Desheng Jiang

Photovoltage and photoreflectance spectroscopy of InAs/GaAs self-organized quantum dots

We present a detailed study of the interband excitonic transitions of InAs/GaAs self-organized quantum dots (QDs) based on photovoltage (PV) photoreflectance (PR) and photoluminescence (PL) spectroscopy. At room temperature, the interband absorption transitions of QDs have been observed by using PV spectrum, which clearly exhibits four well-resolved excitonic absorption peaks. The absorption line shape is Gaussian-like. Furthermore, the corresponding excitonic transitions are also observed in PR experiment at 77 K. The first derivative of a Gaussian profile can fit the experimental data well

Influence of dislocations on photoluminescence of InGaN∕GaN multiple quantum wells

The influence of dislocations on photoluminescence (PL) of InGaN/GaN multiple quantum wells (MQWs) is investigated by triple-axis x-ray diffraction (TAXRD), transmission electron microscopy (TEM), and PL spectra. The omega scan of every satellite peak by TAXRD is adopted to evaluate the mean screw and edge dislocation densities in MQWs. The results show that dislocations can lead to a reduction of the PL-integrated intensity of InGaN/GaN MQWs under certain conditions, with edge dislocations playing a decisive role. Additionally, the dislocations can broaden the PL peak, but the effect becomes evident only under the condition when the interface roughness is relatively low

Confinement factor and absorption loss of AlInGaN based laser diodes emitting from ultraviolet to green

Confinement factor and absorption loss of AlInGaN based multiquantum well laser diodes (LDs) were investigated by numerical simulation based on a two-dimensional waveguide model. The simulation results indicate that an increased ridge height of the waveguide structure can enhance the lateral optical confinement and reduce the threshold current. For 405 nm violet LDs, the effects of p-AlGaN cladding layer composition and thickness on confinement factor and absorption loss were analyzed. The experimental results are in good agreement with the simulation analysis. Compared to violet LD, the confinement factors of 450 nm blue LD and 530 nm green LD were much lower. Using InGaN as waveguide layers that has higher refractive index than GaN will effectively enhance the optical confinement for blue and green LDs. The LDs based on nonpolar substrate allow for thick well layers and will increase the confinement factor several times. Furthermore, the confinement factor is less sensitive to alloys composition of waveguide and cladding layers, being an advantage especially important for ultraviolet and green LDs.

Suppression of thermal degradation of InGaN/GaN quantum wells in green laser diode structures during the epitaxial growth

Local InGaN quantum well (QW) decomposition and resultant inhomogeneous luminescence in green laser diode (LD) epitaxial structures are investigated using micro-photoluminescence, Z-contrast scanning transmission electron microscopy, and high-resolution transmission electron microscopy. The local InGaN QW decomposition is found to happen during p-type layer growth due to too high thermal budget and may initiate at the InGaN/GaN QW upper interface probably due to the formation of In-rich InGaN clusters there. Reducing thermal budget and optimizing InGaN/GaN QW growth suppress the local InGaN QW decomposition, and green LD structures with homogeneous luminescence and bright electroluminescence (EL) intensity are obtained.

Investigations on V-defects in quaternary AlInGaN epilayers

The characteristics of V-defects in quaternary AlInGaN epilayers and their correlation with fluctuations of the In distribution are investigated. The geometric size of the V-defects is found to depend on the In composition of the alloy. The V-defects are nucleated within the AlInGaN layer and associated with threading dislocations. Line scan cathodoluminescence (CL) shows a redshift of the emission peak and an increase of the half width of the CL spectra as the electron beam approaches the apex of the V-defect. The total redshift decreases with decreasing In mole fraction in the alloy samples. Although the strain reduction may partially contribute to the CL redshift, indium segregation is suggested to be responsible for the V-defect formation and has a main influence on the respective optical properties

The fabrication of GaN-based nanopillar light-emitting diodes

InGaN/GaN multiple quantum well-based light-emitting diode (LED) nanopillar arrays were fabricated using Ni self-assembled nanodots as etching mask. The Ni nanodots were fabricated with a density of 6 x 10(8)-1.5 x 10(9) cm(-2) and a dimension of 100-250 nm with varying Ni thickness and annealing duration time. Then LED nanopillar arrays with diameter of approximately 250 nm and height of 700 nm were fabricated by inductively coupled plasma etching. In comparison to the as-grown LED sample an enhancement by a factor of four of photoluminescence (PL) intensity is achieved for the nanopillars and a blueshift as well as a decrease in full width at half maximum of the PL peak are also observed. The method of additional chemical etching was used to remove the etching-induced damage. Then nano-LED devices were further completed using a planarization approach to deposit p-type electrode on the tips of nanopillars. The current-voltage curves of both nanopillars and planar LED devices are measured for comparison.

Tuning and Identification of Interband Transitions in Monolayer and Bilayer Molybdenum Disulfide Using Hydrostatic Pressure

Few-layer molybdenum disulfide (MoS2) is advantageous for application in next-generation electronic and optoelectronic devices. For monolayer MoS2, it has been established that both the conduction band minimum (CBM) and the valence band maximum (VBM) occur at the K point in the Brillouin zone. For bilayer MoS2, it is known that the VBM occurs at the Γ point. However, whether the K valley or the Λ valley forms the CBM and the energy difference between them remain disputable. Theoretical calculations have not provided a conclusive answer. In this paper, we demonstrate that a direct K-K to an indirect Λ-K interband transition in bilayer MoS2 can be optically detected by tuning the hydrostatic pressure. A changeover of the CBM from the K valley to the Λ valley is observed to occur under a pressure of approximately 1.5 GPa. The experimental results clearly indicate that the K valley forms the CBM under zero strain, while the Λ valley is approximately 89 ± 9 meV higher in energy.

Influence of the AlN interlayer crystal quality on the strain evolution of GaN layer grown on Si (111)

The strain evolution in metal organic chemical vapor deposition growth of GaN on Si (111) substrate with an AlN interlayer is studied. During the growth of GaN film on AlN interlayer, the growth stress changes from compression to tension. The study shows that the density of V trenches in the AlN interlayer surface and the threading dislocations generated in the AlN interlayer have a significant influence on this strain evolution process. The dislocations generated in AlN interlayer may thread across the interface and play a key role in the strain evolution process of the GaN layer grown on AlN interlayer.

Preliminary studies on the source of PM10 aerosol particles in the atmosphere of Shanghai City by analyzing single aerosol particles

To identify the origin of PM10 (particulate matter with aerodynamic diameter equal to or less than 10 mum) in the atmosphere of Shanghai City, single PM10 particles from two environmental monitor locations and six pollution emitter sources were measured by scanning nuclear microprobe techniques. Every PM10 particle is characterized by its,micro-PIXE spectrum. The strategy of micro-PIXE spectra combined with the pattern recognition technique is applied to identify original sources of measured PM10 particles. The results of this investigation show that the most of the measured PM10 particles are derived from building construction sites, cement factories, vehicle exhaust, coal boilers and steel mills

High-performance strain-compensated InGaAs/InAlAs quantum cascade lasers

We report on the realization of quantum cascade (QC) lasers based on strain-compensated InxGa(1-x)As/In(y)A((1-y))As grown on InP substrates using molecular beam epitaxy. X-ray diffraction and cross section transmission electron microscopy have been used to ascertain the quality of the QC laser materials. Quasi-continuous wave lasing at lambda approximate to 3.54-3.7 mum at room temperature was achieved. For a laser with 1.6 mm cavity length and 20 mum ridge-waveguide width,quasi-continuous wave lasing at 34 degreesC persists for more than 30 min, with a maximum power of 11.4 mW and threshold current density of 1.2 kA cm(-2), both record values for QC lasers of comparable wavelength.