David B. Kane

An Electrostatic Lens for Focusing Charged Particles in a Mass Spectrometer

The ability to transmit particles into the ablation region of an aerosol mass spectrometer determines in part the lower size limit for particles that can be analyzed. A large fraction of small particles (< 100 nm) are lost due to processes such as Brownian diffusion that broaden the particle beam. In this work, electrostatic focusing is used to overcome the limits of aerodynamic focusing in the analysis of nanometer-sized particles by aerosol mass spectrometry. A simple tube lens is used to focus charged particles into the ablation laser beam path. The diameter of the focused beam is smaller than the fundamental aerodynamic limit imposed by Brownian motion. Measured enhancements of the hit rate for particles between 21 and 33 nm diameter are between 3 and 6. These values are lower limits for the true enhancements. The lens is also energy selective and can be used to select the mass (size) of the particles being analyzed.

Prototype e-cigarette and the capillary aerosol generator (CAG) comparison and qualification for use in subchronic inhalation exposure testing

ABSTRACT Our objective was to evaluate the suitability of using a capillary aerosol generator (CAG) instead of using e-cigarette devices in 90-day or longer inhalation studies. Aerosol characteristics for both the CAG (which uses heat to produce a condensation aerosol) and e-cigarette generators have been previously reported, but a side-by-side comparison with the identical formulation has not been reported. Aerosols from both devices were analyzed immediately after generation for chemicals in the formulation (propylene glycol [PG], glycerin, water, and nicotine), selected carbonyls (acetaldehyde, acrolein, and formaldehyde) by ultra-performance liquid chromatography with ultraviolet detection (UPLC-UV), and a chemical fingerprint analysis using gas chromatography-mass spectroscopy (GC-MS). Aerosol capture methods for chemical analysis included Cambridge filter pads or two impingers in series each containing solution to trap and stabilize selected carbonyl compounds. Particle size distribution (cascade impactor) and exposure port uniformity (gravimetric) was measured in four rodent inhalation exposure chambers under inhalation study conditions. The aerosol of both generators contained the same known and unknown chemicals. Similar levels of compounds in the formula except for PG were detected in the aerosol of both generators. CAG produced more consistent particulate aerosol than e-cigarette generator and had lower levels of carbonyls primarily due to lower levels of formaldehyde. Exposure port concentrations were consistent and closer to target values with the CAG compared to the e-cigarette aerosol generator. CAG was easier to operate on a daily basis although more difficult to maintain because it required daily cleaning compared to single-use e-cigarettes. CAG was determined to be suitable for use in 90-day or longer inhalation studies. Copyright

Coating ambient particles for enhanced detection by mass spectrometry

Ultraviolet absorbing coatings are used to enhance the detection of aerosol particles by aerosol mass spectrometry (AMS). The coating is accomplished in-line with the aerosol sampling by passing the aerosol through a flow diffusion cloud chamber. It is observed that coating the particles with a 2.5 nm layer of benzoic acid increases the particle hit rate by 2 times when ablated by 266 nm radiation. The coating causes a greater enhancement of the hit rate closer to the ablation threshold, and thicker coatings cause greater increases the hit rate.