Dmitriy Feoktistov

Evaporation of liquid droplets from a surface of anodized aluminum

The results of study of evaporation of water droplets and NaCl salt solution from a solid substrate made of anodized aluminum are presented in this paper. The experiment provides the parameters describing the droplet profile: contact spot diameter, contact angle, and droplet height. The specific rate of evaporation was calculated from the experimental data. The water droplets or brine droplets with concentration up to 9.1 % demonstrate evaporation with the pinning mode for the contact line. When the salt concentration in the brine is taken up to 16.7 %, the droplet spreading mode was observed. Two stages of droplet evaporation are distinguished as a function of phase transition rate.

Regimes of water droplet evaporation on copper substrates

Distilled water droplet evaporation has been studied on copper substrate surfaces with different degrees of roughness. Data on variations in the contact diameter have been employed to distinguish between the regimes of distilled water droplet spreading over the copper surfaces that proceed after the viscous regime. For each isolated regime, the duration has been determined as a fraction of the total evaporation time and the main physical processes have been described. Variations in contact angles have been analyzed as depending on copper surface temperature. It has been established that, as the substrate temperature is elevated, wetting becomes better, while the adhesion work remains almost unchanged, thereby indicating the absence of chemical and structural transformations at the liquid–substrate interface.