David Pastor

Sub-bandgap spectral photo-response analysis of Ti supersaturated Si

We have analyzed the increase of the sheet conductance (ΔG□) under spectral illumination in high dose Ti implanted Si samples subsequently processed by pulsed-laser melting. Samples with Ti concentration clearly above the insulator-metal transition limit show a remarkably high ΔG□, even higher than that measured in a silicon reference sample. This increase in the ΔG□ magnitude is contrary to the classic understanding of recombination centers action and supports the lifetime recovery predicted for concentrations of deep levels above the insulator-metal transition.

Far infrared photoconductivity in a silicon based material: Vanadium supersaturated silicon

We have analyzed the spectral sub-bandgap photoresponse of silicon (Si) samples implanted with vanadium (V) at different doses and subsequently processed by pulsed-laser melting. Samples with V concentration clearly above the insulator-metal transition limit show an important increase of the photoresponse with respect to a Si reference sample. Their photoresponse extends into the far infrared region and presents a sharp photoconductivity edge that moves towards lower photon energies as the temperature decreases. The increase of the value of the photoresponse is contrary to the classic understanding of recombination centers action and supports the predictions of the insulator-metal transition theory.

Room-temperature operation of a titanium supersaturated silicon-based infrared photodetector

We report room-temperature operation of 1 × 1 cm2 infrared photoconductive photodetectors based on silicon supersaturated with titanium. We have fabricated these Si-based infrared photodetectors devices by means of ion implantation followed by a pulsed laser melting process. A high sub-band gap responsivity of 34 mV W−1 has been obtained operating at the useful telecommunication applications wavelength of 1.55 μm (0.8 eV). The sub-band gap responsivity shows a cut-off frequency as high as 1.9 kHz. These Si-based devices exhibit a non-previous reported specific detectivity of 1.7 × 104 cm Hz1/2 W−1 at 660 Hz, under a 1.55 μm wavelength light. This work shows the potential of Ti supersaturated Si as a fully CMOS-compatible material for the infrared photodetection technology.

Simultaneous high crystallinity and sub-bandgap optical absorptance in hyperdoped black silicon using nanosecond laser annealing

Hyperdoped black silicon fabricated with femtosecond laser irradiation has attracted interest for applications in infrared photodetectors and intermediate band photovoltaics due to its sub-bandgap optical absorptance and light-trapping surface. However, hyperdoped black silicon typically has an amorphous and polyphasic polycrystalline surface that can interfere with carrier transport, electrical rectification, and intermediate band formation. Past studies have used thermal annealing to obtain high crystallinity in hyperdoped black silicon, but thermal annealing causes a deactivation of the sub-bandgap optical absorptance. In this study, nanosecond laser annealing is used to obtain high crystallinity and remove pressure-induced phases in hyperdoped black silicon while maintaining high sub-bandgap optical absorptance and a light-trapping surface morphology. Furthermore, it is shown that nanosecond laser annealing reactivates the sub-bandgap optical absorptance of hyperdoped black silicon after deactivation ...

Interstitial Ti for intermediate band formation in Ti-supersaturated silicon

We have analyzed by means of Rutherford backscattering spectrometry (RBS) the Ti lattice location and the degree of crystalline lattice recovery in heavily Ti implanted silicon layers subsequently pulsed laser melted (PLM). Theoretical studies have predicted that Ti should occupy interstitial sites in silicon for a metallic-intermediate band (IB) formation. The analysis of Ti lattice location after PLM processes is a crucial point to evaluate the IB formation that can be clarifyied by means of RBS measurements. After PLM, time-of-flight secondary ion mass spectrometry measurements show that the Ti concentration in the layers is well above the theoretical limit for IB formation. RBS measurements have shown a significant improvement of the lattice quality at the highest PLM energy density studied. The RBS channeling spectra reveals clearly that after PLM processes Ti impurities are mostly occupying interstitial lattice sites.

Ruling out the impact of defects on the below band gap photoconductivity of Ti supersaturated Si

In this study, we present a structural and optoelectronic characterization of high dose Ti implanted Si subsequently pulsed-laser melted (Ti supersaturated Si). Time-of-flight secondary ion mass spectrometry analysis reveals that the theoretical Mott limit has been surpassed after the laser process and transmission electron microscopy images show a good lattice reconstruction. Optical characterization shows strong sub-band gap absorption related to the high Ti concentration. Photoconductivity measurements show that Ti supersaturated Si presents spectral response orders of magnitude higher than unimplanted Si at energies below the band gap. We conclude that the observed below band gap photoconductivity cannot be attributed to structural defects produced by the fabrication processes and suggest that both absorption coefficient of the new material and lifetime of photoexcited carriers have been enhanced due to the presence of a high Ti concentration. This remarkable result proves that Ti supersaturated Si is a promising material for both infrared detectors and high efficiency photovoltaic devices.

Synthesis of Ge1−xSnx alloys by ion implantation and pulsed laser melting: Towards a group IV direct bandgap material

Synthesis of Ge1−xSnx alloys by ion implantation and pulsed laser melting: Towards a group IV direct bandgap material

Room temperature photo-response of titanium supersaturated silicon at energies over the bandgap

Silicon samples were implanted with high Ti doses and subsequently processed with the pulsed-laser melting technique. The electronic transport properties in the 15–300 K range and the room temperature spectral photoresponse at energies over the bandgap were measured. Samples with Ti concentration below the insulator-metal (I-M) transition limit showed a progressive reduction of the carrier lifetime in the implanted layer as Ti dose is increased. However, when the Ti concentration exceeded this limit, an extraordinary recovery of the photoresponse was measured. This result supports the theory of intermediate band materials and is of utmost relevance for photovoltaic cells and Si-based detectors.

Meyer Neldel rule application to silicon supersaturated with transition metals

This paper presents the results for the transverse conductance across a bilayer formed by supersaturating with diverse transition metals a thin layer of a silicon wafer. The layer is formed by ion implantation and annealed by pulsed laser melting. The transverse conductance is exponentially activated, obtaining values ranging from 0.018 to 0.7 eV for the activation energy and pre-exponential factors of 10^-2-10^12 S depending on the annealing energy density. A semi-logarithmic plot of the pre-exponential factor versus activation energy shows an almost perfect linear behavior as stated by the Meyer Neldel rule. The Meyer Neldel energy obtained for implantation with different transition metals and also annealed in different conditions is 22meV, which is within the range of silicon phonons, thus confirming the hypothesis of the Multi Excitation Entropy theory.

Suppression of ion-implantation induced porosity in germanium by a silicon dioxide capping layer

Ion implantation with high ion fluences is indispensable for successful use of germanium (Ge) in the next generation of electronic and photonic devices. However, Ge readily becomes porous after a moderate fluence implant ( ∼1×1015 ion cm−2) at room temperature, and for heavy ion species such as tin (Sn), holding the target at liquid nitrogen (LN2) temperature suppresses porosity formation only up to a fluence of 2×1016 ion cm−2. We show, using stylus profilometry and electron microscopy, that a nanometer scale capping layer of silicon dioxide significantly suppresses the development of the porous structure in Ge during a Sn− implant at a fluence of 4.5×1016 ion cm−2 at LN2 temperature. The significant loss of the implanted species through sputtering is also suppressed. The effectiveness of the capping layer in preventing porosity, as well as suppressing sputter removal of Ge, permits the attainment of an implanted Sn concentration in Ge of ∼15 at.%, which is about 2.5 times the maximum value previously at...