagen fiber organization. The earliest meniscus changes occurred predominantly along the inner rim. Menisci from OA joints showed severe fibrocartilaginous separation of the matrix, extensive fraying, tears and calcification. Abnormal cell arrangements included decreased cellularity, diffuse hypercellularity along with cellular hypertrophy and abnormal cell clusters. In general, the anterior horns of both medial and lateral menisci were less affected by age and OA. CONCLUSIONS New standardized protocols and new validated grading systems allowed us to conduct a more systematic evaluation of changes in aging and OA menisci at a macroscopic and microscopic level. Several meniscus abnormalities appear to be specific to aging in the absence of significant OA. With aging the meniscal surface can be intact but abnormal matrix organization and cellularity were observed within the meniscal substance. The increased Safranin-O staining appears to represent a shift from fibroblastic to chondrocytic phenotype during aging and early degeneration.

Impact of mechanical trauma on matrix and cells.

Posttraumatic arthritis is one of the most common causes of secondary osteoarthritis. The contribution of cell death to matrix degradation has not been characterized fully. The current study was designed to determine the effect of mechanical injury on chondrocyte viability and matrix degradation. Full-thickness bovine and human cartilage explants, 5 mm in diameter were subjected to mechanical loads representative of traumatic joint injury. Glycosaminoglycan release and percent apoptotic cells were measured. Unilateral patellas in eight anesthetized rabbits were subjected to an impact load. Rabbits were euthanized at 96 hours after injury and patellar cartilage was harvested for analysis. The effect of a pan-caspase inhibitor, z-VAD.fmk [benzyloxycarbonyl-Val-Ala-Asp (OMe) fluoromethylketone] in preventing chondrocyte apoptosis in human articular cartilage explants was determined. A significant increase in the number of apoptotic cells was observed in response to mechanical loading. The mean in vivo apoptotic rates were 1% in control rabbits and 15% in impacted patellas. Caspase inhibition reduced chondrocyte apoptosis from 34% to 25% after mechanical injury and was associated with reduction in glycosaminoglycan release. Mechanical injury induces chondrocyte apoptosis that is sensitive to pharmacologic inhibition. This identifies a new approach to limit traumatic cartilage injury and the subsequent development of secondary osteoarthritis.

The effect of femoral component malrotation on patellar biomechanics

Patellofemoral complications are among the important reasons for revision knee arthroplasty. Femoral component malposition has been implicated in patellofemoral maltracking, which is associated with anterior knee pain, subluxation, fracture, wear, and aseptic loosening. Rotating-platform mobile bearings compensate for malrotation between the tibial and femoral components and may, therefore, reduce any associated patellofemoral maltracking. To test this hypothesis, we developed a dynamic model of quadriceps-driven open-kinetic-chain extension in a knee implanted with arthroplasty components. The model was validated using tibiofemoral and patellofemoral kinematics and forces measured in cadaver knees. Knee kinematics and patellofemoral forces were measured after simulating malrotation (+/-3 degrees ) of the femoral component. Rotational alignment of the femoral component affected tibial rotation near full extension and tibial adduction at higher flexion angles. External rotation of the femoral component increased patellofemoral lateral tilt, lateral shift, and lateral shear forces. Up to 21 degrees of bearing rotation relative to the tibia was noted in the rotating-bearing condition. However, the rotating bearing had minimal effect in reducing the patellofemoral maltracking or shear induced by femoral component rotation. The rotating platform does not appear to be forgiving of malalignment of the extensor mechanism resulting from femoral component malrotation. These results support the value of improving existing methodologies for accurate femoral component alignment in total knee arthroplasty.

Ultrashort Echo Time MR Imaging of Osteochondral Junction of the Knee at 3 T: Identification of Anatomic Structures Contributing to Signal Intensity

PURPOSE To image cartilage-bone interfaces in naturally occurring and experimentally prepared human cartilage-bone specimens at 3 T by using ultrashort echo time (TE) (UTE) and conventional pulse sequences to (a) determine the appearance of the signal intensity patterns and (b) identify the structures contributing to signal intensity on the UTE MR images. MATERIALS AND METHODS This study was exempted by the institutional review board, and informed consent was not required. Five cadaveric (mean age, 86 years +/- 4) patellae were imaged by using proton density-weighted fat-suppressed (repetition time msec/TE msec, 2300/34), T1-weighted (700/10), and UTE (300/0.008, 6.6, with or without dual-inversion preparations at inversion time 1 = 135 msec and inversion time 2 = 95 msec) sequences. The UTE images were compared with proton density-weighted fat-suppressed and T1-weighted images and were evaluated by two radiologists. To identify the sources of signal on the UTE images, samples including specific combinations of tissues (uncalcified cartilage [UCC] only, calcified cartilage [CC] and subchondral bone [bone] [CC/bone], bone only; and UCC, CC, and bone [UCC/CC/bone]) were prepared and imaged by using the UTE sequence. RESULTS On the UTE MR images, all patellar sections exhibited a high-intensity linear signal near the osteochondral junction, which was not visible on protein density-weighted fat-suppressed or T1-weighted images. In some sections, focal regions of thickened or diminished signal intensity were also found. In the prepared samples, UCC only, CC/bone, and UCC/CC/bone samples exhibited high signal intensity on the UTE images, whereas bone-only samples did not. CONCLUSION These results show that the high signal intensity on UTE images of human articular joints originates from the CC and the deepest layer of the UCC, without a definite contribution from subchondral bone. UTE sequences may provide a way of evaluating abnormalities at or near the osteochondral junction. (c) RSNA, 2010.

In vivo contact kinematics and contact forces of the knee after total knee arthroplasty during dynamic weight-bearing activities

Analysis of polyethylene component wear and implant loosening in total knee arthroplasty (TKA) requires precise knowledge of in vivo articular motion and loading conditions. This study presents a simultaneous in vivo measurement of tibiofemoral articular contact forces and contact kinematics in three TKA patients. These measurements were accomplished via a dual fluoroscopic imaging system and instrumented tibial implants, during dynamic single leg lunge and chair rising-sitting. The measured forces and contact locations were also used to determine mediolateral distribution of axial contact forces. Contact kinematics data showed a medial pivot during flexion of the knee, for all patients in the study. Average axial forces were higher for lunge compared to chair rising-sitting (224% vs. 187% body weight). In this study, we measured peak anteroposterior and mediolateral forces averaging 13.3% BW during lunge and 18.5% BW during chair rising-sitting. Mediolateral distributions of axial contact force were both patient and activity specific. All patients showed equitable medial-lateral loading during lunge but greater loads at the lateral compartment during chair rising-sitting. The results of this study may enable more accurate reproduction of in vivo loads and articular motion patterns in wear simulators and finite element models. This in turn may help advance our understanding of factors limiting longevity of TKA implants, such as aseptic loosening and polyethylene component wear, and enable improved TKA designs.

Knee joint forces: prediction, measurement, and significance

Knee forces are highly significant in osteoarthritis and in the survival and function of knee arthroplasty. A large number of studies have attempted to estimate forces around the knee during various activities. Several approaches have been used to relate knee kinematics and external forces to internal joint contact forces, the most popular being inverse dynamics, forward dynamics, and static body analyses. Knee forces have also been measured in vivo after knee arthroplasty, which serves as valuable validation of computational predictions. This review summarizes the results of published studies that measured knee forces for various activities. The efficacy of various methods to alter knee force distribution, such as gait modification, orthotics, walking aids, and custom treadmills are analyzed. Current gaps in our knowledge are identified and directions for future research in this area are outlined.

Wear of Polyethylene Against Oxidized Zirconium Femoral Components: Effect of Aggressive Kinematic Conditions and Malalignment in Total Knee Arthroplasty

Metallic femoral components with ceramic articulating surfaces can substantially lower polyethylene (PE) wear during walking activities under conditions of normal knee alignment. It is unknown whether these types of components can maintain low wear rates under conditions of knee malalignment and the harsher kinematics associated with younger, athletically active patients. Wear was measured in non-cross-linked, ethylene oxide-sterilized PE inserts against oxidized zirconium or cobalt-chrome femoral components in a knee wear simulator. The vertical load was modified to replicate knee varus malalignment of 3°, and the range of tibial rotation was increased to 20°. Mean gravimetric and volumetric wear rate over 5 million cycles was 55% lower in the oxidized zirconium group. An oxidized zirconium femoral component can significantly reduce PE wear under simulated conditions of athletically active patients with modestly malaligned total knee arthroplasty prostheses.

Comparison of cartilage histopathology assessment systems on human knee joints at all stages of osteoarthritis development.

OBJECTIVE To compare the MANKIN and OARSI cartilage histopathology assessment systems using human articular cartilage from a large number of donors across the adult age spectrum representing all levels of cartilage degradation. DESIGN Human knees (n=125 from 65 donors; age range 23-92) were obtained from tissue banks. All cartilage surfaces were macroscopically graded. Osteochondral slabs representing the entire central regions of both femoral condyles, tibial plateaus, and the patella were processed for histology and Safranin O - Fast Green staining. Slides representing normal, aged, and osteoarthritis (OA) tissue were scanned and electronic images were scored online by five observers. Statistical analysis was performed for inter- and intra-observer variability, reproducibility and reliability. RESULTS The inter-observer variability among five observers for the MANKIN system showed a similar good Intra-class correlation coefficient (ICC>0.81) as for the OARSI system (ICC>0.78). Repeat scoring by three of the five readers showed very good agreement (ICC>0.94). Both systems showed a high reproducibility among four of the five readers as indicated by the Spearmans rho value. For the MANKIN system, the surface represented by lesion depth was the parameter where all readers showed an excellent agreement. Other parameters such as cellularity, Safranin O staining intensity and tidemark had greater inter-reader disagreement. CONCLUSION Both scoring systems were reliable but appeared too complex and time consuming for assessment of lesion severity, the major parameter determined in standardized scoring systems. To rapidly and reproducibly assess severity of cartilage degradation, we propose to develop a simplified system for lesion volume.

Bony Impingement Limits Design-related Increases in Hip Range of Motion

BackgroundFactors affecting risk for impingement and dislocation can be related to the patient, implant design, or surgeon. While these have been studied independently, the impact of each factor relative to the others is not known.Questions/purposesWe determined the effect of three implant design factors, prosthetic placement, and patient anatomy on subject-specific ROM.MethodsWe virtually implanted hip geometry obtained from 16 CT scans using computer models of hip components with differences in head size, neck diameter, and neck-shaft angle. A contact detection model computed ROM before prosthetic or bony impingement. We correlated anatomic measurements from pelvic radiographs with ROM.ResultsWhen we implanted the components for best fit to the subject’s anatomy or in the recommended orientation of 45° abduction and 20° anteversion, ROM was greater than 110° of flexion, 30° of extension, 45° of adduction-abduction, and 40° of external rotation. Changes in head size, neck diameter, and neck-shaft angle generated small gains (3.6°–6°) in ROM when analyzed individually, but collectively, we noted a more substantial increase (10°–17°). Radiographic measurements correlated only moderately with hip flexion and abduction.ConclusionsIt is feasible to tailor implant placement to each patient to maximize bony coverage without compromising ROM. Once bony impingement becomes the restricting factor, further changes in implant design may not improve ROM. Radiographic measurements do not appear to have value in predicting ROM.