David C. Madden

Hydrogenation of N over Fe{111}

Over the past five decades, ultra high vacuum (uhv) techniques applied to well-defined single-crystal samples (the “surface science paradigm”) have transformed our understanding of fundamental surface chemistry. To translate this success to the world of realistic heterogeneous catalysis, however, requires one seriously to address the fact that real heterogeneous catalysts usually operate under near-ambient or higher pressures. Nevertheless, the surface science paradigm can undoubtedly provide crucial insights into catalytic processes, so long as care is exercised in the design of experiments. Forging a secure link between two radically different pressure regimes is the major challenge, which we illustrate here with reference to the vitally important ammonia synthesis reaction, achieved industrially only under extremely high pressure.

Characterizing Surfaces of Garnet and Steel, and Adsorption of Organic Additives

This work reports that abrasive blasting of a structural steel results in significant retention of garnet abrasive residues. A comparative study of the adsorption behavior of a number of organic species, relevant to paint components and additives, onto the surfaces of garnet and S355 steel from nonaqueous solutions is also presented. Areas per adsorbed molecule, estimated from the isotherm data, suggest a range of molecular orientations on the surfaces. Pronounced differences in the adsorption strength to the garnet and steel were observed, particularly that most additives bind more strongly to steel than to garnet. Surface characterization data from acid-base titrations, photoelectron spectroscopy, and backscattered electron diffraction were used to rationalize the adsorption data obtained. The ramifications of these findings for particular industrial processes, with regards the strength of paint adhesion and paint additive formulations, are highlighted.

An X-ray and neutron reflectometry study of iron corrosion in seawater

The corrosive breakdown of thin iron films supported on silicon substrates under a number of conditions is presented-in particular to understand better how iron, and hence ferritic steel, behaves in a salty water environment. A combination of X-ray and neutron reflectometry was used to monitor the structures of both metal and oxide surface layers and also organic corrosion inhibitors adsorbed at the iron/aqueous interface. A range of behavior in seawater was observed, including complete dissolution and void formation under the metal surface. Importantly, two simple treatments-UV/ozone or soaking in ultrapure water-were found to significantly protect the iron surface for considerable lengths of time, although evidence of pitting corrosion began after around 10 days. The underlying causes of the efficacies of these treatments were further investigated using X-ray photoelectron spectroscopy. In addition, three potential corrosion inhibitors were investigated: (i) dodecyltrimethylammonium bromide (DTAB) demonstrated no ability to protect the surface; (ii) sodium dodecyl sulfate (SDS) appeared to accelerate corrosion; and (iii) bis(2-ethylhexyl)phosphate showed an impressive level of protection (the neutron reflectometry results indicated a thick diffuse layer of surfactant of 23% surface coverage). These findings have been interpreted in terms of preferential inhibitor adsorption at cathodic and anodic surface sites (depending on the nature of the inhibitor).