David L. Moore

Comparison of two-surface and multiple-surface scoring methodologies for in vitro microleakage studies.

Investigators differ on the use of a two-surface or multiple-surface scoring methodology in sectional microleakage studies. This study compared microleakage scores using both two-surface and multiple-surface scoring methods for two preparation types and two different dentin bonding agents. Twenty freshly extracted molars each received one box-shaped and one V-shaped restoration on the mesial or distal surface. Each restoration was cut occlusogingivally into four sections, yielding eight surfaces for scoring. Surfaces were marked to identify central (I), lateral (II), and end (III) locations, then scored by two calibrated raters. The Wilcoxon Matched-Pairs Signed-Rank Test showed a statistically significant difference (p less than or equal to 0.05) in median microleakage scores obtained by an end two- surface and multiple-surface evaluation for V-shaped preparations restored with Scotchbond 2, P-50. No other statistically significant comparisons were detected. Results suggest that microleakage may be more extreme at end surfaces and that these end surfaces should be scored so that an accurate microleakage value could be assigned to composite restorations.

Marginal penetration of composite resin restorations as indicated by a tracer dye.

There was no evidence of marginal penetration of a tracer dye around Class V preparations lined with a BIS-GMA sealant, filled with Nuva-fil (a composite restorative material), and covered with the sealant. In the control group, 72 per cent of the Adaptic restorations showed varying degrees of marginal penetration.

Use of preformed hydroxylapatite blocks for grafting in genioplasty procedures

Dense hydroxylapatite is a synthetic, biocompatible, immunologically inert material that can establish a chemical union with bone when placed in intimate contact in histologic studies. The following is a preliminary report of the use of preformed dense, non-resorbable hydroxylapatite blocks as a grafting material for use in advancement and vertical lengthening of the bony chin associated with orthognathic surgical procedures. In rare instances where an autogenous bone graft would be required for vertical lengthening without any advancement of bony pogonion, the need is obviated by utilization of the hydroxylapatite solid block.

The effects of rinse volumes and air and water pressures on enamel-composite resin bond strength

To assess the effect of different rinse volumes and air and water pressures on shear enamel-composite resin bond strength, the buccal surfaces of 384 maxillary molars were prepared through 600-grit silicon carbide, gel-etched, and rinsed with one of 24 randomly assigned test conditions: 0, 2, 5, 10, 15, or 25 ml volume wash with air and water syringe pressures of 20/10, 20/40, 40/10, or 40/40 psi. The rinsed enamel was dried, Scotchbond adhesive was applied, and a polysiloxane ring was secured to the flattened surface. Silux resin was incrementally added to a depth of 2 mm and each increment cured 40 seconds. Shear bond strengths were determined by using an Instron testing machine at a crosshead speed of 0.5 mm/min. A statistically significant (p less than 0.05) volume effect was found only between the 0 volume rinse groups and each other volume group. No statistically significant differences (p less than 0.05) were seen between air or water pressure groups. Mean bond strengths for greater than or equal to 2 ml rinsing ranged from 250 +/- 30 to 280 +/- 50 kg/cm2. Enamel-composite resin bond strengths were not significantly increased beyond 2 ml rinsing regardless of air and water syringe pressure used.